1997 FORD F250 brake

9
%*
[II06000(FM)01/96]
Breaking Your Vehicle In
*
[II06100(FM)01/96]
Your new vehicle goes through an adjustment or
break-in period during the first 1,000 miles
(1,600 km) that you drive it. During the break-in
period, you need to pay careful attention to how
you drive your vehicle.
%*
[II06300(FM)01/96]
q
Avoid sudden stops.Because your vehicle
has new brake linings, you should take these
steps:
*
[II06400(FM)01/96]
Ð Watch traffic carefully so that you can
anticipate when to stop.
*
[II06500(FM)01/96]
Ð Begin braking well in advance.
*
[II06600(FM)01/96]
Ð Apply the brakes gradually.
*
[II06700(FM)01/96]
The break-in period for new brake linings
lasts for 100 miles (160 km) of city driving or
1,000 miles (1,600 km) of highway driving.
*
[II06750(FM)03/96]
q
Wheel lug nuts must be retightened to proper
torque specifications at 500 miles/800 km of
new vehicle operation. Proper torque
specifications are provided in this guide. Also
retighten to proper torque specifications at
500 miles/800 km after any wheel change or
any other time the wheel lug nuts have been
loosened.
%*
[II06800(F )03/96]
q
Use only the type of engine oil that Ford
recommends.SeeEngine oil recommendations
in the Index. Do not use special ªbreak-inº
oils.
File:02ltiif.ex
Update:Tue May 28 08:39:40 1996
ProCarManuals.com

15
%*
[IS01700(FM)01/96]
The Mechanical Cluster
*
[IS01800(FM)01/96]
The following warning lights and gauges are on
the mechanical cluster. All of the warning lights
and gauges alert you to possible problems with
your vehicle. Some of the lights listed are
optional. The following sections detail what each
of these indicators means.
%*
[IS02600(FM)01/96]
Brake System Warning Light
[IS02800(F )04/96]
The warning light for the brakes can show three
things Ð that either the parking brake is not
fully released, that the brake fluid level is low in
the master cylinder reservoir or the vacuum
pressure is low on diesel engine vehicles. If the
fluid level is low, the brake system should be
checked by a qualified service technician.
*
[IS02900(FM)03/96]
This light illuminates when you turn the ignition
key to START to verify that the indicator bulb is
working. If the light stays on or illuminates after
you have released the parking brake fully, have
the hydraulic brake system serviced.
*
[IS03000(FM)03/96]
RWARNING
The BRAKE light indicates that the brakes
may not be working properly. Have the
brakes checked immediately.
[IS03100(FM)04/96]
one inch art:0020044-A
Brake warning light
File:03ltisf.ex
Update:Tue May 28 08:40:24 1996
ProCarManuals.com

16 %
*
[IS03200(F )03/96]
Anti-Lock Brake System Warning Light
*
[IS03300(F )04/96]
To check the ABS brake warning light turn the
ignition key to ON. The ABS brake warning
light should glow momentarily.
*
[IS03400(F )03/96]
NOTE: If it does not glow momentarily, have
your vehicle's electrical system checked
immediately.
[IS03500(F )04/96]
NOTE: If the ABS brake warning light begins
to flash in a repeatable flash sequence,
check the rear anti-lock system
continuous power fuse and brake lights
for proper operation.
[IS03600(F )04/96]
one inch art:0020913-B
Antilock warning light
*
[IS03700(F )03/96]
RWARNING
If the anti-lock brake system warning
light remains on or comes on while
driving, have the braking system checked
by a qualified service technician as soon
as possible.
*
[IS03800(F )03/96]
NOTE: If a fault occurs in the anti-lock
system, and the brake warning light is
not lit, the anti-lock system is disabled
but normal brake function remains
operational.
File:03ltisf.ex
Update:Tue May 28 08:40:24 1996
ProCarManuals.com

23 %
*
[IS11100(FM)03/96]
Speedometer
*
[IS11200(FM)03/96]
The speedometer tells you how many miles
(kilometers) per hour your vehicle is moving.
*
[IS11300(F )03/96]
Your vehicle contains a speedometer which
receives its input from the Anti-Lock brake
sensor. The speedometer is also used to provide
a speed signal for correct operation of the
vehicle's Powertrain Control Module (PCM),
electronic transmission, and speed control (if so
equipped). Because of this, it is very
IMPORTANT to change the speedometer's
internal conversion constant if the size of the
tires on the vehicle is changed. Changing the
conversion constant to the proper value when
the tires are changed will also ensure that the
speedometer retains the original factory-set
accuracy.
*
[IS11500(F )03/96]
Some vehicles are equipped with a vehicle speed
(mph/km/h) limiting device that is contained
within the Powertrain Control Module (PCM).
The purpose of this device is to maintain peak
vehicle speed below a specified limit. (Vehicle
speed limits may vary based on engine
displacement.)
*
[IS11600(F )03/96]
If you are experiencing an ªengine cut-outº
condition at high speeds, it may be the result of
this limiting device. It is a normal condition and
can be avoided by reducing vehicle/engine
speed.
File:03ltisf.ex
Update:Tue May 28 08:40:24 1996
ProCarManuals.com

