CLUTCH
Mechanism - Disc
REFITTING
Clean the splines of the clutch shaft and refit the
assembly without lubricant.
Fit the disc (with the offset on the hub on the
gearbox side).
Centre using the tool supplied in the kit.
20
REMOVAL
Fit the locking sector tool Mot. 582 or
Mot. 582-01.
Remove the mounting bolts from the mechanism
and remove the friction plate.
Check and replace any faulty parts.
99055R
SPECIAL TOOLING REQUIRED
Mot. 582
or Locking tool
Mot. 582-01
Mechanism mounting bolt 2
TIGHTENING TORQUES (in daN.m)
REPLACEMENT (after removal of the gearbox)
95414S
Tighten progressively in a star pattern, then tigh-
tenthe mounting bolts to the correct torque.
Remove the locking sector tool Mot. 582 or
Mot. 582-01.
Coat with
MOLYKOTE BR2 grease:
- the guide tube,
- the fork pads.
20-2
