Page 140 of 377
![FORD F250 1997 Owners Manual 141
*
[TO04400(FM)05/96]
If you need to shift out of P (Park) by using the
alternate procedure described above, it is
possible that a fuse has blown and that your
brakelamps may also not be functional FORD F250 1997 Owners Manual 141
*
[TO04400(FM)05/96]
If you need to shift out of P (Park) by using the
alternate procedure described above, it is
possible that a fuse has blown and that your
brakelamps may also not be functional](/manual-img/11/57800/w960_57800-139.png)
141
*
[TO04400(FM)05/96]
If you need to shift out of P (Park) by using the
alternate procedure described above, it is
possible that a fuse has blown and that your
brakelamps may also not be functional. Please
refer to the chapter titledRoadside Emergenciesin
this Owner Guide for instructions on checking
and replacing fuses.
*
[TO04500(FM)05/96]
RWARNING
DO NOT DRIVE YOUR VEHICLE UNTIL
YOU VERIFY THAT THE BRAKELAMPS
ARE WORKING.
[TO04600(FM)04/96]
For cold or warm engines:
*
[TO04700(FM)01/96]
If the engine still does not start after two
attempts:
*
[TO04800(FM)01/96]
1. Turn the ignition key to the OFF position.
*
[TO04900(FM)01/96]
2. Press the accelerator all the way to the floor
and hold it.
*
[TO05000(FM)01/96]
3. Turn the ignition key to the START position.
*
[TO05100(FM)01/96]
4. Release the ignition key when the engine
starts.
*
[TO05200(FM)03/96]
5. Release the accelerator gradually as the
engine speeds up.
*
[TO05300(FM)05/96]
If the engine still does not start, the fuel pump
shut-off switch may have been activated. For
directions on how to reset the switch seeFuel
Pump Shut-Off Switchin the index.
*
[TO05500(F )01/96]
A computer system controls the engine's idle
speed. When you start your vehicle, the engine's
idle speed normally runs higher than when it's
warmed up. These faster engine speeds will
make your vehicle move slightly faster than its
File:08lttof.ex
Update:Tue May 28 08:44:45 1996
ProCarManuals.com
Page 144 of 377
223
Roadside Emergencies
%*
[ER00205(FM)01/96]
If the Engine Cranks but Does
Not Start or Does Not Start After
a Collision
%*
[ER00210(FM)01/96]
Fuel Pump Shut-Off Switch
*
[ER00220(FM)03/96]
If the engine cranks but does not start or does
not start even after a small collision, the fuel
pump shut-off switch may have been activated.
The shut-off switch is a device intended to stop
the fuel pump when your vehicle has been
involved in a substantial jolt.
*
[ER00225(FM)03/96]
Once the shut-off switch is activated, you must
reset the switch by hand before you can start
your vehicle.
[ER00230(F )04/96]
one third page art:0020005-C
Fuel pump shut-off switch location
File:10lterf.ex
Update:Tue May 28 08:49:52 1996
ProCarManuals.com
Page 215 of 377
![FORD F250 1997 Owners Manual 215
*
[GF22500(FM)01/96]
To start, after being parked on a grade:
*
[GF22510(FM)01/96]
q
Apply the brake pedal and hold.
*
[GF22520(FM)01/96]
q
Start the engine.
*
[GF22530(FM)01/96]
q
Shift transmiss FORD F250 1997 Owners Manual 215
*
[GF22500(FM)01/96]
To start, after being parked on a grade:
*
[GF22510(FM)01/96]
q
Apply the brake pedal and hold.
*
[GF22520(FM)01/96]
q
Start the engine.
*
[GF22530(FM)01/96]
q
Shift transmiss](/manual-img/11/57800/w960_57800-214.png)
215
*
[GF22500(FM)01/96]
To start, after being parked on a grade:
*
[GF22510(FM)01/96]
q
Apply the brake pedal and hold.
