1997 FORD F SERIES MOTORHOME AND COMMERCIAL CHASSIS brake

74 %
*
[GF24080( ALL)01/96]
Driving in Bad Weather
%*
[GF24090( ALL)01/96]
Slippery roads
*
[GF24100( ALL)01/96]
Drive cautiously on wet or snowy roads:
*
[GF24110( ALL)01/96]
q
Do not quickly move the steering wheel
unless necessary.
*
[GF24120( ALL)01/96]
q
Drive slower than you normally would.
*
[GF24130( ALL)01/96]
q
Give your vehicle more distance to stop.
[GF24140( M)01/96]
q
Pump the brake pedal steadily and evenly to
avoid locking your front wheels
[GF24160( M)01/96]
q
To stop on ice, shift to N (Neutral) below 10
mph (16 km/h) and gently pump brakes.
*
[GF24170( ALL)01/96]
q
Consider using one of the lower gears.
*
[GF24200( E M)01/96]
RWARNING
To avoid skidding and losing control on
slippery roads, do not downshift into 1
(First) when you are moving faster than
20 mph (30 km/h).
%*
[GF24270( ALL)01/96]
High water
*
[GF24280( ALL)01/96]
Never attempt to cross water that is fast flowing
or of unknown depth.
*
[GF24290( ALL)01/96]
Do not drive through flooded areas unless you
are sure that the water is below the bottom of
the wheel hubs.
*
[GF24300( ALL)01/96]
If you must drive through high water, drive
slowly. You may have limited traction or wet
brakes, so allow extra stopping distance because
your vehicle will not stop as quickly as usual.
*
[GF24310( ALL)01/96]
After you drive through the standing water,
apply your brakes gently several times as your
vehicle moves slowly. This helps to dry the
brakes.
File:09ltgfm.ex
Update:Fri Dec 13 11:22:54 1996

87 %
*
[ER03000( ALL)01/96]
Circuit Breakers
[ER03100( M)01/96]
If you need to check a circuit breaker that is on
the fuse panel, locate the circuit breaker
according to the instructions on the charts given
earlier in this chapter.
*
[ER03150( ALL)01/96]
Since you need diagnostic equipment to check
whether a circuit breaker works and such
equipment comes with instructions, we do not
discuss how to check circuit breakers.
*
[ER03200( ALL)01/96]
However, you should know that the circuit
breakers will reset themselves and allow the
electrical parts to work again once the overload
on the circuit is removed. If the circuit breakers
continue to cut off electricity, have your vehicle's
electrical system checked.
*
[ER03250( ALL)01/96]
If you replace a circuit breaker, use one with the
same amperage rating. To remove a circuit
breaker mounted in the fuse panel, grip it with
your finger and thumb and pull it straight out
of its socket.
%
*
[ER03500( ALL)01/96]
Changing a Tire
*
[ER03600( ALL)01/96]
If you get a flat tire while you are driving, do
not apply the brake heavily. Instead, gradually
decrease the speed. Hold the steering wheel
firmly and slowly move to a safe place on the
side of the road. Park on a level spot, turn off
the ignition, set the parking brake, and turn on
the hazard flashers.
%*
[ER03700( ALL)01/96]
The Conventional Spare Tire
[ER03900( M)01/96]
With the conventional spare tire, you can use it
as a spare or as a regular tire. This spare tire is
identical to the other tires that come with your
vehicle.
File:10lterm.ex
Update:Fri Dec 13 11:23:45 1996

