Page 1 of 21
AIR CONDITIONING AND AUDIO
11 0
Lower vent
The lower vent may be opened or closed as shown.
Rear vents
The rear vents may be opened or closed as shown.
AUDIO SYSTEM
Car audio operating tips
NOTICE
To prevent the battery from being discharged, do
not leave the car audio on longer than necessary
when the engine is not running.
To ensure the correct audio system operation:
Be careful not to spill beverages over the audio
system.
Do not put anything other than a cassette tape or
CD magazine into the cassette tape slot or CD
changer.
You can listen to the car audio when the ignition key is
at ªONº or ªACC.º However, if the engine is not running,
the key must be in the ªACCº position.
Audio operation is described in detail on the following pages:
Radio operation ± See page 111.
Cassette tape player operation ± See page 115.
Compact disc player operation ± See page 119.
Anti±theft system ± See page 125.
Page 4 of 21

AIR CONDITIONING AND AUDIO
11 3 Push the
(SCAN) button for longer than 2 seconds.
With ªSCANº on the display, the radio will automatically seek
out a station of higher frequency, hold it for 5 seconds and
scan to the next. To continue listening to the broadcast of
your choice, simply push the
(SCAN) button once
again.
Manual tuning: Push the
(TUNE) button briefly. Each
time you push the button, the radio will step up or down to
another frequency.
(c) Presetting a station
1. Tune in the desired station. (See ª(b) Selecting a
station.º)
2. Push one of the station selector buttons and hold it until
a beep is heard. This sets the station to the button and the
button number will appear on the display.
Each button can store one AM station and two FM stations.
To change the preset station to a different one, follow the
same procedure.
The preset station will be cancelled when the power source
is cut off (battery disconnected, blown fuse, etc.).
(d) Adjusting the tone
To adjust the low±pitched tone, push the ªBASSº knob (if
depressed) and turn it.
To adjust the middle±pitched tone, push the ªMIDº knob (if
depressed) and turn it.
To adjust the high±pitched tone, push the ªTREBLEº knob (if
depressed) and turn it.(e) Adjusting the sounds balance
To balance the sound between the right and left speakers,
push the ªBALANCEº knob (if depressed) and turn it.
To balance the sound between the front and rear speakers,
push the ªFADERº knob (if depressed) and turn it.
Radio operating tips
The antenna automatically extends when the radio and
ignition are turned on and retracts when either is turned off.
CAUTION!
Before extending the antenna, confirm that no one
is close enough to get injured.
NOTICE
To prevent damage to the antenna, make sure it is
retracted before running your vehicle through an
automatic car wash.
Page 18 of 21

AIR CONDITIONING AND AUDIO
127
Once the system is set, the indicator light turns on and off
with the ignition switch in ªOFFº and ªSECº will appear each
time the key is turned to the ªACCº position.
To change the identification number for some reason, cancel
the system (See ª(b) Cancelling the anti±theft system.º) and
set it again with a new number.
The system will be activated if the electrical power source is
disconnected from the radio unit. When the system is
activated, the audio system cannot be turned on even after
the power supply resumes and ªSECº will appear on the
display. If this happens, such as when the battery is
discharged, see ª(c) If the anti±theft system is activated.º(b) Cancelling the anti±theft system
1. Follow steps 1 to 4 described in ª(a) Setting the
anti±theft system.º
2. With your identification number appearing on the
display, press the
(SCAN) button and hold it in until
ª±±±º appears on the display. ª±±±º will go off to indicate the
system is cancelled. If invalid buttons have been used, ªErrº
will appear on the display and ªSECº appears. Try again
from step 3 in ª(a) Setting the anti±theft system.º
The number displayed with ªErrº indicates how many errors
you have made. You may make up to nine errors, but no
more!