*
[GF22520(FM)01/96]
q
Start the engine.
*
[GF22530(FM)01/96]
q
Shift transmission into gear and release the
parking brake.
*
[GF22540(FM)01/96]
q
Release the brake pedal and move the vehicle
uphill to free the wheel chocks.
*
[GF22550(FM)01/96]
q
Apply the brake pedal and hold while
another person retrieves the chocks.
%
*
[GF22560(F )01/96]
Snowplowing
[GF22610(F )04/96]
Commercial snow removal applications should
utilize F-350 Regular Cab 4x4 vehicles which are
much more conducive to the rigors of long
hours of plow operation.
% [GF22660(F )04/96]
Snowplowing and the Heavy Duty Front
Suspension Package
[GF22670(F )04/96]
If you plan to use your vehicle for plowing
snow, it should be equipped with the Heavy
Duty Front Suspension option. After adding the
snowplowing equipment, check the front-end
alignment and if necessary reset to prevent
uneven tire wear. If the snowplowing equipment
is later removed, check the front-end alignment
again.
[GF22680(F )04/96]
If you add equipment to your vehicle, which
will not ordinarily be removed when not in use,
such as heavy-duty winches, snowplow
components, brush guards, etc, then the
following index cannot be exceeded.
[GF22690(F )04/96]
NOTE: Diesel equipped vehicles not
recommended for snow plowing.
[GF22700(F )04/96]
q
Front axle curb weight must not exceed 63%
of the total vehicle curb weight.
File:09ltgff.ex
Update:Thu May 30 15:25:49 1996
ProCarManuals.com
Page 223 of 377
![FORD F250 1997 Owners Manual 224
*
[ER00250(FM)03/96]
RWARNING
If you see or smell fuel, do not reset the
switch or try to start your vehicle. Have
all the passengers get out of the vehicle
and call the local fire department or a FORD F250 1997 Owners Manual 224
*
[ER00250(FM)03/96]
RWARNING
If you see or smell fuel, do not reset the
switch or try to start your vehicle. Have
all the passengers get out of the vehicle
and call the local fire department or a](/manual-img/11/57800/w960_57800-222.png)
224
*
[ER00250(FM)03/96]
RWARNING
If you see or smell fuel, do not reset the
switch or try to start your vehicle. Have
all the passengers get out of the vehicle
and call the local fire department or a
towing service.
*
[ER00252(FM)03/96]
If your engine cranks but does not start after a
collision or substantial jolt:
*
[ER00255(FM)01/96]
1. Turn the ignition key to the OFF position.
*
[ER00260(FM)03/96]
2. Check under the vehicle for leaking fuel.
*
[ER00265(FM)01/96]
3. If you do not see or smell fuel, push the red
reset button down. If the button is already
set, you may have a different mechanical
problem.
*
[ER00270(F )01/96]
4. Turn the ignition key to the ON position for
a few seconds, then turn it to the OFF
position.
*
[ER00280(FM)03/96]
5. Check under the vehicle again for leaking
fuel.If you see or smell fuel, do not start
your vehicle again.If you do not see or
smell fuel, you can try to start your vehicle
again.
*
[ER00285(FM)03/96]
6. Check all vehicle warning lights before
driving your vehicle.
[ER00290(FM)03/96]
quarter page art:0020107-A
Reset button for fuel pump shut-off switch
File:10lterf.ex
Update:Tue May 28 08:49:52 1996
ProCarManuals.com
Page 235 of 377
![FORD F250 1997 Owners Manual 236
*
[ER03200(FM)01/96]
However, you should know that the circuit
breakers will reset themselves and allow the
electrical parts to work again once the overload
on the circuit is removed. If the circu FORD F250 1997 Owners Manual 236
*
[ER03200(FM)01/96]
However, you should know that the circuit
breakers will reset themselves and allow the
electrical parts to work again once the overload
on the circuit is removed. If the circu](/manual-img/11/57800/w960_57800-234.png)
236
*
[ER03200(FM)01/96]
However, you should know that the circuit
breakers will reset themselves and allow the
electrical parts to work again once the overload
on the circuit is removed. If the circuit breakers
continue to cut off electricity, have your vehicle's
electrical system checked.
