1997 FORD CONTOUR battery replacement

198
%*
[MC14500(ALL)01/96]
Battery
*
[MC14600(ALL)01/96]
Your vehicle may have a Motorcraft maintenance-free battery.
The Motorcraft maintenance-free battery does not require
additional water during its life of service. The vents are part of
the cover and cannot be removed. For longer, trouble-free
operation, keep the top of the battery clean and dry. Also, make
certain the battery cables are tightly fastened to the battery
terminals.
*
[MC14700(ALL)01/96]
If you see any corrosion on the battery cables or terminals,
remove the cables from the terminal and clean them both with a
wire brush. You can neutralize the acid with a solution of
baking soda and water. Reinstall the cables when you are done
cleaning them, and apply a small quantity of grease to the top
of each battery terminal to help prevent corrosion.
[MC14800(ALL)12/95]
Battery Replacement
*
[MC14900(ALL)01/96]
If your original equipment battery requires replacement (under
warranty), it may in some cases be replaced by a Motorcraft
low-maintenance battery. The low-maintenance battery has
removable vent caps for checking the electrolyte level and for
adding water, if needed.
[MC15000(ALL)12/95]
Check your battery's electrolyte level, at least every 12 months
or 12,000 miles (20,000 km), in temperatures above90ÊF (32ÊC)
and more often in temperatures above90ÊF (32ÊC).Keep the
electrolyte in each cell up to the ªlevelº indicator. Do not
overfill the battery cell.
*
[MC15100(ALL)01/96]
If the electrolyte level in your battery gets low, you can add
plain tap water to the battery, as long as you don't use hard
water, or water with a high mineral or alkali content. If
possible, however, try to only fill the battery cell with distilled
water. If the battery needs water often, have the charging
system checked.
File:11cdmco.ex
Update:Thu Sep 12 11:08:18 1996

200
[MC15900(ALL)12/95]
Disconnecting the Battery
[MC16000(ALL)12/95]
Because your vehicle engine is electronically controlled by a
computer, some control conditions are maintained by power
from the battery. If you ever disconnect the battery or install a
new battery, you must allow the computer to ªrelearnº its idle
conditions before your vehicle will drive properly. To begin this
process, put the gearshift in P (Park) (automatic transaxle) or
Neutral (manual transaxle), set the emergency brake, turn off all
the accessories, and start the vehicle. Bring the engine to normal
operating temperature. Allow the manual transaxle to idle for
one minute in Neutral. Allow the automatic transaxle engine to
idle for one minute in N (Neutral) and one minute in D (Drive).
Perform the previous procedure with the air conditioning (if
equipped) on and off (conditions permitting). The relearning
process will complete automatically as you drive the vehicle.
*
[MC16100(ALL)01/96]
If you do not let the engine relearn its idle, the idle quality of
your vehicle may be adversely affected until the idle is
relearned. Your vehicle will eventually relearn its idle while you
drive it, but it takes much longer than if you use the previous
procedure.
% [MC16200(ALL)04/96]
Passenger Compartment Air Filter
Replacement
[MC16300(ALL)04/96]
In your climate control system, you may have a filter that cleans
the air before it enters the interior of the vehicle. This filter
should be replaced at the intervals in theMaintenance Schedule
and Recordbooklet.
[MC16400(ALL)12/95]
To replace the passenger compartment air filter:
[MC16500(ALL)12/95]1.
Remove both windshield wiper arms. With the wiper arm in
the horizontal position, lift the arm away from the
windshield while pulling the retaining clip at the base
toward the windshield. Release the wiper arm, then lift it off
the base.
File:11cdmco.ex
Update:Thu Sep 12 11:08:18 1996

Maintenance and Care
219
%*
[MC32300(ALL)03/96
]
How to Prepare Your Vehicle for
Inspection/Maintenance (I/M) Testing
*
[MC32400(ALL)05/96]
In some localities it may become a legal requirement to pass an
Inspection/Maintenance (I/M) test of the On-Board Diagnostic
(OBD) II system. If the vehicle's powertrain system or its battery
has just been serviced, the OBD II system is reset to a not ready
for I/M testing condition. To prepare for I/M testing, the law
specifies that additional mixed city and highway driving is
required to complete the check of the OBD II system.
*
[MC32500(ALL)05/96]
OBD II Drive Cycle
*
[MC32601(ALL)05/96]
The driving modes required to reach the ready condition consist
of a minimum of 30 minutes of city and highway driving as
described below:
*
[MC32701(ALL)05/96]
n
At least twenty minutes driving in stop and go, city type
traffic with at least four idle periods.
*
[MC32801(ALL)05/96]
n
At least ten minutes of driving on an expressway or
highway.
*
[MC32901(ALL)05/96]
Before completing the above driving modes, the engine must be
warmed up and at operating temperature. Once started, the
vehicle must not be turned off during these driving modes.
%*
[MC34300(ALL)03/96]
Lights and Bulb Replacement
*
[MC34400(ALL)01/96]
It is a good idea to check the operation of the following lights
frequently:
*
[MC34500(ALL)01/96]
n
headlamps
*
[MC34600(ALL)01/96]
n
tail lamps
*
[MC34700(ALL)01/96]
n
brakelamps
*
[MC34800(ALL)01/96]
n
high-mount brakelamp
*
[MC34900(ALL)01/96]
n
hazard flasher
File:11cdmco.ex
Update:Thu Sep 12 11:08:18 1996

272
B
Backing up...................... 137
Basic vehicle warranty.................. 3
Battery........................ 198
acid, treating emergencies............169, 199
charging system warning light............. 14
disconnecting.................... 173
how to service................... 198
jumping a disabled battery.............. 169
maintenance-free.................. 198
proper disposal, recycling.............. 199
replacement, specifications.............. 229
servicing...................... 198
when storing your vehicle.............. 234
Brake fluid...................... 188
brake warning light.................. 13
checking and adding................ 188
description..................... 188
specifications.................... 231
Brakelamp...................... 222
bulb replacement.................. 222
high-mount brakelamp............... 222
Brakes........................ 125
adjustment..................... 125
anti-lock...................... 126
anti-lock brake system (ABS) warning light....... 21
applying the brakes................. 125
brake warning light.................. 13
fluid, checking and adding.............. 188
fluid, refill capacities..............188, 230
fluid, specifications................. 231
front disc...................... 125
if brakes do not grip well.............. 125
master cylinder................... 188
new brake linings................... 5
noise......................125±126
parking...................... 128
File:cdixo.ex
Update:Thu Sep 12 11:12:35 1996