1997 FORD PROBE brake

194
*
[MC08700(ALL)01/96]
RWARNING
Brake fluid is toxic.
*
[MC08800(ALL)01/96]
If brake fluid contacts eyes, flush eyes with
running water for 15 minutes. Get medical
attention if irritation persists. If taken internally,
drink water and induce vomiting. Get medical
attention immediately.
[MC08900(ALL)01/96]
one third page art:0032042-A
Brake fluid level
[MC09000(ALL)01/96]
If the fluid is low, carefully clean and remove
the cap from the reservoir. Fill the reservoir to
the MAX line with Ford High Performance DOT
3 Brake Fluid C6AZ-19542-AA or DOT 3
equivalent fluid meeting Ford specification
ESA-M6C25-A.
*
[MC09100(ALL)01/96]
RWARNING
If you use a brake fluid that is not DOT
3, you will cause permanent damage to
your brakes.
*
[MC09200(ALL)01/96]
Do not fill the reservoir above the MAX line.
*
[MC09300(ALL)01/96]
If you find that the fluid level is excessively low
Ð below the seam or ridge on the outside of the
plastic reservoir Ð have the brake system
inspected.
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

195
*
[MC09400(ALL)01/96]
RWARNING
Do not let the reservoir for the master
cylinder run dry. This may cause the
brakes to fail.
%
*
[MC09700(ALL)02/96]
Windshield Washer Fluid
%*
[MC09750(ALL)03/96]
Washer Fluid
[MC09800(ALL)01/96]
Check the level of the windshield washer fluid
every time you stop for fuel. The reservoir for
the windshield washer fluid is located in the
engine compartment. Visual inspection can
determine if the washer fluid is adequate. Do
not operate the washer when the reservoir is
empty.
[MC09900(ALL)01/96]
half page art:0032082-A
Windshield washer fluid reservoir
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

201
%*
[MC18100(ALL)01/96]
Automatic Transaxle Fluid
*
[MC18200(ALL)02/96]
Under normal circumstances, you do not need to
check the fluid level of the transaxle, since your
vehicle does not use up transaxle fluid. Refer to
theMaintenance Schedulebooklet for replacement
intervals. However, if the transaxle is not
working properly Ð for instance, the transaxle
may slip or shift slowly, or you may notice
some sign of fluid leakage Ð the fluid level
should be checked.
[MC18300(ALL)01/96]
If you must check the transaxle fluid in an
emergency, make sure that your vehicle is on
level ground, start the engine, and move the
gearshift through all of the gears allowing
sufficient time for each position to engage.
Securely latch the gearshift in P (Park). Set the
parking brake and leave the engine running.
[MC18400(ALL)01/96]
Wipe off the dipstick cap, pull the dipstick out
and wipe the indicator end clean. Put the
dipstick back into the filler tube. Make sure the
dipstick is fully seated in the filler tube;
otherwise, you will not get an accurate reading.
Pull the dipstick out and read the fluid level.
[MC18500(ALL)01/96]
The fluid level must be above the lower mark. If
it is not, you should not drive your vehicle until
more fluid is added. Ideally, the fluid level
should be within the specified area of the
dipstick.
[MC18600(ALL)01/96]
NOTE: The fluid level indication on the
dipstick will be different at operating
temperature and room temperature. For
the correct fluid level reading on the
dipstick, follow the appropriate
instructions.
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

204
*
[MC19700(ALL)01/96]
If you see any corrosion on the battery cables or
terminals, remove the cables from the terminal
and clean them both with a wire brush. You can
neutralize the acid with a solution of baking
soda and water. Reinstall the cables when you
are done cleaning them, and apply a small
quantity of grease to the top of each battery
terminal to help prevent corrosion.
*
[MC19800(ALL)01/96]
Battery replacement
[MC19900(ALL)01/96]
When the original equipment maintenance-free
battery is replaced under warranty, it may be
replaced by a low-maintenance battery.
[MC19950(ALL)01/96]
The low-maintenance battery has removable vent
caps for checking the electrolyte level and
adding water, if necessary.
[MC20000(ALL)01/96]
The electrolyte level should be checked at least
every 24 months or 24,000 miles (40,000 km) in
temperatures up to90ÊF (32ÊC) andmore in
temperatures above90ÊF (32ÊC).Keep the
electrolyte level in each cell up to the level
indicator. Do not overfill.
[MC20100(ALL)01/96]
If the level gets low, you can add plain tap
water to the battery, provided the water isn't
hard or doesn't have a high mineral or alkali
content. However, if possible, refill with distilled
water. If the battery needs water quite often,
have the charging system checked for a possible
problem.
[MC20200(ALL)01/96]
If you ever disconnect the battery or install a
new battery, you must allow the computer to
ªrelearnº its idle condition before your vehicle
will drive properly. To begin this process, put
the gearshift in P (Park) (automatic transaxle) or
N (Neutral) (manual transaxle), set the
emergency brake, turn off all the accessories, and
start the vehicle. Bring the engine to normal
operating temperature.
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

