00-17
Nuts, bolts
Always replace self-locking nuts and bolts.
Loosen nuts or bolts, opposite to tightening
sequence.
Tighten and loosen bolts and nuts for securing
covers and housings in a diagonal sequence.
Especially delicate parts, such as clutch
pressure plates, must not be canted. Loosen
and tighten bolts and nuts in stages in a
diagonal sequence.
The tightening torques stated apply to non-oiled
nuts and bolts.
The threads of bolts which are secured by a
locking compound should be cleaned using a
wire brush. Then apply AMV 185 101 A1 when
installing.
CAUTION!
Part numbers are listed here for reference
only. Always check with your Parts
department for the latest information.
Pa
ge 6 of 14 General re
pair instructions
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.00.5
00-21
Synchronizer rings
Do not interchange.
When re-using, install synchronizer rings with
the same gear with which they were previously
matched.
Check for signs of wear; replace if necessary.
Lubricate with gear oil before installing.
Clutch mechanism
When removing transmission, remove clutch
slave cylinder without opening hydraulic lines.
CAUTION!
Do not depress the clutch pedal after
removing the slave cylinder. Otherwise the
piston will be pressed out of the slave
cylinder.
Do not cant clutch pressure plate, loosen and
tighten in a diagonal sequence and in stages.
To reduce odor caused by a burnt clutch,
thoroughly clean the bellhousing, flywheel and
Pa
ge 13 of 14 General re
pair instructions
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.00.5
