ENGINE
196
SPECIFICATIONS
±GENERAL
Model 1MZ±FE
Type 6 cylinder V type, 4 cycle, gasoline
Bore and stroke 87.5 X 83 mm (3.44 X 3.27 in.)
Displacement 2995 cm
3
(182.7 cu.in.)
Valve clearance (engine cold)
Intake 0.15 ± 0.25 mm (0.006 ± 0.010 in.)
Exhaust 0.25 ± 0.35 mm (0.010 ± 0.014 in.)
Drive belt tension (with Borroughs drive belt tension 115 + 20 lb.
gauge No. BT±33±73F)
±LUBRICATION SYSTEM
Oil capacity
Drain and refill
with filter 4.7 L (5.0 qt., 4.2 Imp.qt.)
without filter 4.5 L (4.8 qt., 4.0 Imp.qt.)
Oil grade API SH, Energy±Conserving II multigrade engine oil or
ILSAC multigrade engine oil
Recommended oil viscosity (SAE):
ENGINE
203
Engine oil selection
Use API SH, Energy±Conserving II multigrade engine oil or
ILSAC multigrade engine oil.
Recommended viscosity (SAE):
SAE 5W±30 is the best choice for your vehicle, for good
fuel economy, and good starting in cold weather.
If you use SAE 10W±30 engine oil in extremely low
temperatures, the engine may become difficult to start,
so SAE 5W±30 engine oil is recommended.
Oil identification marks
API Service SymbolILSAC Certification Mark
Either or both API registered marks are added to some oil
containers to help you select the oil you should use.
The API Service Symbol is located anywhere on the
outside of the container.
The top portion of the label shows the oil quality by API
(American Petroleum Institute) designation such as SH.
The center portion of the label shows the SAE viscosity
grade such as SAE 5W±30. ªEnergy±Conserving II,º
shown in the lower portion, indicates that the oil has fuel±
saving capabilities. Oils marked ªEnergy±Conserving IIº
will have higher fuel±saving capabilities than oils marked
ªEnergy±Conserving.º
The ILSAC (International Lubricant Standardization and
Approval Committee) Certification Mark is displayed on the
front of the container.
