1997 FORD F SERIES MOTORHOME AND COMMERCIAL CHASSIS reset

87 %
*
[ER03000( ALL)01/96]
Circuit Breakers
[ER03100( M)01/96]
If you need to check a circuit breaker that is on
the fuse panel, locate the circuit breaker
according to the instructions on the charts given
earlier in this chapter.
*
[ER03150( ALL)01/96]
Since you need diagnostic equipment to check
whether a circuit breaker works and such
equipment comes with instructions, we do not
discuss how to check circuit breakers.
*
[ER03200( ALL)01/96]
However, you should know that the circuit
breakers will reset themselves and allow the
electrical parts to work again once the overload
on the circuit is removed. If the circuit breakers
continue to cut off electricity, have your vehicle's
electrical system checked.
*
[ER03250( ALL)01/96]
If you replace a circuit breaker, use one with the
same amperage rating. To remove a circuit
breaker mounted in the fuse panel, grip it with
your finger and thumb and pull it straight out
of its socket.
%
*
[ER03500( ALL)01/96]
Changing a Tire
*
[ER03600( ALL)01/96]
If you get a flat tire while you are driving, do
not apply the brake heavily. Instead, gradually
decrease the speed. Hold the steering wheel
firmly and slowly move to a safe place on the
side of the road. Park on a level spot, turn off
the ignition, set the parking brake, and turn on
the hazard flashers.
%*
[ER03700( ALL)01/96]
The Conventional Spare Tire
[ER03900( M)01/96]
With the conventional spare tire, you can use it
as a spare or as a regular tire. This spare tire is
identical to the other tires that come with your
vehicle.
File:10lterm.ex
Update:Fri Dec 13 11:23:45 1996

139 %
*
[MC39800( ALL)01/96]
Readiness for Inspection/Maintenance
Testing
*
[MC39825( ALL)01/96]
In some localities it may become a legal
requirement to pass an
Inspection/Maintenance (I/M) test of the
On-Board Diagnostic (OBD) II system. If the
vehicle's powertrain system or its battery has
just been serviced, the OBD II system is reset to
a not ready for I/M testing condition. To
prepare for I/M testing, the law specifies a
ªneed for additional mixed city and highway
driving to complete the checkº of the OBD II
system. As soon as all of the OBD II system
checks are successfully completed, the OBD II
system is set to the ready condition. The amount
of driving required to reach the ready condition
varies with individual driving patterns. To
complete this requirement in the minimum
amount of time, refer to the OBD II Drive Cycle
defined below. If the vehicle owner cannot or
does not want to do the additional driving
required by law, a service center can perform
this drive cycle as it would any other type of
repair work.
*
[MC39850( ALL)01/96]
OBD II Drive Cycle
*
[MC39875( ALL)01/96]
The engine must be warmed up and at
operating temperature before proceeding with
the drive modes of the following OBD II Drive
Cycle.
*
[MC39900( ALL)01/96]
1. Start the engine. Drive or idle (in neutral)
the vehicle for 4 minutes.
[MC39925( ALL)01/96]
2. Idle the vehicle in drive (neutral for manual
transmission) for 40 seconds.
*
[MC39950( ALL)01/96]
3. Accelerate the vehicle to 45 mph (70 km/h)
at 1/4 to 1/2 throttle for 10 seconds.
File:11ltmcm.ex
Update:Fri Dec 13 11:24:54 1996

Index 213
Roadside assistance........... 156
Roadside emergencies........... 77
Rotating the tires............ 123
S
Safe driving tips............. 73
Safety Compliance Certification Label . . . 5±6
Safety defects, reporting......... 163
Safety information relating to
automotive fuels........... 130
Serial number (VIN)............ 5
Service concerns............ 157
Servicing your vehicle........... 99
precautions when servicing....... 99
servicing when you tow......... 97
Shift-lock system........... 40,52
Shift positions (see Gearshift)........ 51
Spare tire
changing the tire..........87±88
conventional spare........... 87
Spark plugs, specifications........ 147
Special driving conditions......... 73
Special notice............... 5
Specification chart, lubricants....... 149
Speed control
accelerating.............. 33
resetting................ 33
tap up/tap down............ 33
when towing a trailer.......... 70
Speedometer............... 19
Starting your vehicle
preparing to start your vehicle...... 37
starting a cold engine.......... 39
starting after a collision......... 77
starting a warm engine......... 39
File:ltixm.ex
Update:Fri Dec 13 11:25:54 1996