1997 FORD PROBE ignition

31
*
[AS08700(ALL)10/95]
Using the ªSCANº function
[AS08800(ALL)05/94]
Press the ªSCAN/TUNEº button to enter the
scan mode. Once in the scan mode, press the top
(
b) or bottom (
a) half of the ªSEEKº button to
scan forward or reverse, respectively. The CD
player will begin scanning the disc, stopping on
each listenable track for approximately an
eight-second sampling. This continues until you
press the ªSCAN/TUNEº button a second time.
*
[AS09500(ALL)04/96]
How to eject the disc
*
[AS09600(ALL)10/95]
Push the ªEJECTº button to stop play, eject the
disc and resume radio operation of your audio
system.
*
[AS09700(ALL)10/95]
NOTE: You can eject the disc while the radio
power and/or ignition is on or off.
%*
[AS09710(ALL)08/95]
How To Take Care of and Clean Your CD
Player and Discs
*
[AS09720(ALL)08/95]
To ensure the continued performance of your
Ford Compact Disc Player, carefully read the
following precautions:
*
[AS09730(ALL)04/96]
q
Always handle the disc by its edge. Never
touch the playing surface.
*
[AS09740(ALL)08/95]
q
Before playing, inspect the disc for any
contamination. If needed, clean the disc with
an approved disc cleaner, such as the
DiscwasherHCompact Disc Cleaner or the
Allsop 3HCompact Disc Cleaner, by wiping
from the center out to the edges.Do not use
a circular motion to clean.
*
[AS09750(ALL)04/96]
q
Do not clean discs with solvents such as
benzine, thinner, commercially available
cleaners or antistatic spray intended for
analog records.
File:04prasp.ex
Update:Mon Jun 3 10:03:33 1996

36
*
[AS21400(ALL)03/96]
Using the Controls on Your New Radio
*
[AS21500(ALL)08/95]
How to turn the radio on and adjust the
volume
*
[AS21701(ALL)10/95]
Press the ªPOWERº button to turn the radio on.
Press it again to turn it off.
*
[AS21950(ALL)02/96]
Press the right (+) side of the ªVOLUMEº
button to increase the volume. Press the left (S)
side of the button to decrease the volume.
Illuminated bars in the display show the relative
volume level.
*
[AS21975(ALL)02/96]
NOTE: If the volume level is set above a
certain listening level when the
ignition switch is turned off, when the
ignition switch is turned back on, the
volume will come back to a ªnominalº
listening level. However, if the radio
power is turned off, the volume will
remain in the position it was set at
when radio power was switched off.
*
[AS22100(ALL)03/96]
Selecting the AM or FM frequency band
*
[AS22225(ALL)02/96]
Push the ªAM/FMº button to select the desired
frequency band. Pushing the button more than
once will alternate between AM, FM1 and FM2.
These functions are used with the station
memory buttons described underHow to tune
radio stations.
*
[AS22300(ALL)02/96]
How to tune radio stations (Stereo Radio)
*
[AS22400(ALL)02/96]
There are three ways for you to tune in to a
particular station. You can manually locate the
station by using the ªTUNEº button, ªSEEKº the
station or select the station by using the memory
preset buttons, which you can set to any desired
frequency.
File:04prasp.ex
Update:Mon Jun 3 10:03:33 1996

40
*
[AS24800(ALL)04/96]
q
Adjusting speaker fader
*
[AS24925(ALL)02/96]
Fade control allows you to adjust the sound
distribution between the front and rear
speakers. Push the ªAUDIOº button
repeatedly until the display reads ªFADE.º
Push the right (+) side of the ªVOLUMEº
button to shift the sound to the front
speakers, and push the left (S) side to shift
the sound to the rear speakers.
*
[AS24950(ALL)09/95]
NOTE: Illuminated bars in the display show
relative levels of bass and treble and
positions of speaker balance and fader
functions after adjustments are made,
then revert to volume level set.
*
[AS25000(ALL)04/96]
Using the Controls of Your Cassette Tape
Player (If equipped)
*
[AS25500(ALL)08/95]
How to insert a tape
*
[AS25600(ALL)08/95]
Insert a cassette (with the open edge to the
right) firmly into the tape door opening, making
sure the cassette is completely in and ªseated.º
[AS25650(ALL)07/93]
NOTE: A cassette tape can be loaded with the
ignition on whether or not the radio
power is on. Inserting a cassette tape
with the radio power off will turn the
audio system on. After the cassette is
ejected, radio play will return.
*
[AS25700(ALL)12/95]
How to locate a desired track on the tape
*
[AS25800(ALL)06/95]
NOTE: The tape track or side number
indicated in the display does not
necessarily correspond to the tape track
or side number on the cassette label. It
is used only to indicate when the tape
mechanism reverses tracks.
File:04prasp.ex
Update:Mon Jun 3 10:03:33 1996

