1997 FORD CONTOUR air condition

16
[IS04600(ALL)12/95]
6 pica art:0000295-B*
[IS04700(ALL)08/95]
Chime for Headlamps On
[IS04800(ALL)12/95]
This chime sounds if the driver's door is open when the parking
lamps or headlamps are on. The chime sounds until you close
the door or turn off the lamps.
%*
[IS04900(ALL)03/96]
Air Bag Readiness Light
*
[IS05000(ALL)03/96]
The air bag supplemental restraint system uses a readiness light
and a tone to indicate the condition of the system. The
readiness light is in the instrument cluster. When you turn the
ignition key to ON, this light will illuminate for approximately
six (6) seconds and then turn off. This indicates that the system
is operating normally.NOTE:Maintenance of the air bag system
is not required.
[IS05100(ALL)12/95]
A problem with the system is indicated by one or more of the
following: the readiness light will either flash or stay lit, or it
will not light or a group of five beeps will be heard.
*
[IS05200(ALL)03/96]
RWARNING
If any of these things happen, even intermittently, have
the air bag system serviced at your Ford or
Lincoln-Mercury dealer immediately.
File:03cdiso.ex
Update:Thu Sep 12 10:58:17 1996

47
Controls and Features
%*
[CF00200(ALL)03/96]
The Climate Control Systems
[CF00300(ALL)12/95]
Your vehicle has one of the following:
[CF00400(ALL)12/95]
n
Heating Only System (Without Air Conditioning)
[CF00500(ALL)04/96]
n
Heating and Air Conditioning System
*
[CF00600(ALL)12/95]
If you are not sure which system your vehicle has, see the
diagrams on the following pages.
[CF00700(ALL)12/95]
Heating Only System
[CF00800(ALL)12/95]
The control for your heater system is located at the center of the
instrument panel below the radio. The heater will operate only
when the ignition key is turned to the ON position. Your heater
will heat and/or ventilate your vehicle interior depending on
the function selector knob position and temperature you select.
The function selector knob allows you to select heating or
ventilation and determine where the air will be directed. The
temperature control knob setting determines the temperature of
the air that flows into the vehicle.
[CF00900(O )05/96]
10-1/2 pica
art:0001181-C
The control for the heating only system
[CF01100(ALL)12/95]
To turn your heater system on, select any position except OFF.
This will turn the fan on and allow air flow into the vehicle. To
turn your heater off, select OFF. This will turn the fan off and
stop air flow from coming into the vehicle.
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996

48
[CF01200(ALL)12/95]
Your vehicle also has small demister openings on each front
door near the window. This allows a small amount of air flow
to be directed onto the door glass to reduce fogging whenever
the heater system is operating.
[CF01300(ALL)05/96]
The temperature control is located at the right side of the
control with a broken RED and BLUE band around the top and
sides. The all RED part of the band (full right) is the heat or
warmer area. The all BLUE area (full left) is the cool or
unheated temperature area. Any position selected between full
right and full left will give a temperature between the two
extreme temperatures. The cool temperature you select will not
be cooler than the outside temperature if your vehicle is not
equipped with an air conditioner.
*
[CF01400(ALL)03/96]
HFan speed adjustment
[CF01500(ALL)05/96]
The
H(left) control is the fan speed control which controls the
volume of air flow. Rotate the
Hcontrol to HI to increase fan
speed and increase the amount of air entering the vehicle. Four
fan speed positions are available and are indicated by LO, two
single dots and HI beside the
Hcontrol.
[CF01600(ALL)04/96]
Air flow selections
[CF01700(ALL)12/95]
PANEL
[CF01800(ALL)05/96]
Use PANEL to bring outside air through the instrument panel
registers. You can heat the air in this position by rotating the
temperature control into the RED area. The air CANNOT be
cooled below the outside temperature regardless of the
temperature control setting.
[CF01900(ALL)12/95]
PNL/FLR
[CF02000(ALL)12/95]
Select PNL/FLR to get air flow to the floor and through the
instrument panel registers at the same time. This selection can
be used to either heat or ventilate your vehicle.
*
[CF02100(ALL)03/96]
FLOOR
[CF02200(ALL)12/95]
Air flow will be to the floor when FLOOR is selected. The air
cannot be cooled in the FLOOR position but can be heated by
rotating the temperature control knob into the RED area.
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996

