1997 GMC JIMMY tow

Turn and Lane Change Signals
The turn signal has twio upward (for right) and two
downward (for left) positions. These positions allow
you
to signal a turn or LI lane change.
To signal a tum, move the lever all the way up or down.
When the turn is finished. the lever will return automatically.\

An arrow on the instrument
panel will flash
in the
direction
of the turn
or lane change.
To signal a lane change, just raise or lower the lever
unt.il the arrow starts to flash. Hold it there until you
complete
your lane change. The lever will return by
itself when
you release it.
As you signal a turn or a lane change, if the arrows don't
flash but just stay
on, a signal bulb may be burned out
and other drivers won't see your turn signal.
If a bulb is burned out, replace it to help ac.oid an
accident.
If the arrows don't go on at all when you
signal
a turn, check the fuse (see "Fuses and Circuit
Breakers"
in the Index) and for burned-out bulbs.
If you have a trailer towing option with added wiring for
the trailer lamps.
a different turn signal flasher is used.
With this flasher installed, the signal indicator will flash
even
if ;I turn signal bulb is burned out. Check the front
and rear turn signal
lamps regularly to make sure they
are working.
Headlamp HighLow Beam Changer
To change the headlamps from low-beam to high or
high
to low. pull the multifunction lever all the way
toward you. Then release
it.
2-39

Press the tab under the mirror to reduce glare from
headlamps behind
you.
Outside Manual Adjust Mirror
Adjust your outside mirrors so you can just see the side
of your vehicle.
You can fold them before entering a car wash. Pull the
mirrors in toward the vehicle. Push the mirrors back out
when finished.
Power Remote Control Mirror
The control is located on the
driver’s door armrest.
Turn
the control to L or R to
choose the mirror, then
press the arrows on the
outside switch ring to adjust
the mirror.
2-49

Brake System Warning Light
Your vehicle’s hydraulic brake system is divided into
two parts.
If one part isn’t working, the other part can
still work and stop you. For good braking, though, you
need both parts working well.
If the warning light comes on, there could be
a brake
problem. Have your brake system inspected right away.
I
This light should come on
briefly when you turn the
ignition key to RUN. If it
doesn’t come on then, BRAKE
(a) (@)
:;;::::$d;:n1::: if
have it fixed so it will be
If the light comes on while you are driving, pull off the
road and stop carefully. You may notice that the pedal is
harder to push. Or, the pedal may go closer to
the floor.
It may take longer to stop. If the light is still on, have the
vehicle towed for service. (See “Towing Your Vehicle“
in the Index.)
Your brake system may not be working properly
if the brake system warning light is on. Driving
with the brake system warning light on can lead
to an accident. If the light is still on after you’ve
pulled
off the road and stopped carefully, have
the vehicle towed for service.
When the ignition is on, the brake system warning light
will
also come on when you set your parking brake. The
light will stay on
if your parking brake doesn’t release
fully. If it stays on after your parking brake is fully
released,
it means you have a brake problem.
2-75

If the Light Is Flashing
The following may prevent more serious damage to
your vehicle:
Reducing vehicle speed.
Avoiding hard accelerations.
Avoiding steep uphill grades.
If you are towing a trailer. reduce the anlount of
cargo being hauled as soon as it is possible.
If the light stops flashing and remains
on steady. see “If
the Light Is On Steady” following.
If the light continues t.o flash, when it is safe to do so.
stop the \?el?ic&~. Find a safe place to park your vehiclc.
Turn the key off,
wait at least 10 seconds and restart the
engine.
If the light remains on steady, see “If the Light
Is On Steady” following. If the light is still flashing,
follow the previous steps, and drive the vehicle to your
dealer or qualified service center for service.
If the Light Is On Steady
You may be able to correct the emission system
malfunction by considering the following:
Did
you recently put fuel into your vehicle?
If so, reinstall the fuel cap, making s111-e to fully install
the cap. The diagnostic system can cleter~nine
if the fuel cap
has been left off
or improperly installed. A loose or
missing fuel cap
will allow fuel to evaporate into the
atmosphere.
A few driving trips with the cap properly
installed should turn
the light off,
Did you *just drive through a deep puddle of water’!
If so, your electrical system may be wet. The condition
will usually be corrected when the electrical system
dries out.
A few driving trips should turn the light off.
Have you recently changed brands of fuel?
I1 so, be sure to fuel your vehicle with cpality fuel (see
“Fuel”
in the Index). Poor fuel quality will cause your
engine not to
r11n as e,fficiently as designed. You may
notice this
as stalling after start-up, stalling when you put
the vehicle
into gear, mistlring, hesitation on acceleration
or
stumbling on acceleration. (These conditions may go
away once the engine is warmed up.) This will be detected
by the system and cause the light
to turn on.
If you experience one or more of these conditions,
change the fuel brand you use.
It will require at least one
full tank of the proper fuel to turn the light off.
If none of the above steps have made the light. turn off.
have your dealer or qualified service center check the
vehicle. Your dealer has the proper test equipment and
diagnostic
tools to fix any mechanical or electrical
problcnls that may have developed.