88 %
*
[ER09400( ALL)01/96]
Preparing to Change the Tire
*
[ER09500( ALL)01/96]
NOTE: To lift your vehicle by other than the
front or rear jacking points, be sure to
use only hoist adapters with a wide
contact surface.
*
[ER09700( E M)01/96]
1. Make sure that your vehicle will not move
or roll. Put the gearshift in P (Park). Set the
parking brake and block the wheel that is
diagonally opposite the tire that you are
changing.
[ER10600( FM)01/96]
On F-Super Duty vehicles, the parking brake is
on the transmission. Therefore, the vehicle will
not be prevented from moving when a rear
wheel is lifted, even if the vehicle is in Park and
the parking brake is applied. Be sure to block
both directions of the wheel that is diagonally
opposite to the wheel that is being lifted.
*
[ER10700( FM)01/96]
RWARNING
If the vehicle slips off the jack, you or
someone else could be seriously injured.
[ER10800( M)01/96]
RWARNING
Do not put any part of your body under
the vehicle. Do not start the engine when
your vehicle is on the jack. Never raise
your vehicle by using a bumper jack.
[ER10900( M)01/96]
The jack is only for changing the tire in
emergencies. The Ford F-Super Duty Jack is
recommended. Use safety stands if you want to
service the vehicle.
[ER11000( M)01/96]
If an alternative jack is used, it must have a
curved surface swivel head compatible with the
stripped chassis jacking surfaces and must have
a minimum load rating of 4 tons. Do not use a
button head type jack.
File:10lterm.ex
Update:Fri Dec 13 11:23:45 1996

93 %
*
[ER19600( ALL)01/96]
RWARNING
Batteries contain sulfuric acid which burns
skin, eyes, and clothing.
*
[ER19650( ALL)01/96]
If the acid touches someone's skin, eyes, or
clothing, immediately flush the area with water
for at least 15 minutes. If someone swallows the
acid, have him or her drink lots of milk or water
first, then Milk of Magnesia, a beaten egg, or
vegetable oil. Call a doctor immediately.
*
[ER19750( ALL)01/96]
To avoid damaging your vehicle or your battery,
and to avoid injury to yourself, follow these
directions for preparing your vehicle to
jump-start and connecting the jumper cables in
the order they are given. If in doubt, call for
road service.
*
[ER19800( ALL)01/96]
Preparing Your Vehicle
*
[ER19850( ALL)01/96]
1. Your vehicle has a 12-volt starting system, so
you need to use a 12-volt jumper system.
You will damage your starting motor,
ignition system, and other electrical parts if
you connect them to a 24-volt power supply
(either two 12-volt batteries in series or a
24-volt generator set).
*
[ER19900( ALL)01/96]
2. Do not disconnect the battery of the disabled
vehicle. You could damage the vehicle's
electrical system.
*
[ER19950( ALL)01/96]
3. Park the booster vehicle close to the hood of
the disabled vehicle.Make sure the vehicles
do not touch each other.Set the parking
brake on both vehicles and stay clear of the
engine cooling fan and other moving parts.
File:10lterm.ex
Update:Fri Dec 13 11:23:45 1996

100
*
[MC01600( ALL)01/96]
q
Never get under a vehicle while it is
supported only by a jack. If you must work
under a vehicle, use safety stands.
*
[MC01700( ALL)01/96]
q
Keep all lit cigarettes and other smoking
materials away from the battery and all
fuel-related parts.
*
[MC01800( ALL)01/96]
If you disconnect the battery, the engine must
ªrelearnº its idle conditions before your vehicle
will drive properly. To find out how the engine
does this, seeBatteryin this chapter.
*
[MC01900( ALL)01/96]
Working with the engine off:
*
[MC02000( E M)01/96]
1. Set the parking brake fully and make sure
that the gearshift is securely latched in P
(Park).
*
[MC02300( ALL)01/96]
2. Remove the key from the ignition after you
turn the engine off.
*
[MC02400( ALL)01/96]
3. Block the wheels. This will prevent your
vehicle from moving unexpectedly.
*
[MC02500( ALL)01/96]
Working with the engine on:
*
[MC02700( E M)01/96]
1. Set the parking brake fully and make sure
that the gearshift is securely latched in P
(Park).
*
[MC02800( E M)01/96]
2. Block the wheels. This will prevent your
vehicle from moving unexpectedly.
*
[MC03000( ALL)01/96]
RWARNING
Do not start your engine with the air
cleaner removed and do not remove it
while the engine is running.
File:11ltmcm.ex
Update:Fri Dec 13 11:24:54 1996