63 [CF14400(FM)04/96]
2. Pull the headlamp control knob toward you
to the outer position. Headlamps are now on
in addition to the above.
[CF14500(F )04/96]
3. Rotate the knob when it is in an on position
to brighten or dim the instrument panel
lamps. Rotate fully counterclockwise to
operate courtesy and cargo lamps.
[CF14600(FM)05/96]
half page art:0020122-G
Headlamp switch
%*
[CF14800(FM)03/96]
Daytime Running Light System
*
[CF14900(FM)03/96]
(Canadian vehicles only)
*
[CF15000(FM)03/96]
The Daytime Running Light (DRL) system turns
the high beam headlamps on, with a reduced
light output, when:
*
[CF15100(FM)03/96]
q
The headlamp system is in the OFF position,
and
*
[CF15200(FM)01/96]
q
The vehicle is running, and
*
[CF15300(FM)03/96]
q
The vehicle has a fully released parking
brake.
File:05ltcff.ex
Update:Tue May 28 08:42:43 1996
ProCarManuals.com

65 %
*
[CF16600(F )03/96]
Combination Cargo and High-Mount
Brakelamp
[CF16700(F )04/96]
The combination cargo/high-mount brakelamp is
located outside the vehicle, directly over the rear
window. Use the headlamp control switch to
turn on the cargo lamp and interior courtesy
lights.
[CF16800(F )01/96]
A high-mount brakelamp feed is provided in the
taillamp wiring, in the event an aftermarket cap
is installed on the vehicle obscuring the
cargo/high-mount brakelamp on the cab. The
feed is located at the left rear of the vehicle,
behind the bumper and is marked with a white
tag ªcenter high-mount stop lamp.º
[CF16900(F )04/96]
quarter page art:0020902-B
Cargo/High-mount brakelamp
*
[CF17100(F )03/96]
RWARNING
Do not drive your vehicle with the
cargo/courtesy light on. Showing a white
light to the rear while driving on public
roads is illegal in some places.
File:05ltcff.ex
Update:Tue May 28 08:42:43 1996
ProCarManuals.com

67
*
[CF24100(FM)01/96]
Ignition
%*
[CF24110(FM)01/96]
Understanding the Positions of the Ignition
*
[CF24120(FM)01/96]
quarter page art:0020004-B
The positions of the key in the ignition lock cylinder.
*
[CF24130(FM)01/96]
ON allows you to test your vehicle's warning
lights (except the brake system warning light) to
make sure they work before you start the
engine. The key returns to the ON position once
the engine is started and remains in this position
while the engine runs.
*
[CF24140(FM)01/96]
START cranks the engine. Release the key once
the engine starts so that you do not damage the
starter. The key should return to ON when you
release it. The START position also allows you
to test the brake warning light.
*
[CF24150(FM)01/96]
OFF allows you to shut off the engine and all
accessories without locking the steering wheel or
the automatic transmission gearshift lever.
[CF24160(F )03/96]
LOCK locks the steering wheel. It also locks the
gearshift if your vehicle's gearshift is on the
column.
File:05ltcff.ex
Update:Tue May 28 08:42:43 1996
ProCarManuals.com

68 [CF24180(F )04/96]
RWARNING
LOCK position does not lock the gearshift
on floor-mounted gearshifts. If the
parking brake is not set and the gearshift
is moved out of Park (automatic
transmission) or out of gear (manual
transmission), your vehicle may move
unexpectedly.
*
[CF24200(F )05/96]
With the transfer case in N (Neutral), the vehicle
is free to move with either the automatic
transmission in P (Park) or with the manual
transmission in any driving gear.
*
[CF24210(F )05/96]
RWARNING
Do not leave the vehicle unattended with
the transfer case in the N (Neutral)
position. Always set the parking brake
fully and turn off the ignition when
leaving the vehicle.
*
[CF24220(FM)01/96]
LOCK is the only position that allows you to
remove the key. The LOCK feature helps to
protect your vehicle from theft.
%*
[CF24230(FM)01/96]
If the key is stuck in the LOCK position, move
the steering wheel left or right until the key
turns freely.
%*
[CF24240(FM)04/96]
ACCESSORY allows some of your vehicle's
electrical accessories such as the radio and the
windshield wipers to operate while the engine is
not running.
*
[CF24250(F )03/96]
In order to turn the key from the ON or OFF
position to the ACCESSORY position, you must
push the key release button if your vehicle's
manual transmission gearshift is mounted on the
floor.
File:05ltcff.ex
Update:Tue May 28 08:42:43 1996
ProCarManuals.com