WIRING
Remote control for door locking
88
Remove the receiver and its printed circuit by se-
parating tabs (F) (example: infrared receiver).
13075R
Special notes for refitting
When refitting the mounting (D), check that the
switch (E) is positioned towards the right (see dia-
gram) to avoid damaging the contacts on reclip-
ping the assembly.
13074R2
13072R
- the two courtesy light console mounting bolts
(B).
Release the assembly forwards and disconnect the
connector.
After removing the bulb, remove bolt (C) and un-
clip mounting (D).
13074R1
88-7
WIRING
Airbags and seat belt pretensioners
88
When refitting the computer, it MUST be moun-
ted on the vehicle before its connectors are re-
connected.
The arrow on the computer must point towards
the front of the vehicle.
Vehicle fitted with airbag(s)
Lock the computer using the XR25 and command
G80* (ISO selector on S8 code D49).
When this function is active, all the trigger lines
are inhibited, the airbag warning light on the ins-
trument panel and bargraph 14 LH on the XR25 il-
luminate (new computers are supplied in this
condition).
When refitting the computer:
- Mount it on the vehicle (the arrow on the
computer must point towards the front of the
vehicle).
- Connect the 30 track computer connector and
carry out a check using the XR25.
If everything is correct, unlock the computer using
command G81*.COMPUTER
Several types of unit may be found:
- one computer for pretensioners only.
- one computer for pretensioners and airbag(s).
Depending on function, these computers have:
- an electromagnetic safety sensor,
- a decelerometer for the airbags
- an ignition circuit for the different pyrote-
chnic systems,
- a power reserve,
- a diagnostic and detected fault storage circuit
(except pretensioner only),
- a control circuit for the warning light on the
instrument panel (except pretensioner only),
- a K - L communication interface via the dia-
gnostic socket (except pretensioner only).
IMPORTANT
Before removing the computer:
Vehicle with pretensioners only (no air-bag) :
- Switch off the ignition.
- Remove the feed fuse (see fuse allocation) and
wait for 5 minutes for the reserve capacity to
discharge.
- Disconnect the computer connector to avoid
any risk of triggering.
- Ensure no-one is in the passenger compartment
during the complete operation on the compu-
ter.
88-14
WIRING
Airbags and seat belt pretensioners
88
LOCATION OF THE COMPUTER
It is located on the tunnel in the central console.
13059S
COMPUTER WITHOUT AIRBAG
98715S
COMPUTER WITH AIRBAG(S)
98716S
IMPORTANT:
• The computer must be replaced after the pre-
tensioners and airbags have been triggered.
Certain components will lose their nominal cha-
racteristics after the trigger energy has passed
through them.
• When replacing an airbag(s) computer, the
computer must be unlocked using the XR25 be-
fore it is used (see "Fault finding" section " : in-
terpretation of bargraph 14 LH side).
IMPORTANT :When refitting the computer, it
MUST be mounted on the vehicle before its
connectors are reconnected. The arrow on the
computer must point towards the front of the
vehicle (tightening torque : 0.4 daN.m).
NOTE: The 30 track connector for the computer
short circuits the various trigger lines as soon as it
is disconnected. Shunts located opposite each pre-
tensioner line or airbag line prevent the incorrect
triggering of these systems (by aerial effect for
example).
88-15
