INSTRUMENT PANEL
Instrument panel
83
Connector N (black)
Track Allocation
1 Not used
2 Brake pad wear warning light
3 ABS warning light
4Handbrake / brake info warning light
(NIVOCODE)
5 Immobiliser warning light
6 Not used
7 Not used
8 Speed signal
9 Oil level sensor
10 Oil level sensor earth
Connector G (grey)
Track Allocation
1 Earth
2 Not used
3 Not used
4 Low fuel level warning light
5 Coolant temperature warning light
6 Oil pressure warning light
7 Battery charge warning light
8 Rear fog light tell-tale
9 Front fog lights tell-tale
10 Right hand indicator tell-tale
83-9
Mot. 1264
Mot. 1264-01
Mot. 1265
Mot. 1265-01Wrench for removing sender unit nut
Pliers for removing quick-release unions
INSTRUMENT PANEL
Fuel level sensor
83
97163R6
Disconnect the battery.
Lift the rear bench seat (depending on
equipment).
Remove the pump and sender unit steel cover.
Disconnect the electrical connector (1).
Release the clips (2).
Then disconnect the fuel supply pipe (3) (green
marking on the quick-release union) and the fuel
return pipe (4) (red marking on the quick-release
union) using the special pliers Mot. 1265 or Mot.
1265-01.
IMPORTANT: When the pipes are removed, fuel
may be splashed out due to the residual pressure
in the pipes. Take appropriate precautions.
IMPORTANT :
During any operation on the fuel level sensor
you must observe the following precautions:
- Do not smoke.
- Keep all flames or incandescent objects away
from the working area.
REMOVAL OF THE PUMP - SENDER ASSEMBLY
The pump and sender unit assembly may be
removed through the inspection cover under the
rear bench seat and the fuel tank does not have to
be removed.
96420R2
SPECIAL TOOLING REQUIRED
TIGHTENING TORQUES (in daN.m)
Sender unit nut 7
83-10
