1997 FORD ASPIRE clock

176
*
[MC43825(ALL)01/96]
To fill the tank properly:
*
[MC43830(ALL)01/96]
1. Remove the fuel cap. Proceed to add fuel to
the tank only if your vehicle is on level
ground.
[MC43835(ALL)01/96]
2. Make sure that you pump unleaded fuel and
put the nozzle all the way inside the fuel
filler pipe. The fuel tank is normally full
after three automatic shutoffs of the nozzle.
*
[MC43840(ALL)01/96]
3. If you spill any fuel on the body of your
vehicle, clean it off immediately. The fuel
may dull or soften the paint if you do not
wash it off.
[MC43845(ALL)01/96]
4. Replace the fuel cap tightly when you are
finished. Turn it clockwise until you hear at
least three clicks.
*
[MC43850(ALL)01/96]
5. Push the fuel door closed.
%*
[MC43855(ALL)08/96]
Choosing the Right Fuel
*
[MC43861(ALL)05/96]
Use only UNLEADED FUEL. The use of leaded
fuel is prohibited by law and could damage
your vehicle. The damage may not be covered
by your warranty.
*
[MC43866(ALL)08/96]
Your vehicle was not designed to use fuel
containing manganese-based additives such as
MMT. Additionally, vehicles certified to
California emission standards (indicated on the
underhood Vehicle Emissions Control
Information label) are designed to operate on
California reformulated gasolines. If California
reformulated gasoline is not available when you
refuel, your vehicle can be operated on
non-California fuels. However, even though your
engine will perform adequately on other
File:11icmcf.ex
Update:Tue Mar 4 08:57:16 1997

188
*
[MC62900(ALL)01/97]
Installing the headlamp bulb
[MC62950(ALL)01/96]
1. Insert the glass end of the bulb assembly
into the socket.
[MC63000(ALL)01/96]
2. Secure the bulb assembly in place with the
metal retaining clip.
[MC63100(ALL)01/96]
3. Attach the rubber boot over the bulb
assembly.
[MC63200(ALL)01/96]
4. Slip the bulb retaining ring over the boot
and bulb assembly. Lock the ring into the
socket by rotating it clockwise until you feel
a ªstopº.
[MC63300(ALL)01/96]
5. Push the electrical connector into the rear of
the bulb assembly until it locks into position.
[MC63400(ALL)01/96]
6. Turn the headlamps on and make sure they
work properly. If the headlamp was
correctly aligned before you changed the
bulb, you should not need to align it again.
File:11icmcf.ex
Update:Tue Mar 4 08:57:16 1997

190 [MC63460(ALL)04/96]
half page art:0032288-A
[MC63465(ALL)04/96]
5. Turn the socket counterclockwise to remove
it from the lens.
[MC63470(ALL)04/96]
6. Remove the bulb from the socket by pushing
it in and turning it counterclockwise.
[MC63475(ALL)04/96]
7. Install the bulb by pushing it into the socket
and turning it clockwise.
[MC63480(ALL)04/96]
8. Install the socket by pushing it into its
housing and turning it clockwise.
[MC63485(ALL)04/96]
9. Replace the rear lamp.
File:11icmcf.ex
Update:Tue Mar 4 08:57:16 1997

191 %
*
[MC63500(ALL)01/96]
High-Mount Brakelamp Bulbs
[MC63600(ALL)01/96]
To replace the high-mount brakelamp bulb, refer
to the instructions below or take your vehicle to
your Ford dealer or a qualified technician.
[MC63700(ALL)01/96]
To remove the high-mount brakelamp:
[MC63800(ALL)01/96]
1. Disconnect the negative battery cable.
[MC63900(ALL)01/96]
2. Raise the hatchback.
[MC64000(ALL)04/96]
3. Gently pull the hatchback trim panel away
from the hatchback.
[MC64100(ALL)04/96]
4. Disconnect the luggage compartment lamp
electrical connector (if equipped) and lay the
trim panel aside.
[MC64200(ALL)04/96]
5. Rotate the high-mount lamp socket
counterclockwise and remove it from the
housing.
[MC64300(ALL)04/96]
6. Carefully remove the bulb by gently pulling
it straight from the socket.
*
[MC64400(ALL)01/96]
To install a bulb:
[MC64500(ALL)01/96]
1. Firmly install the replacement bulb into the
socket.
[MC64600(ALL)01/96]
2. Place the socket assembly in the high-mount
stoplamp housing and turn clockwise to lock
into position.
[MC64700(ALL)01/96]
3. Position the hatchback trim panel and
connect the luggage compartment lamp
electrical connector (if equipped).
[MC64800(ALL)01/96]
4. Insert the trim panel retaining clips into the
locating holes in the hatchback and push
each clip firmly into position.
[MC64820(ALL)04/96]
5. Close the hatchback and reconnect the
negative battery cable.
File:11icmcf.ex
Update:Tue Mar 4 08:57:16 1997

246 Index
Cleaning your vehicle (continued)
exterior lamps............ 193
fabric................ 194
headlamps.............. 193
instrument panel........... 193
instrument panel lens......... 195
interior................ 194
plastic parts............. 193
polishing............... 192
rear windows.............. 41
rustproofing............. 193
safety belts.............. 195
tail lamps.............. 193
upholstery and interior trim...... 194
washing............... 192
waxing................ 192
wheels................ 193
windows................ 41
Climate control system........... 33
Clock................... 27
Clutch................. 114
fluid reservoir............ 152
operation while driving........ 114
recommended shift speeds....... 117
shifting the gears........... 115
Cold engine starting............ 95
Combination lap and shoulder belts . . . 63, 65
Controls, mirrors............. 51
Convenience kit in cargo area...... 132
Coolant (see Engine coolant)....... 155
checking and adding......... 155
drain and flush............ 159
preparing for storage......... 197
temperature gauge........... 17
warnings............... 155
Cooling fan............... 146
Crankcase emission filter......... 199
Customer Assistance Center, Ford (U.S.) . . 213
Customer Assistance Centre,
Ford of Canada..........214, 218
File:icixf.ex
Update:Tue Mar 4 08:59:36 1997