1997 LINCOLN TOWN CAR belt

153
5. Insert the belt tongue into the proper buckle
for that seating position until you hear a snap
and feel it latch. Make sure the tongue is
securely latched to the buckle by pulling on the
tongue. See Figure 3.
File:06fnsst.ex
Update:Fri Jun 21 08:57:53 1996

154
6. Push down on the child seat and pull up on
the shoulder belt portion to tighten the lap belt
portion of the combination lap and shoulder
belt. See Figure 4.
File:06fnsst.ex
Update:Fri Jun 21 08:57:53 1996

155
7. Grasp belt close to child seat and pull on the
shoulder belt portion of the combination
lap/shoulder belt, then allow the belt to retract
and remove all slack to securely tighten the
child safety seat in the vehicle. See Figure 5.
File:06fnsst.ex
Update:Fri Jun 21 08:57:53 1996

158
9. Chec kfro m tim eto tim eto be sur etha tthere
WARNING
If safet ybelt sar e no tproperl yworn

159
WARNING
Do no tus ea belt-positionin gbooster
WARNING
Childre nshoul dalway srid ewit hthe

209
Towing Your VehicleIf you need to have your vehicle towed, contact a
professional towing service or, if you are a member,
your roadside assistance center. Typical towing
options include wheel lift towing or flat bed towing.
Front towing
Before your vehicle can be towed, the air
suspension switch in the luggage compartment
needs to be turned to the OFF position. It is
recommended that your Town Car be towed with
wheel lift or flatbed equipment. If slingbelt
equipment must be used, the towbar will deform
the soft fascia (bumper). However, it will return to
an acceptable shape.
File:10fnert.ex
Update:Thu Jun 20 15:16:36 1996

254Cleaning Plastic PartsSome of your vehicle's exterior trim parts are
plastic. Clean with a tar and road oil remover if
necessary. Use a vinyl cleaner for routine cleaning.
Do not clean plastic parts with thinners, solvents or
petroleum-based cleaners.
If you have your vehicle rustproofed, remove
oversprayed rustproofing with a tar and road oil
remover. If rustproofing is not removed from plastic
and rubber parts, it can cause deterioration.Cleaning the Safety BeltsClean the safety belts with any mild soap solution
that is recommended for cleaning upholstery or
carpets. Do not bleach or dye the belt webbing
because this may weaken it.
Cleaning the Instrument Panel LensClean the instrument panel lens and woodtone trim
with a soft cloth and a glass cleaner. Do not use
paper towel or any abrasive cleaner to clean either
the lens or the woodtone trim as these may cause
scratches.Cleaning the Exterior LampsDo not use dry paper towel, chemical solvents or
abrasive cleaners to clean the lamps, as these may
cause scratches or crack the lamps.Cleaning the Interior LampsYour interior dome lamps and map lamps are plastic
and should be cleaned with a mild detergent
diluted in water. Rinse them with clear water.
File:11fnmct.ex
Update:Mon Jun 17 13:54:56 1996

298Charging system warning light...... 15
Childproof locks............ 96
Child safety restraints.......... 140
child safety belts........... 158
child safety seats........... 141
Child safety seats
and air bags............. 141
attaching with tether straps...... 158
automatic locking mode
(retractor)........130, 141, 143
in front seat..........141, 143
in rear outboard seat......141, 151
in rear seat............. 141
tether anchorage hardware...... 158
Chime
headlamps on............ 32
key in ignition............ 75
safety belt.............. 13
Circuit breakers, checking and replacing . . 191Cleaning your vehicle
chrome and aluminum parts...... 253
exterior............... 253
exterior lamps............ 254
fabric................ 255
headlamps.............. 254
instrument panel........... 254
interior............... 255
interior lamps............ 254
mirrors............... 90
plastic parts............. 254
polishing.............. 253
rustproofing............. 254
safety belts............. 254
tail lamps.............. 254
upholstery and interior trim...... 255
washing............... 253
waxing............... 253
wheels............... 255
File:fnixt.ex
Update:Mon Jun 17 13:58:01 1996