Page 227 of 358
Downloaded from www.Manualslib.com manuals search engine 3100 (Code M) Engine 3.4L DOHC (Code X)
Engine
The engine oil fill cap is located toward the front of the
engine near the yellow-looped engine oil dipstick.
Be sure
to fill it enough to put the level somewhere in
the proper operating range. Push the dipstick all the way
back in when you’re through.
What Kind of Oil to Use
Oils recommended for your vehicle can be identified by
looking
for the “Starburst” symbol. This symbol
indicates that the oil
has been certified by the American
Petroleum Institute (API).
Do not use any oil which
does not carry this Starburst symbol.
If you change your own oil,
be sure you use oil that has
the Starburst symbol on the
front of the oil container.
If you have your oil changed for you, be sure the oil put
into your engine
is American Petroleum Institute
certified for gasoline engines.
You should also use the proper viscosity oil for your
vehicle,
as shown in the following chart:
Page 228 of 358
Downloaded from www.Manualslib.com manuals search engine RECOMMENDEO SAE VISCOSITY GRADE ENGINE OILS
FOR BEST FUEL ECONOMY AND COLD STARTING, SELECT THE LOWEST
SAE VISCOSITY GRADE
011 FOR THE EXPECTED TEMPERATURE RANGE.
HOT
WEATHER
I
"F
+ 100-
+Eo-
+60-
t40-
t20-
0-
C
+ 38
+ 21
+ 16
+4
-7
- 18
LO
LOOK
FOR THIS
SYMBOL
II SAE 1UW-30
WEATHER
DO NOT USE SAE 2OW-50 OR ANY OTHER GRADE OIL NOT RECOMMENDED
As shown in the chart, if you have the 3100 engine,
SAE 5W-30 is best for your vehicle. However, you can
use
SAE low-30 if it's going to be 0°F (-18°C) or
above. These numbers on
an oil container show its
viscosity, or thickness. Do not use other viscosity oils,
such as
SAE 20W-50.
Page 229 of 358

Downloaded from www.Manualslib.com manuals search engine RECOMMENDED SAE VISCOSITY GRADE ENGINE OILS
FOR BEST FUEL ECONOMY AND COLD STARTING, SELECT THE LOWEST
SA€ VISCOSITY GRADE
011 FOR THE EXPECTED TEMPERATURE RANGE.
HOT
WEATHER
+loo- - +38
+00- - +27
+60--+16
+40- -+4
t20---7
O---l8
WOK
FOR THIS
SYMBOL
COLD
WEATHER
DO NOT USE SAE 2OW-50 OR ANY OTHER GRADE OIL NOT RECOMMENDED
As shown in the chart, if you have the 3.4L DOHC
engine, SAE 1OW-30 is best for your vehicle. However,
you can use
SAE 5W-30 if it’s going to be colder than
60°F ( 16°C) before your next oil change. When it’s
very cold, you should use
SAE 5W-30. These numbers
on an oil container show its viscosity, or thickness.
Do
not use other viscosity oils, such as SAE 20W-50.
NOTICE:
Use only engine oil with the American Petroleum
Institute Certified For Gasoline Engines
“Starburst” symbol. Failure
to use the
recommended oil can result
in engine damage not
covered
by your warranty.
GM Goodwrench@ oil meets all the requirements for
your vehicle.
If you are in an area where the temperature falls below
-20°F (-29”C), consider using either an SAE 5W-30
synthetic oil or an
SAE OW-30 oil. Both will provide
easier cold starting and better protection for your engine
at extremely low temperatures.
Page 323 of 358

Downloaded from www.Manualslib.com manuals search engine Part D: Recommended Fluids
and Lubricants
NOTE: Fluids and lubricants identified below by name,
part number or specification may be obtained from your
GM dealer.
USAGE
Engine Oil
Engine Coolant
~~
FLUIDLUBRICANT
Engine oil with the American
Petroleum Institute Certified For
Gasoline Engines “Starburst”
symbol of the proper viscosity. To
determine the preferred viscosity
for your vehicle’s engine, see
“Engine Oil” in the Index.
50/50 mixture of clean water
(preferably distilled)
and use only
GM Goodwrench’ DEX-COOL@
or Havoline’ DEX-COOL@
coolant. See “Engine Coolant” in
the Index.
USAGE
Coolant
Supplement
Sealer
Hydraulic Brake System
Power Steering System
Automatic
Transaxle
Key Lock
Cylinders
Windshield
Washer Solvent
FLUIDLUBRICANT
GM Part No. 3634621 or
equivalent with a complete flush
and refill.
Delco Supreme 11
’ Brake Fluid
(GM Part No. 12377967 or
equivalent DOT-3 brake fluid).
GM Power Steering Fluid
(GM
Part No. 1052884 - 1 pint,
1050017
- 1 quart, or equivalent).
DEXR0N’-I11 Automatic
Transmission Fluid.
Multi-Purpose lubricant, Superlube’ (GM Part
No. 12346241 or
equivalent).
GM Optikleen’ Washer Solvent
(GM Part
No. 1051515)
or equivalent.
I
7-42 1 i