61
*
[CF15100(ALL)01/96]
Ignition
%*
[CF15200(ALL)01/96]
Understanding the Positions of the Ignition
[CF15300(ALL)01/96]
one third page art:0032054-A
Ignition lock cylinder
*
[CF15400(ALL)01/96]
LOCK locks the steering wheel. It also locks the
gearshift lever in P (Park) (automatic transaxle).
*
[CF15500(ALL)01/96]
LOCK is the only position that allows you to
remove the key. The LOCK feature helps to
protect your vehicle from theft.
[CF15600(ALL)01/96]
To remove the key if you have a manual
transaxle, push the key in while turning it to the
LOCK position.
*
[CF15700(ALL)01/96]
If your key is stuck in the LOCK position and
will not turn, move your steering wheel left or
right until the key turns freely.
[CF15800(ALL)01/96]
ACC (Accessory) allows some of your vehicle's
electrical accessories to operate while the engine
is not running.
*
[CF15900(ALL)01/96]
ON allows you to test your vehicle's warning
lights (except the brake system warning light) to
make sure they work before you start the
engine. The key returns to the ON position once
the engine is started and remains in this position
while the engine runs.
File:05prcfp.ex
Update:Tue Jun 11 11:03:33 1996

68
%*
[CF19100(ALL)01/96]
Windshield Wipers and Washer
*
[CF19200(ALL)01/96]
To operate the windshield wipers and washers,
make sure your ignition key is turned to the ON
position.
[CF19300(ALL)01/96]
The windshield wipers have two speeds. To
operate the wipers, pull down the lever on the
right side of your steering column. The first
position is LO (Low) and the second position is
HI (High). To turn the wipers off, return the
lever to the uppermost position.
[CF19400(ALL)01/96]
quarter page art:0032071-C
Windshield wiper control
[CF19500(ALL)01/96]
ONE-TOUCH WIPER CONTROL (If equipped)
Ð For one wiping cycle, push the lever away
from you and release it with the lever in the
OFF or interval position. The ignition switch
must be in the ON position for this operation.
[CF19600(ALL)01/96]
quarter page art:0032058-B
One touch wiper control
File:05prcfp.ex
Update:Tue Jun 11 11:03:33 1996

72
%*
[CF21300(ALL)03/96]
Speed Control (If equipped)
[CF21600(ALL)01/96]
half page art:0032031-C
Speed control switches on the steering wheel
%*
[CF21610(ALL)05/96]
To Turn Speed Control Off
[CF21612(ALL)05/96]
Press OFF, or
[CF21614(ALL)05/96]
Turn off the vehicle ignition.
*
[CF21616(ALL)05/96]
Once speed control is switched off, the
previously programmed set speed will be erased.
*
[CF21620(ALL)05/96]
To Turn Speed Control On
[CF21640(ALL)05/96]
Press ON
*
[CF21740(ALL)05/96]
To Set a Speed
[CF21760(ALL)05/96]
Press SET ACC. For speed control to operate,
the speed control must be ON and the vehicle
speed must be greater than 30 mph (48 km/h).
*
[CF21780(ALL)05/96]
If you drive up or down a steep hill, your
vehicle speed may vary slower or faster than the
set speed. This is normal.
File:05prcfp.ex
Update:Tue Jun 11 11:03:33 1996

74
*
[CF22020(ALL)05/96]
To Disengage Speed Control
[CF22040(ALL)05/96]
Depress the brake pedal, or
[CF22060(ALL)05/96]
Depress the clutch pedal (if equipped).
*
[CF22080(ALL)05/96]
Disengaging the speed control will not erase the
previously programmed set speed.
*
[CF22100(ALL)05/96]
To Return to a Set Speed
[CF22120(ALL)05/96]
Press RSM. For RSM to operate, the vehicle
speed must be faster than 30 mph (48 km/h).
%
*
[CF25200(ALL)01/96]
Moon Roof (If equipped)
[CF25300(ALL)01/96]
The control switch for the sliding moon roof is
on the interior/map lamp control panel located
above the windshield and between the sun
visors. The ignition must be in the ON position
for the moon roof to be operational.
[CF25400(ALL)01/96]
To open the sliding moon roof to the vent
position, push the recessed part of the moon
roof switch until the back of the moon roof tilts
into the vent position. You must release the
switch after opening the vent before pressing it
again to slide the moon roof open. To close,
push the other side of the switch until the moon
roof sets back into place.
File:05prcfp.ex
Update:Tue Jun 11 11:03:33 1996

77 [CF26700(ALL)01/96]
half page art:0030079-C
Power locks on the driver's door
%*
[CF27000(ALL)04/96]
Windows
%*
[CF27400(ALL)01/96]
Using the Power Windows (If equipped)
[CF27450(ALL)01/96]
Each door has a power control that opens and
closes the window on that door. The driver's
door has a master control panel that operates
both windows.
[CF27500(ALL)01/96]
To use your power windows, your ignition
switch must be placed in the ON position. Press
the recessed end of the power window switch to
lower a window, press the raised end of the
switch to raise a window.
% [CF27550(ALL)01/96]
NOTE: Your vehicle is equipped with a ªone
touch downº feature. This feature
allows the driver to fully open the
driver's window by firmly pressing the
switch and then releasing. The switch
will release when the window has
fully opened.
File:05prcfp.ex
Update:Tue Jun 11 11:03:33 1996