Controls and Features
49
[CF02300(ALL)12/95]
FLR/DEF
[CF02400(ALL)12/95]
Select FLR/DEF to get air to the floor and windshield defrosters
at the same time.
*
[CF02500(ALL)03/96]
VDEF
[CF02600(ALL)05/96]
SelectVDEF to obtain maximum air flow to the windshield.
Rotate the temperature control into the RED area for the air
temperature required to defrost. Rotate the
Hcontrol to
increase the air flow.
*
[CF02700(ALL)01/96]
Heating and Air Conditioning System
[CF02800(ALL)12/95]
Heating, ventilation, defrosting and defogging are accomplished
in the same way as with the heating only system. See ªHeating
Only System.º
[CF02900(ALL)12/95]
With the heating and air conditioning system, if the outside
temperature is about50ÊF (10ÊC) orwarmer, the air will be
dehumidified to remove moisture if you select FLR/DEF orV
DEF.
[CF03000(O )05/96]
10-1/2 pica
art:0001192-C
The control for the heating and air conditioning system
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996

50
[CF03200(ALL)12/95]
Air conditioning
*
[CF03300(ALL)01/96]
A/C
[CF03400(ALL)12/95]
Select A/C to get refrigerated outside air through the
instrument panel registers. The A/C position is used for cooling
except when extremely hot or fast cooling of the vehicle is
needed. Then, select MAX A/C for fast cooling and return to
A/C when you are comfortable.
*
[CF03500(ALL)03/96]
MAX A/C
[CF03600(ALL)03/96]
The MAX A/C position produces cool air more rapidly to
provide faster cooling of your vehicle. This is possible because
cooler air is drawn from inside the passenger area and
refrigerated again instead of using warmer outside air. Using
inside air will also make the fan sound louder, which is normal
when using MAX A/C. The air flow will be from the
instrument panel registers.
[CF03700(ALL)12/95]
Comfort tips
[CF03800(ALL)04/96]
The following tips will help you to get the most satisfaction
from your climate control system.
[CF03900(ALL)12/95]
n
In humid weather, selectVDEF before starting your
engine. This will help to prevent windshield fogging. After a
few minutes of operation, you may select another function.
[CF04000(ALL)12/95]
n
To prevent humidity buildup inside your vehicle, always
drive with the climate control system turned on.
*
[CF04100(ALL)01/96]
n
Do not put objects under the front seats that interfere with
the flow of air to the back seat area.
[CF04200(ALL)12/95]
n
Remove any snow, ice, or leaves from the air intake area of
your heater and air conditioner system which could block
the air intake. The intake area is located at the bottom of the
windshield.
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996

100
*
[SS11801(ALL)03/96]
Determining if System Is Operational
*
[SS11901(ALL)03/96]
The Air Bag Supplemental Restraint System uses a readiness
light and a tone to indicate the condition of the system. The
readiness light is in the instrument cluster. When you turn the
ignition key to ON, this light will illuminate for approximately
six (6) seconds and then turn off. This indicates that the system
is operating normally. NOTE: Routine maintenance of the air
bag system is not required.
%*
[SS12001(ALL)03/96]
A problem with the system is indicated by one or more of the
following:
*
[SS12101(ALL)03/96]
n
the readiness light will either flash or stay lit,
*
[SS12201(ALL)03/96]
n
the readiness light will not light immediately after ignition is
turned on,
%*
[SS12301(ALL)12/95]
n
a group of five beeps will be heard. The tone pattern will
repeat periodically until the problem and light are repaired.
*
[SS12401(ALL)03/96]
If any of these things happen, even intermittently, have the Air
Bag Supplemental Restraint System serviced at your Ford or
Lincoln-Mercury dealer immediately. Unless serviced, the system
may not function properly in the event of a collision.
*
[SS12501(ALL)03/96]
Disposal of Air Bags and Air Bag Equipped Vehicles
*
[SS12601(ALL)03/96]
For disposal of air bags or air bag equipped vehicles, see your
local Ford or Lincoln-Mercury dealer. Air bags MUST BE
disposed of by qualified personnel.
%*
[SS13400(ALL)01/96]
Safety Restraints for Children
*
[SS13500(ALL)01/96]
In the U.S. and Canada, you are required by law to use safety
restraints for children. If small children ride in your vehicle Ð
this generally includes children who are four years old or
younger and who weigh 40 pounds (18 kg) or less Ð you must
put them in safety seats that are made specially for children.
Safety belts alone do not provide maximum protection for these
children. Check your local and state laws for specific
requirements.
File:06cdsso.ex
Update:Thu Sep 12 11:03:20 1996