*
[ER03250(FM)01/96]
If you replace a circuit breaker, use one with the
same amperage rating. To remove a circuit
breaker mounted in the fuse panel, grip it with
your finger and thumb and pull it straight out
of its socket.
%
*
[ER03500(FM)02/96]
Changing a Tire
*
[ER03600(FM)02/96]
If you get a flat tire while you are driving, do
not apply the brake heavily. Instead, gradually
decrease the speed. Hold the steering wheel
firmly and slowly move to a safe place on the
side of the road. Park on a level spot, turn off
the ignition, set the parking brake, and turn on
the hazard flashers.
%*
[ER03700(FM)01/96]
The Conventional Spare Tire
*
[ER03800(F )02/96]
If you have the conventional spare tire, you can
use it as a spare or as a regular tire. This spare
tire is identical to the other tires that come with
your vehicle, although the wheel may not match.
*
[ER04000(F )05/96]
RWARNING
To avoid injury, never run the engine
with one wheel off the ground, such as
when changing a tire.
*
[ER04100(F )01/96]
Extended use of other than matching size spare
tires on a Traction-Lok axle could result in a
permanent reduction in effectiveness. This loss of
effectiveness does not affect normal driving and
should not be noticeable to the driver.
File:10lterf.ex
Update:Tue May 28 08:49:52 1996
ProCarManuals.com
Page 305 of 377
![FORD F250 1997 Owners Manual 306 [MC39750(FM)04/96]Maintenance
[MC39775(FM)04/96]
Instructions for maintenance and service of the
noise control system have been included in the
Maintenance Schedule and Recordbooklet and in
the ª FORD F250 1997 Owners Manual 306 [MC39750(FM)04/96]Maintenance
[MC39775(FM)04/96]
Instructions for maintenance and service of the
noise control system have been included in the
Maintenance Schedule and Recordbooklet and in
the ª](/manual-img/11/57800/w960_57800-304.png)
306 [MC39750(FM)04/96]Maintenance
[MC39775(FM)04/96]
Instructions for maintenance and service of the
noise control system have been included in the
Maintenance Schedule and Recordbooklet and in
the ªGeneral Maintenance Checklist.º To aid the
noise control system throughout the life of the
vehicle, Ford Motor Company recommends that
this vehicle should be operated according to the
Owner's Guide. When installing replacement
parts, use caution not to violate the tampering
act as described above. Use the Maintenance
Record Log to list any inspections and services
performed on the vehicle.
%*
[MC39800(FM)03/96]
How to Prepare Your Vehicle for
Inspection/Maintenance (I/M) Testing
*
[MC39825(FM)04/96]
In some localities it may become a legal
requirement to pass an
Inspection/Maintenance (I/M) test of the
On-Board Diagnostic (OBD) II system. If the
vehicle's powertrain system or its battery has
just been serviced, the OBD II system is reset to
a not ready for I/M testing condition. To
prepare for I/M testing, the law specifies that
additional city and highway driving is necessary
to complete the check of the OBD II system.
[MC39830(FM)05/96]
The driving modes required to reach the ready
condition consist of a minimum of 30 minutes
city and highway driving as described below:
[MC39835(FM)05/96]
At least 20 minutes driving in stop and go, city
type traffic with at least four idle periods.
[MC39840(FM)05/96]
At least 10 minutes of driving on an expressway
or highway.
[MC39845(FM)05/96]
Before completing the above driving modes, the
engine must be warmed up and at operating
temperature. Once started, the vehicle must not
be turned off during these driving modes.
File:11ltmcf.ex
Update:Tue May 28 08:52:04 1996
ProCarManuals.com