1997 FORD CONTOUR water pump

192
*
[MC10200(ALL)12/95]
Check the engine coolant level in the engine coolant reservoir at
least once a month using the following guidelines.
[MC10300(ALL)12/95]
When your vehicle's engine is cool, the coolant level in the
engine coolant recovery reservoir should be at or above the
MIN mark. When the engine is hot, the coolant level should be
at the MAX mark. If the level is below the indicator mark in
either condition, coolant may need to be added.
*
[MC10400(ALL)02/96]
The coolant additives also protect the entire cooling system from
internal passageway corrosion and these additives lubricate the
water pump. The coolant should be serviced as noted in the
Maintenance Schedulebooklet.
*
[MC10500(ALL)01/96]
Adding Engine Coolant
*
[MC10601(ALL)05/96]
RWARNING
Do not put engine coolant in the container for the
windshield washer fluid.
*
[MC10611(ALL)05/96]
If sprayed on the windshield, engine coolant could make it
difficult to see through the windshield.
*
[MC10621(ALL)05/96]
When the engine is cool, add a 50/50 mixture of engine coolant
and water to the engine coolant recovery reservoir Ð DO NOT
ADD DIRECTLY TO THE RADIATOR. Add straight water only
in an emergency, but you should replace it with a 50/50
mixture of coolant and distilled water as soon as possible.
*
[MC10631(ALL)05/96]
Check the coolant level in the coolant recovery reservoir the
next few times you drive the vehicle. If necessary, add enough
of a 50/50 mixture of coolant and water to bring the liquid
level to the fill line on the reservoir.
*
[MC10641(ALL)05/96]
RWARNING
Never remove the coolant recovery cap while the engine
is running or hot.
File:11cdmco.ex
Update:Thu Sep 12 11:08:18 1996

Maintenance and Care
227
*
[MC40500(ALL)01/96]
Cleaning the Engine
*
[MC40600(ALL)01/96]
A clean engine is more efficient because a buildup of grease and
dirt acts as an insulator, keeping the engine warmer than usual.
*
[MC40700(ALL)01/96]
n
Extreme care must be used if a power washer is used to
clean the engine. The high pressure fluid could penetrate
sealed parts and assemblies causing damage or malfunctions.
*
[MC40800(ALL)04/96]
n
In order to avoid possible cracking of the engine block or
fuel injection pump, do not spray a hot engine or injection
pump with cold water.
*
[MC40900(ALL)04/96]
n
The alternator, distributor and air intake must be covered.
Covering these components will help prevent water damage.
*
[MC41000(ALL)01/96]
n
Never wash or rinse the engine while it is running. Water
getting into the engine may cause internal damage.
%*
[MC41100(ALL)03/96
]
Cleaning the Wheels
*
[MC41200(ALL)03/96]
Wash the wheels with the same detergent you use to wash your
vehicle's body. Do not use acid-based wheel cleaners, steel wool,
abrasives, fuel, or strong detergents. These substances will
damage protective coatings. Use tar and road oil remover to
remove grease and tar.
*
[MC41300(ALL)03/96]
NOTE: Before going to a car wash, find out if the brushes are
abrasive.
File:11cdmco.ex
Update:Thu Sep 12 11:08:18 1996