Starting
123
*
[TO06000(ALL)12/95]
Guarding Against Exhaust Fumes
*
[TO06100(ALL)01/96]
Carbon monoxide, although colorless and odorless, is present in
exhaust fumes. Take precautions to avoid its dangerous effects.
*
[TO06200(ALL)02/96]
RWARNING
Do not start your vehicle in a closed garage or in other
enclosed areas. Exhaust fumes can be toxic. Always open
the garage door before you start the engine.
*
[TO06300(ALL)01/96]
RWARNING
If you smell exhaust fumes inside your vehicle, have
your dealer inspect your vehicle immediately. Do not
drive if you smell exhaust fumes.
*
[TO06400(ALL)01/96]
Have the exhaust and body ventilation systems checked
whenever:
*
[TO06500(ALL)01/96]
n
your vehicle is raised for service
*
[TO06600(ALL)01/96]
n
the sound of the exhaust system changes
*
[TO06700(ALL)01/96]
n
your vehicle has been damaged in a collision
*
[TO06800(ALL)01/96]
Improve your ventilation by keeping all air inlet vents clear of
snow, leaves, and other debris.
*
[TO06900(ALL)01/96]
If the engine is idling while you are stopped in an open area
for long periods of time, open the windows at least one inch
(2.5 cm). Also, adjust the heating or air conditioning system to
bring in outside air.
[TO07000(ALL)12/95]
If you use the heater, set the fan speed on medium or high with
the function control knob turned to FLR, PNL/FLR or PANEL.
[TO07100(ALL)12/95]
If you use the air conditioner, set the fan speed on medium or
high with the A/C button pressed. (Do not use MAX A/C.)
File:08cdtoo.ex
Update:Thu Sep 12 11:03:39 1996

200
[MC15900(ALL)12/95]
Disconnecting the Battery
[MC16000(ALL)12/95]
Because your vehicle engine is electronically controlled by a
computer, some control conditions are maintained by power
from the battery. If you ever disconnect the battery or install a
new battery, you must allow the computer to ªrelearnº its idle
conditions before your vehicle will drive properly. To begin this
process, put the gearshift in P (Park) (automatic transaxle) or
Neutral (manual transaxle), set the emergency brake, turn off all
the accessories, and start the vehicle. Bring the engine to normal
operating temperature. Allow the manual transaxle to idle for
one minute in Neutral. Allow the automatic transaxle engine to
idle for one minute in N (Neutral) and one minute in D (Drive).
Perform the previous procedure with the air conditioning (if
equipped) on and off (conditions permitting). The relearning
process will complete automatically as you drive the vehicle.
*
[MC16100(ALL)01/96]
If you do not let the engine relearn its idle, the idle quality of
your vehicle may be adversely affected until the idle is
relearned. Your vehicle will eventually relearn its idle while you
drive it, but it takes much longer than if you use the previous
procedure.
% [MC16200(ALL)04/96]
Passenger Compartment Air Filter
Replacement
[MC16300(ALL)04/96]
In your climate control system, you may have a filter that cleans
the air before it enters the interior of the vehicle. This filter
should be replaced at the intervals in theMaintenance Schedule
and Recordbooklet.
[MC16400(ALL)12/95]
To replace the passenger compartment air filter:
[MC16500(ALL)12/95]1.
Remove both windshield wiper arms. With the wiper arm in
the horizontal position, lift the arm away from the
windshield while pulling the retaining clip at the base
toward the windshield. Release the wiper arm, then lift it off
the base.
File:11cdmco.ex
Update:Thu Sep 12 11:08:18 1996