102 %
*
[MC07000( ALL)01/96]
Checking and Adding Engine Oil
*
[MC07100( ALL)01/96]
Since the proper amount of engine oil is
important for safe engine operation, check the oil
using the dipstick each time you put fuel in
your vehicle. Remember the engine must be off,
the oil must be warm and the vehicle must be
parked on level ground.
%*
[MC07200( ALL)01/96]
Checking the engine oil level:
*
[MC07300( ALL)01/96]
1. Turn the engine off after it has warmed up
and allow a few minutes for the engine oil
to drain back into the oil pan.
*
[MC07500( E M)01/96]
2. Set the parking brake, making sure the
gearshift is securely latched in P (Park).
*
[MC07600( ALL)01/96]
3. Open the hood. Protect yourself from engine
heat.
*
[MC07700( ALL)01/96]
4. Locate the engine oil dipstick (highlighted in
yellow) and carefully pull it out of the
engine.
*
[MC07800( ALL)01/96]
5. Wipe the dipstick clean and put it back into
position, making sure it is fully seated.
File:11ltmcm.ex
Update:Fri Dec 13 11:24:54 1996

105
%*
[MC09600( ALL)01/96]
Brake Fluid
*
[MC09625( ALL)01/96]
Your vehicle is equipped with a brake fluid level
indicator in the master cylinder which lights the
BRAKE warning light on the instrument panel
when the brake fluid level is low.
*
[MC09650( ALL)01/96]
Under normal circumstances, your vehicle
should not use up brake fluid rapidly. However,
expect the level of the brake fluid to slowly fall
as you put more mileage on your vehicle and
the brake lining wears.
*
[MC09675( ALL)01/96]
Check the brake fluid at least once a year. You
can do this by looking at the fluid level in the
plastic brake fluid reservoir on the master
cylinder. The fluid level should be at or near the
MAX mark.
*
[MC09700( ALL)01/96]
RWARNING
Brake fluid is toxic.
*
[MC09725( ALL)01/96]
If brake fluid contacts eyes, flush eyes with
running water for 15 minutes. Get medical
attention if irritation persists. If taken internally,
drink water and induce vomiting. Get medical
attention immediately.
%*
[MC09750( ALL)01/96]
If the fluid is low, carefully clean and remove
the filler cap from the reservoir. Fill the
reservoir to the MAX line with Ford High
Performance DOT 3 Brake Fluid C6AZ-19542-AB
or DOT 3 equivalent fluid meeting Ford
specification ESA-M6C25-A.
*
[MC09775( ALL)01/96]
NOTE: If brake fluid is spilled on painted
surfaces, it must be flushed and wiped
away immediately. Brake fluid may
dissolve the paint finish on your
vehicle.
File:11ltmcm.ex
Update:Fri Dec 13 11:24:54 1996

106
*
[MC09800( ALL)01/96]
RWARNING
If you use a brake fluid that is not DOT
3, you will cause permanent damage to
your brakes.
*
[MC09825( ALL)01/96]
Do not fill the reservoir above the MAX line.
*
[MC09850( ALL)01/96]
If you find that the fluid level is excessively low
Ð below the seam or ridge on the outside of the
plastic reservoir Ð have the brake system
inspected.
*
[MC09875( ALL)01/96]
RWARNING
Do not let the reservoir for the master
cylinder run dry. This may cause the
brakes to fail.
[MC09925( M)01/96]
one third page art:0020867-B
Brake master cylinder
[MC09950( M)01/96]
Parking Brake Reservoir
[MC09975( M)01/96]
To inspect the parking brake fluid, refer to the
1997 Ford Service Manualor a qualified service
technician.
File:11ltmcm.ex
Update:Fri Dec 13 11:24:54 1996