1997 FORD AEROSTAR engine

64 [CF00280(ALL)01/96]Select MIX to direct air to the floor and
windshield defrosters at the same time. If the
outside temperature is about50ÊF (9ÊC) or
warmer, the air will also be dehumidified to
remove moisture. This feature will help prevent
fogging in humid weather. The air can be cooled
or heated.
[CF00290(ALL)01/96]
SelectVto obtain maximum airflow to the
windshield. Rotate the TEMP knob into the red
area for the air temperature required to defrost.
When the outside temperature is about50ÊF
(9ÊC) orwarmer, the air will be dehumidified to
remove moisture. Rotate thexknob on the left
to increase the airflow.
*
[CF00300(ALL)05/96]
Operating Tips
[CF00320(ALL)04/96]
The following tips help you get the most
satisfaction from your air conditioner and heater
system:
[CF00330(ALL)01/96]
q
In humid weather, selectVbefore starting
your engine. This helps prevent windshield
fogging. After a few minutes of operation,
you may select another airflow position.
[CF00340(ALL)04/96]
q
To prevent humidity buildup inside your
vehicle, always drive with the air conditioner
and heater system turned on.
*
[CF00350(ALL)01/96]
q
Do not put objects under the front seats that
interfere with the flow of air to the back seat
area.
*
[CF00360(ALL)03/96]
q
Remove any snow, ice, or leaves from the air
intake area at the bottom of the windshield.
[CF00370(ALL)01/96]
q
For maximum heating, rotate the function
selector knob to FLR, the temperature control
knob to the red (warm) range, and the fan
knob to HI.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

67
*
[CF00515(ALL)05/96]
Operating Tips
*
[CF00520(ALL)03/96]
The following tips will help you to get the most
satisfaction from your heater system.
[CF00530(ALL)01/96]
q
In humid weather, selectVbefore starting
your engine. This will help to prevent
windshield fogging. After a few minutes, you
may select another airflow position.
*
[CF00540(ALL)03/96]
q
To prevent humidity buildup inside your
vehicle, always drive with the heater system
turned on.
*
[CF00550(ALL)01/96]
q
Do not put objects under the front seats that
interfere with the flow of air to the back seat
area.
*
[CF00560(ALL)03/96]
q
Remove any snow, ice, or leaves from the air
intake area at the bottom of the windshield.
[CF00570(ALL)01/96]
q
For maximum heating, rotate the function
selector knob to FLR, the temperature control
knob to the red (warm) range, and the fan
blower knob to HI.
% [CF00580(ALL)04/96]
Auxiliary Heater and Air
Conditioner (If equipped)
[CF00590(ALL)04/96]
If your vehicle is equipped with a factory
installed auxiliary unit (heater or heater/air
conditioner), the front control assembly will
include separate switches for FRONT and REAR
fan control. Fan speed for front and rear systems
can be set as desired by adjusting these switches.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

69
%*
[CF00650(ALL)03/96]
Rear Window Defroster
(If equipped)
*
[CF00660(ALL)03/96]
The defroster for the rear window clears frost,
fog, or thin ice from both the inside and outside
of the rear window.
*
[CF00670(ALL)03/96]
The control switch is located on the instrument
panel to the right of the steering column.
[CF00680(ALL)01/96]
one third page art:0020899-A
Rear window defroster switch
*
[CF00690(ALL)03/96]
To defrost the rear window:
*
[CF00700(ALL)03/96]
1. Clear any snow or ice from the rear
window.
*
[CF00710(ALL)03/96]
2. Get in your vehicle and start the engine.
[CF00720(ALL)04/96]
3. Press the switch. The indicator light will turn
on.
[CF00730(ALL)04/96]
The defroster turns off automatically after
approximately 10 minutes. If the window is not
clear, turn on the defroster again. It will also
automatically shut off any time the engine is
shut off.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

74
*
[CF01340(ALL)01/96]
Clock Controls on Electronic
Radios
[CF01345(ALL)04/96]
The electronic radios have a built-in clock. For
complete operating instructions, refer to the
Electronic Sound Systemschapter in this Owner
Guide.
*
[CF02100(ALL)01/96]
Ignition
%*
[CF02110(ALL)01/96]
Understanding the Positions of the Ignition
*
[CF02120(ALL)01/96]
quarter page art:0020004-B
The positions of the key in the ignition lock cylinder.
%*
[CF02130(ALL)04/96]
ACCESSORY allows some of your vehicle's
electrical accessories such as the radio and the
windshield wipers to operate while the engine is
not running.
*
[CF02135(ALL)01/96]
LOCK locks the steering wheel and gearshift
lever.
*
[CF02140(ALL)01/96]
LOCK is the only position that allows you to
remove the key. The LOCK feature helps to
protect your vehicle from theft.
*
[CF02150(ALL)01/96]
If your key is stuck in the LOCK position and
will not turn, move your steering wheel left or
right until the key turns freely.
*
[CF02160(ALL)01/96]
OFF allows you to shut off the engine and all
accessories without locking the steering wheel or
the automatic transmission gearshift lever.
*
[CF02170(ALL)01/96]
ON allows you to test your vehicle's warning
lights (except the brake system warning light) to
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

