1997 FORD AEROSTAR transmission

18
*
[IS11501(ALL)03/96]
If your engine overheats:
*
[IS11601(ALL)03/96]
1. Pull off the road as soon as it is safely
possible.
*
[IS11701(ALL)01/96]
2. Turn off the engine.
*
[IS11801(ALL)03/96]
3. Let the engine cool.DO NOT REMOVE
COOLANT SYSTEM FILL CAP UNTIL
THE ENGINE IS COOL.
*
[IS11901(ALL)01/96]
4. Check the coolant level following the
instructions on checking and adding coolant
to your engine. Refer toEngine coolantin the
Index. If you do not follow these
instructions, you or others could be injured.
[IS12325(ALL)01/96]
quarter page art:0020541-B
Engine coolant temperature gauge
%*
[IS12601(ALL)03/96]
Speedometer
*
[IS12700(ALL)03/96]
The speedometer tells you how many miles
(kilometers) per hour your vehicle is moving.
*
[IS12750(ALL)03/96]
Your vehicle contains a speedometer which
receives its input from the Anti-Lock brake
sensor. The speedometer is also used to provide
a speed signal for correct operation of the
vehicle's Powertrain Control Module (PCM),
electronic transmission, and speed control (if so
equipped). Because of this, it is very
IMPORTANT to change the speedometer's
internal conversion constant if the size of the
tires on the vehicle is changed. Changing the
conversion constant to the proper value when
File:03cpisa.ex
Update:Fri Jun 7 14:23:36 1996

74
*
[CF01340(ALL)01/96]
Clock Controls on Electronic
Radios
[CF01345(ALL)04/96]
The electronic radios have a built-in clock. For
complete operating instructions, refer to the
Electronic Sound Systemschapter in this Owner
Guide.
*
[CF02100(ALL)01/96]
Ignition
%*
[CF02110(ALL)01/96]
Understanding the Positions of the Ignition
*
[CF02120(ALL)01/96]
quarter page art:0020004-B
The positions of the key in the ignition lock cylinder.
%*
[CF02130(ALL)04/96]
ACCESSORY allows some of your vehicle's
electrical accessories such as the radio and the
windshield wipers to operate while the engine is
not running.
*
[CF02135(ALL)01/96]
LOCK locks the steering wheel and gearshift
lever.
*
[CF02140(ALL)01/96]
LOCK is the only position that allows you to
remove the key. The LOCK feature helps to
protect your vehicle from theft.
*
[CF02150(ALL)01/96]
If your key is stuck in the LOCK position and
will not turn, move your steering wheel left or
right until the key turns freely.
*
[CF02160(ALL)01/96]
OFF allows you to shut off the engine and all
accessories without locking the steering wheel or
the automatic transmission gearshift lever.
*
[CF02170(ALL)01/96]
ON allows you to test your vehicle's warning
lights (except the brake system warning light) to
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

78 [CF05500(ALL)01/96]
one third page art:0095028-AOverdrive off button
[CF05504(ALL)01/96]
OVERDRIVE OFF Light on Gearshift
Lever
[CF05508(ALL)01/96]
This light indicates the operating range of the
transmission. The word OFF illuminates on the
lever when the OVERDRIVE OFF button is
depressed.
%
*
[CF05530(ALL)05/96]
Hazard Flasher Switch
*
[CF05540(ALL)05/96]
The hazard flasher switch is located on the top
of the steering column. For more information,
refer toHazard Flasherin theRoadside Emergencies
chapter.
[CF05575(ALL)05/96]
quarter page art:0095077-A
Hazard flasher
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

82
*
[CF09325(ALL)05/96]
RWARNING
Do not shift the transmission into N
(Neutral) with the speed control on.
*
[CF09400(ALL)05/96]
To Disengage Speed Control
[CF09500(ALL)03/96]
Depress the brake pedal.
*
[CF09600(ALL)05/96]
Disengaging the speed control will not erase the
previously programmed set speed.
*
[CF09700(ALL)05/96]
To Return to a Set Speed
[CF09800(ALL)03/96]
Press RESUME. For RESUME to operate, the
vehicle speed must be faster than 30 mph
(48 km/h).
*
[CF11950(ALL)05/96]
Use of radio transmitting equipment that is not
Federal Communications Commission (FCC) or
in Canada the Canadian Radio and
Telecommunications Commission (CRTC)
approved may cause the speed control to
malfunction. Therefore, use only properly
installed FCC (CRTC in Canada) approved radio
transmitting equipment in your vehicle.
[CF13000(ALL)05/96]Dome/Map/Reading Lamps
(If equipped)
[CF13020(ALL)05/96]
one third page art:0095104-A
Map lamps
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