Defogging and Defrosting
On cool. humid days. use BLEND to keep the
windshield and side windows clear.
Use
DEFROST to remove fog or ice from the
windshield quickly
in extreme humid or cold conditions.
Turn the temperature knob clockwise and
move the fhn
control toward HI.
Rear Window Defogger (Option)
window of as much snow or ice as possible before using
the rear window defogger.
To turn on the rear window defogger, find the switch
marked REAR
DEFOG on your instrument panel below
the headlamp switch. Press ON until the light in the
switch comes
on, then release it. It will only work if the
ignition switch is turned to RUN.
The rear window defozger will stay
on for five to seven
minutes. then turn off.
If you need additional warming
time, turn
it on again. You can turn the defogger off at
any time by pressing OFF.
Do not attach a temporary vehicle license, tape or decals
across the defogger grid on the rear window.
NOTICE:
Don’t use a razor blade or something else sharp
on the inside
of the rear window. If you do, you
could cut or damage the warming grid, and the
repairs wouldn’t be covered
by your warranty.
3-5

Section 4 Your Driving and the Road
Here you’ll find information about driving on different kinds\
of roads and in varying weather conditions. We’ve also
included many other useful tips
on driving.
4-2
4-3 4-6
4-6 4-9
4-11
4-12 4-13
4-14
4-28 4-29
4-32 4-3 3 Defensive Driving
Drunken Driving Control
of a Vehicle
Braking
Steering
Off-Road Recovery
Passing
Loss of Control
Driving Guidelines
Driving at Night
Driving in Rain and on Wet Roads
City Driving
Freeway Driving Before Leaving on a Long Trip
Highway Hypnosis
Hill and Mountain Roads
Winter Driving Recreational Vehicle Towing
(Four-wheel Drive with the
Manual Shift Transfer Case Only)
Recreational Vehicle Towing (Except
Four-wheel Drive with the Manual Shift
Transfer Case)
Loading Your Vehicle
Towing a Trailer
4-34
4-35
4-35
4-37 4-4
1
4-42
4-42 4-45
4-1

Recreational Vehicle Towing (Four-wheel Drive With
7
Shift Transfer Case Only)
1.
2.
3.
3.
Set the par' * lg brake firmly.
Place an automatic transmission
in PARK (P) or a
manual transmission in FIRST ( I ).
Firmly attach the vehicle being towed to the tow
vehicle.
Do not tow the vehicle by the rear bumper
bar. Refer
to the hitch manufacturer's instructions.
Place the manual shift transfer case shift lever
in
NEUTRAL (N).
A CAUTION:
Shifting the transfer case into NEUTRAL (N) can
cause your vehicle to roll even if the transmission
is
in PARK (P), for an automatic transmission, or
if your vehicle is in gear, for a manual
transmission. You
or others could be injured.
Make sure the parking brake
is firmly set before
you shift the transfer case into
NEUTRAL (N).
5. Release the parking brake only after the vehicle
being towed is firmly attached
to the tow vehicle.
6. Insert the ignition key into the ignition switch and
turn
it one notch forward of the LOCK position. This
places the key
in the OFF position, which unlocks
the steering column while preventing battery drain.
Unlocking the steering column will allow
for proper
movement
of the front wheelshires during towing.
4-41

Recreational Vehicle Towing (Except Four-wheel Drive With
Manual Shift Transfer Case) Loading Your Vehicle
Vehicles with
two-wheel drive or the optional electronic
shift transfer case require special modifications before
they can be towed
in this manner. Please contact your
dealer for the towing information that
is appropriate for
your particular vehicle.
Vehicles
with all-wheel drive (AWD) can not be towed
in this manner.
The Certification/Tire label is found on the driver’s door
edge, above the door latch. The label shows the size
of
your original tires and the inflation pressures needed to
obtain the gross weight capacity of your vehicle. This is
called the GVWR (Gross Vehicle Weight Rating). The
GVWR includes the weight
of the vehicle, all occupants,
fuel, cargo and trailer tongue weight,
if pulling a trailer.
4-42