75
make sure they work before you start the
engine. The key returns to the ON position once
the engine is started and remains in this position
while the engine runs.
*
[CF02180(ALL)01/96]
START cranks the engine. Release the key once
the engine starts so that you do not damage the
starter. The key should return to ON when you
release it. The START position also allows you
to test the brake warning light.
%
*
[CF02500(ALL)02/96]
The Turn Signal Lever
*
[CF02510(ALL)02/96]
You can use the turn signal lever on the left side
of the steering column to:
*
[CF02520(ALL)02/96]
q
operate the turn signals and cornering lamps
*
[CF02530(ALL)03/96]
q
turn the high beams on/off
*
[CF02540(ALL)03/96]
q
flash the lamps
*
[CF02550(ALL)03/96]
q
turn the windshield wipers and washer
on/off
%*
[CF02560(ALL)01/96]
Turn Signals
[CF02570(ALL)01/96]
one third page art:0095013-A
Turn signal operation
*
[CF02580(ALL)08/95]
If the turn indicator light in the instrument
panel does not illuminate or remains on (doesn't
flash) when you signal a turn, the turn signaling
system is malfunctioning. Have this condition
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

153
Starting
%*
[TO04800(ALL)01/96]
Fuel-Injected Engines
*
[TO04900(ALL)01/96]
When starting a fuel-injected engine,the most
important thing to remember is to avoid
pressing down on the accelerator before or
during starting. Only use the accelerator when
you have problems getting your vehicle started.
SeeStarting Your Enginein this chapter for
details about when to use the accelerator while
you start your vehicle.
*
[TO05150(ALL)01/96]
Starting Your Vehicle
%*
[TO05200(ALL)01/96]
Preparing to Start Your Vehicle
*
[TO05300(ALL)02/96]
RWARNING
Do not start your vehicle in a closed
garage or in other enclosed areas. Exhaust
fumes can be toxic. Always open the
garage door before you start the engine.
*
[TO05400(ALL)01/96]
Before you start your vehicle, do the following:
*
[TO05500(ALL)01/96]
1. Make sure all occupants in the vehicle
buckle their safety belts. SeeSafety Restraints
in the Index for more details.
*
[TO05600(ALL)01/96]
2. Make sure the headlamps and other
accessories are turned off when starting.
*
[TO05750(ALL)01/96]
3. Make sure that the gearshift is in P (Park)
and the parking brake is set before you turn
the key.
*
[TO06015(ALL)02/96]
Before you start your vehicle, you should test
the warning lights on the instrument panel to
make sure that they work. Refer to the
Instrumentationchapter.
File:08cptoa.ex
Update:Thu Jun 6 14:43:40 1996

154 %
*
[TO06200(ALL)01/96]
Starting Your Engine
*
[TO06300(ALL)01/96]
To start your engine:
*
[TO06400(ALL)01/96]
1. Follow the steps underPreparing to Start
Your Vehicleat the beginning of this section.
*
[TO06425(ALL)01/96]
2. Turn the ignition key to the ON position.
*
[TO06451(ALL)01/96]
3. DO NOT depress the accelerator pedal when
starting your engine. DO NOT use the
accelerator while the vehicle is parked.
*
[TO06475(ALL)01/96]
4. Turn the key to the START position
(cranking) until the engine starts. Allow the
key to return to the ON position after the
engine has started.
*
[TO06501(ALL)05/96]
If you have difficulty in turning the key,
rotate the steering wheel slightly because it
may be binding.
%*
[TO06505(ALL)01/96]
For a cold engine:
*
[TO06510(ALL)01/96]
q
At temperatures10ÊF (-12ÊC) andbelow:If
the engine does not start infifteen (15)
secondson the first try, turn the key to OFF,
wait approximately ten (10) seconds so you
do not flood the engine, then try again.
*
[TO06515(ALL)01/96]
q
At temperaturesabove10ÊF(-12ÊC):If the
engine does not start infive (5) secondson
the first try, turn the key to OFF, wait
approximately ten (10) seconds so you do not
flood the engine, then try again.
%*
[TO06530(ALL)01/96]
For a warm engine:
*
[TO06551(ALL)01/96]
q
Do not hold the key in the START position
for more thanfive (5) secondsat a time. If
the engine does not start within five (5)
seconds on the first try, turn the key to the
OFF position. Wait a few seconds after the
starter stops, then try again.
File:08cptoa.ex
Update:Thu Jun 6 14:43:40 1996

155
*
[TO06575(ALL)01/96]
Whenever you start your vehicle, release the key
as soon as the engine starts. Excessive cranking
could damage the starter.
*
[TO06601(ALL)01/96]
After starting, allow the engine to idle for a few
seconds before driving away.
%*
[TO06625(ALL)05/96]
NOTE: Your vehicle is equipped with a
brake-shift interlock feature. This
feature prevents you from shifting
from P (Park) unless you have the
brake pedal depressed. (The ignition
must be in the ON position.) If you
cannot shift from P (Park) with the
brake pedal depressed:
*
[TO06627(ALL)05/96]
1. Apply the parking brake.
*
[TO06629(ALL)05/96]
2. Remove the key.
*
[TO06631(ALL)05/96]
3. Insert the key and rotate it one position
clockwise (ignition in the OFF position).
*
[TO06633(ALL)05/96]
4. Apply the brake pedal and shift to N
(Neutral). (If the vehicle is shifted back to P
[Park], you must repeat the previous steps.)
*
[TO06635(ALL)05/96]
5. Start the vehicle.
*
[TO06637(ALL)05/96]
If you need to shift out of P (Park) by using the
alternate procedure described above, it is
possible that a fuse has blown and that your
brakelamps may also not be functional. Please
refer to the chapter titledRoadside Emergenciesin
this Owner Guide for instructions on checking
and replacing fuses.
*
[TO06640(ALL)05/96]
RWARNING
DO NOT DRIVE YOUR VEHICLE UNTIL
YOU VERIFY THAT THE BRAKELAMPS
ARE WORKING.
File:08cptoa.ex
Update:Thu Jun 6 14:43:40 1996