168
%*
[GF04000(ALL)01/96]
Steering Your Vehicle
%*
[GF04100(ALL)01/96]
Your vehicle comes with power steering. Power
steering uses energy from the engine to help
steer your vehicle.
%*
[GF04150(ALL)03/96]
If the amount of effort needed to steer your
vehicle changes at a constant vehicle speed, have
the power steering system checked. If the power
steering system breaks down (or if the engine is
turned off), you can steer the vehicle manually
but it takes more effort.
*
[GF04200(ALL)01/96]
Never hold the steering wheel to the extreme
right or left for more than five seconds if the
engine is running. This can damage the power
steering pump.
*
[GF04300(ALL)01/96]
NOTE: After any severe impact such as
striking large potholes, sliding into
curbs on icy roads, or a collision
involving the front end, observe the
steering wheel alignment. If the spokes
of the steering wheel seem to be in a
different position while going straight
down the road, have the front
suspension and steering checked for
possible damage.
[GF10000(ALL)03/96]Automatic Transmission
Operation (4R44E/5R55E)
[GF10050(ALL)06/96]
If your vehicle is equipped with an automatic
transmission, it will be either a four speed
overdrive transmission (4R44E) or a five speed
overdrive transmission (5R55E). All 3.0L engines
use the 4R44E transmission, while all 4.0L
engines use the 5R55E transmission. Both
transmission types have a lockup torque
converter. Transmission operation is controlled
by the Powertrain Control Module (PCM).
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

169
*
[GF10150(ALL)01/96]
The PCM will automatically adjust transmission
operation to make up for varying conditions.
Several sensors located on the engine and
transmission such as throttle position, engine
speed, vehicle speed and transmission
temperature are used by the PCM to shift the
transmission into a higher or lower gear when
required for the best performance and fuel
economy. For example, you may notice that the
transmission will upshift to a higher gear more
quickly when the vehicle has not reached normal
operating temperature.
*
[GF10200(ALL)01/96]
The PCM also controls the transmission's Torque
Converter Clutch (TCC) to further raise vehicle
performance and fuel economy. The TCC will
engage when the transmission operating
temperature and other conditions determined by
the PCM have been met. Engagement of the
clutch may be noted as a decrease in engine
speed.
[GF10250(ALL)05/96]
To help in troubleshooting, the PCM continually
performs self-tests on the electronic control
system and, if any faults are detected, stores
them in memory. The Transmission Control
Indicator Light (TCIL) (O/D OFF), which is
located on the gearshift lever, may flash steadily
if a malfunction has been detected. If the TCIL is
flashing, contact your Ford dealer as soon as
possible. If this condition persists, damage to the
transmission could occur.
*
[GF10320(ALL)05/96]
Speed limiter
*
[GF10330(ALL)06/96]
All models are equipped with a Powertrain
Control Module (PCM) which limits the
maximum engine speed and thus road speed in
top gear. Vehicle operation is normal since the
controlled maximum speed is above posted
highway speeds in North America.
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

170
*
[GF10400(ALL)05/96]
Power Braking
*
[GF10410(ALL)05/96]
Increasing the engine speed above idle without
vehicle movement (such as holding the brake) in
a forward or reverse gear causes transmission
stall.
*
[GF10450(ALL)05/96]
NOTE: Continued operation in the stall
condition can result in transmission
overheat, malfunction or fluid
expulsion.
*
[GF10500(ALL)05/96]
Automatic Overdrive
Transmission
%*
[GF10750(ALL)05/96]
Putting Your Vehicle in Gear
[GF10800(ALL)05/96]
Your vehicle's gearshift is on the steering
column. The transmission control switch is
located on the end of the gearshift lever. You
can put the gearshift in any one of several
positions.
[GF10900(ALL)01/96]
one third page art:0095027-A
The positions of the column-mounted gearshift
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

172
*
[GF12500(ALL)05/96]
4. Apply the brake pedal and shift to N
(Neutral). (If the vehicle is shifted back to P
[Park], you must repeat the previous steps.)
*
[GF12600(ALL)05/96]
5. Start the vehicle.
*
[GF12700(ALL)05/96]
If you need to shift out of P (Park) by using the
alternate procedure described above, it is
possible that a fuse has blown and that your
brakelamps may also not be functional. Please
refer to the chapter titledRoadside Emergenciesin
this Owner Guide for instructions on checking
and replacing fuses.
*
[GF12800(ALL)05/96]
RWARNING
DO NOT DRIVE YOUR VEHICLE UNTIL
YOU VERIFY THAT THE BRAKELAMPS
ARE WORKING.
*
[GF12820(ALL)05/96]
P (Park)
[GF12830(ALL)03/96]
Always come to a complete stop before you shift
into P (Park). This position locks the
transmission and prevents the rear wheels from
turning.
[GF12840(ALL)03/96]
To securely latch the gearshift in the P (Park)
position, pull it toward you, push it completely
counterclockwise against the stop, and then push
it toward the instrument panel.
*
[GF12850(ALL)06/96]
The gearshift is securely latched in P (Park) if
you cannot rotate it in a clockwise direction
without lifting it toward you.
*
[GF12860(ALL)05/96]
RWARNING
Always set the parking brake fully and
make sure the gearshift is latched in P
(Park). Turn off the ignition whenever you
leave your vehicle.
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996