Page 168 of 315
163
WARNING
If safet ybelt sar e no tproperl yworn
Page 169 of 315
164
To improv eth efi tof la pan dshoulde rbeltWARNING
Do no tus ea belt-positionin gbooster
Childre nshoul dalway srid ewit hthe
Page 219 of 315
214DO NOT TOW WITH SLINGBELT EQUIPMENT.
Ford Motor Company has not developed or
approved a T-hook sling-type procedure. Use wheel
lift or flatbed equipment. When towing your Mark
VIII with wheel lift equipment, be sure dollies are
in place under the trailing wheels if the air
suspension is deflated to prevent damage to the air
deflector.
Rear towing
When calling for a tow truck, tell the operator what
kind of vehicle you have. A towing manual is
available from Ford Motor Company for all
authorized tow truck operators. Have your tow
truck driver refer to this manual for the proper
hook-up and towing procedures for your vehicle.
File:10fner8.ex
Update:Thu Jun 20 14:27:22 1996
Page 236 of 315

231
concentration in your vehicle is such that the
coolant will not freeze at the temperature level in
which you drive during winter months. Never
increase the engine coolant concentration above
60%. Leave a 50/50 mixture of engine coolant and
water in your vehicle year-round in non-extreme
climates.
Proper procedures for a complete coolant drain and
flush of the cooling system can be found in theCar
Service Manual.Following these recommended
procedures will ensure that the specified coolant
level and a 50/50 or appropriate mixture of coolant
and water is maintained.Engine Coolant Refill ProcedureWhen the entire cooling system is drained and
refilled, the following procedure should be used to
ensure a complete fill:
NOTE:It is imperative the following procedure be
adhered to. Failure to do so could result in damage
to your engine.
q
Remove coolant reservoir pressure cap.
q
Remove the engine coolant outlet tube fill plug
on the engine.
q
With the engine off and cool, add a 50/50
mixture of recommended cooling system fluid
and water to the coolant outlet tube fill neck
until the reservoir is full.
NOTE:DO NOT FILL COOLANT SYSTEM
THROUGH COOLANT RESERVOIR. COOLANT
WILL NOT ENTER ENGINE, WHICH CAN LEAD
TO ENGINE DAMAGE.
NOTE:Avoid spilling coolant on the front end
accessory drive belt, as this will allow the belt to
slip and become noisy.
q
Reinstall the pressure cap to the coolant
reservoir.
q
Continue filling at the engine coolant tube fill
neck slowly while allowing air to escape.
File:11fnmc8.ex
Update:Thu Jun 20 14:28:32 1996
Page 266 of 315

261
Cleaning Plastic PartsSome of your vehicle's exterior trim parts are
plastic. Clean with a tar and road oil remover if
necessary. Use a vinyl cleaner for routine cleaning.
Do not clean plastic parts with thinners, solvents or
petroleum-based cleaners.
If you have your vehicle rustproofed, remove
oversprayed rustproofing with a tar and road oil
remover. If rustproofing is not removed from plastic
and rubber parts, it can cause deterioration.
Cleaning the Safety BeltsClean the safety belts with any mild soap solution
that is recommended for cleaning upholstery or
carpets. Do not bleach or dye the belt webbing
because this may weaken it.
Clean the instrument panel lens and woodtone trim
with a soft cloth and a glass cleaner. Do not use
paper towel or any abrasive cleaner to clean either
the lens or the woodtone trim as these may cause
scratches.Cleaning the Exterior LampsDo not use dry paper towel, chemical solvents or
abrasive cleaners to clean the lamps, as these may
cause scratches or crack the lamps.
File:11fnmc8.ex
Update:Thu Jun 20 14:28:32 1996
Page 299 of 315

298Chains, tires.............. 242
Changing a tire............ 201
Charging system warning light...... 13
Child safety restraints.......... 150
child safety belts........... 163
child safety seats........... 151
Child safety seats............ 151
and air bags............. 151
attaching with tether straps...... 162
automatic locking mode (retractor) 143, 151
in front seat............. 151
in rear outboard seat......... 151
in rear seat............. 151
tether anchorage hardware . . . 162, 163
Chime
headlamps on............ 15
key in ignition............ 84
safety belt.............. 44Cleaning your vehicle.......... 260
chrome and aluminum parts...... 260
exterior............... 260
exterior lamps............ 261
fabric................ 262
headlamps.............. 261
instrument panel......... 7,261
interior............... 262
interior lamps............ 262
mirrors............... 100
plastic parts............. 261
polishing.............. 260
rustproofing............. 261
safety belts............. 261
tail lamps.............. 261
upholstery and interior trim...... 262
washing............... 260
waxing............... 260
wheels............... 262
File:fnix8.ex
Update:Thu Jun 27 10:02:38 1996
Page 300 of 315

299
Climate control system
air conditioning........... 69
electronic automatic temperature
control.............. 69
heating............... 69
Clock................. 82
Clutch
fluid reservoir............ 225
specifications............ 265
Combination lap and shoulder belts.... 138
Console, description.......... 115
Controls, mirrors............ 99
Convenience kit in cargo area...... 202
Coolant (see Engine coolant)....... 228
checking and adding......... 228
preparing for storage......... 267
refill capacities............ 264specifications............ 265
temperature gauge.......... 17
warnings.............. 228
Cooling fan.............. 217
Crankcase emission filter........ 263
Cruise control indicator light....... 13
Customer Assistance Centre,
Ford of Canada............ 276
D
Daytime running light system...... 78
Defects, reporting............ 269
Dipstick................ 223
automatic transmission fluid...... 234
engine oil.............. 223
power steering fluid......... 233
Disabled vehicle (see Towing)...... 213
Dispute Settlement Board........ 272
Doors................. 106
lubricant specifications........ 265
File:fnix8.ex
Update:Thu Jun 27 10:02:38 1996
Page 306 of 315

305
K
Keyless entry system
locking and unlocking doors...... 119
programming entry code....... 120
Keys
key in ignition chime......... 84
positions of the ignition........ 83
removing from the ignition...... 84
stuck in lock position......... 83
L
Lamps
autolamp delay system........ 80
checking.............. 253
daytime running light system..... 78
dome lamps............. 96
flashing the lamps.......... 86
hazard flashers............ 89
headlamps............. 79
high beams............. 86
interior lamps............ 78map lamps............. 96
replacing bulbs............ 253
trailer............... 187
Lane change indicator (see Turn signal) . . 85
Lap belts............... 143
Lights, warning and indicator
airbag............... 45
anti-lock brakes (ABS)......... 11
brake................ 10
charging system........... 13
check engine............ 45
engine oil pressure.......... 11
hazard warning light......... 89
high beam............. 14
overdrive off............. 46
safety belt.............. 44
turn signal indicator......... 14
File:fnix8.ex
Update:Thu Jun 27 10:02:38 1996