221
*
[MC35300(ALL)01/96]
To calculate fuel economy:
*
[MC35400(ALL)01/96]
1. Fill the tank completely and record the
initial odometer reading.
*
[MC35500(ALL)01/96]
2. Every time you buy fuel record the
amount (in gallons or liters) purchased.
*
[MC35600(ALL)01/96]
3. After at least three to five tankfuls, fill the
fuel tank and record the final odometer
reading.
*
[MC35700(ALL)01/96]
4. Use these equations to calculate your fuel
economy:
*
[MC35800(ALL)01/96]
q
English: MPG = (total miles driven)v
(gallons used)
*
[MC35900(ALL)01/96]
q
Metric: L/100k = (liters used)v
(100 kilometers)
*
[MC36000(ALL)01/96]
Comparisons With EPA Estimates
*
[MC36100(ALL)05/96]
EPA fuel economy figures are obtained from
laboratory tests under simulated road conditions
and may not reflect the actual conditions you
experience or your style of driving. The EPA
fuel economy estimate is not a guarantee that
you will achieve the fuel economy shown.
*
[MC36200(ALL)01/96]
The following decrease fuel economy:
*
[MC36300(ALL)01/96]
q
Lack of regular, scheduled maintenance
*
[MC36400(ALL)01/96]
q
Rapid acceleration and excessive speed
*
[MC36500(ALL)01/96]
q
Driving with your foot on the brake
*
[MC36550(ALL)01/96]
q
Sudden stops
*
[MC36600(ALL)01/96]
q
Extended engine idling
*
[MC36660(ALL)01/96]
q
Using speed control in hilly terrain
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

225
*
[MC39910(ALL)03/96]
The driving modes required to reach the ready
condition consist of a minimum of 30 minutes of
city and highway driving as described below.
*
[MC39920(ALL)03/96]
q
20 minutes of driving in stop and go
city-type traffic with at least four idle periods.
*
[MC39930(ALL)03/96]
q
10 minutes of driving on an expressway or
highway
*
[MC39940(ALL)05/96]
Before completing the above driving modes, the
engine must be warmed up and at operating
temperature. Once started, the vehicle must not
be turned off during the above driving modes. If
the vehicle owner is unable to meet the I/M
requirements by using these driving patterns, an
authorized service center can perform a detailed
OBD II drive cycle as it would any other type of
repair work.
%
*
[MC42000(ALL)03/96]
Lights and Bulb Replacement
*
[MC42100(ALL)01/96]
It is a good idea to check the operation of the
following lights frequently:
*
[MC42200(ALL)01/96]
q
headlamps
*
[MC42400(ALL)01/96]
q
tail lamps
*
[MC42500(ALL)01/96]
q
brakelamps
*
[MC42600(ALL)01/96]
q
hazard flasher
*
[MC42700(ALL)01/96]
q
turn signals
*
[MC42800(ALL)01/96]
q
side markers
*
[MC42900(ALL)05/96]
q
license plate lamps
[MC43000(ALL)01/96]
q
fog lamps (GT model)
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

226 %
*
[MC43100(ALL)01/96]
The alignment of your headlamps should be
checked if:
*
[MC43200(ALL)01/96]
q
oncoming motorists frequently signal you to
turn off your vehicle's high beams when you
do not have the high beams on
*
[MC43300(ALL)01/96]
q
the headlamps do not seem to give you
enough light to see clearly at night
*
[MC43400(ALL)01/96]
q
the headlamp beams are pointed substantially
away from a position slightly down and to
the right
%*
[MC43500(ALL)01/96]
Headlamp Bulb
[MC43600(ALL)01/96]
Your vehicle has retractable halogen headlamps.
If you need to replace a headlamp, have it done
by a Ford service technician.
% [MC43700(ALL)04/96]
High-Mount Brakelamp Bulb
[MC43800(ALL)01/96]
To replace the bulb:
[MC43900(ALL)01/96]
1. Remove the two side trim liftgate panels.
[MC44000(ALL)01/96]
2. Remove the liftgate trim clip and the liftgate
trim.
[MC44100(ALL)01/96]
3. Remove the bulb from the socket by pushing
it in and turning it counterclockwise.
[MC44200(ALL)01/96]
4. Install the bulb by pushing straight into the
lamp socket and turning it clockwise until it
locks in place.
[MC44300(ALL)01/96]
5. Replace the liftgate trim and trim clip.
[MC44400(ALL)01/96]
6. Replace the two side trim liftgate panels.
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

227 [MC44500(ALL)01/96]
one third page art:0032061-B
High-mount brakelamp
% [MC46000(ALL)01/96]
Rear Lamp Bulbs
[MC46100(ALL)01/96]
To replace a bulb:
[MC46200(ALL)01/96]
1. Remove the attaching screw and the rear
lens cover.
[MC46300(ALL)01/96]
one third page art:0032120-A
Removing the attaching screw and lens
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996