1997 CADILLAC SEVILLE change time

Downloaded from www.Manualslib.com manuals search engine GENERAL MOTORS, GM and the GM Emblem,
CADILLAC, the CADILLAC Emblem and the name
SEVILLE are registered trademarks of General Motors
Corporation.
This manual includes the latest
information at the time it
was printed. We rcserve the right to make changes in the
prodnct after that
tirile without further notice. For
vehicles first sold in Canada, substitute the name
"General Motors of Canada Limited" for Cadillac Motor
Car Division whenever it appears
in this manual.
Please keep
this manual in your Cadillac. so it will be
there if you ever need it when you're on the road. If you
scll the vehicle, please leave this manual in it so the new
owner can use it.
WE SUPPORT VOLUNTARY TECHNICIAN
CERTIFICATION THROUGtd
AUTOMOTIVE
Flaton?l Institute for
SERVICE EXCELLENCE
We support voluntary
technician certification.
Aux propriitaircs canadiens: Vous pouvez vow
procurer un exernplaire de ce guide en franpis chez
votre concessionaire
ou au:
DGN Marketing Services Ltd.
1500 Bonhill Rd.
Mississauga. Ontario
L5T 1C7
4
1

Downloaded from www.Manualslib.com manuals search engine This section tells you about the power seats -- how to
adjust them, and also about reclining front seatbacks,
lumbar adjustments, heated seats and head restraints.
The power seat controls are located
on the outboard side
of the front seat cushion.
0 Move the front of the control in the direction of the
arrows to adjust the front portion of the cushion up
or down.
Move
the rear of the control in the direction of the
arrows
to adjust the rear portion of the cushion up
or down.
@ Lift up or push down on both outer arrows at the
same time
to move the entire seat up or down.
0 To move the whole seat forward or backward, slide
the control in the direction of the center arrow.
The lumbar control is
located on the outboard side
of each front seat. It
provides additional
support
to your lower back and it
works independently
of the
other seat controls. Use the
power seat control first
to
get the proper position.
Then proceed with the
lumbar adjustment.
To reshape the lower seatback, press the lumbar control
forward to increase support and rearward to decrease
support. Press the control up or down to raise or lower
the support mechanism.
Keep in mind that
as your seating position changes, as it
may during long trips,
so should the position of your
lumbar support. Adjust the seat
as needed.

Downloaded from www.Manualslib.com manuals search engine This device, complies with Part 15 of the FCC Rules.
Operation
is subject to the following two conditions:
( 1) this device may not cause harmful interference.
and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
This device complies with
RSS-210 of Industry and
Science Canada. Operation
is subject to the following
two conditions:
( 1 ) this device may not cause
interference, and
(2) this device must accept any
interference received, including interference that may
cause undesired operation
of the device.
Changes or modifications
to this system by other than
an authorized service facility could void authorization
to use this equipment.
r_l Ihe range of this system is about 10 feet (3 m). At times
you may notice
a decrease in range. This is normal for
any remote keyless entry system. If the transmitter does
not work or if you have to stand closer to your vehicle
for the transmitter to work, try this:
e Check to determine if battery replacement is
necessary. See the instructions that
follow.
Check the distance. You may be too far from your
vehicle. You may need to stand closer during rainy
or snowy wsather.
a
a
Check the location. Other vehicles or objects may
be blocking the
signal. Take a few steps to the left
or right, hold the transmitter higher, and try again.
If you‘re still having trouble, see your Cadillac
dealer or
a qualified technician for service.
& When you press this symbol to unlock the
driver’s door, the parking lamps on your vehicle will
blink twice.
(You can progmm your vehicle so the
parking lamps will
not flash. For more information,
see “Remote Confirmation” later in this section.)
Pressing
it again within five seconds will unlock the
other doors. Pressing this button will also disarm the
optional theft-deterrent system and turn on the interior
lamps at night.
When you press this symbol
to lock the doors,
the parking
lamps will blink once. (You can program
your vehicle
so the parking lamps will not flash. For
more information, see “Remote Confirmation” later
in this section.) This also arms the optional
theft-deterrent system when the ignition
is off.
-4

Downloaded from www.Manualslib.com manuals search engine If a no response was made, the KEY IN RECALL
MEMORY prompt will show next. This choice recalls
memory settings when the key is placed in your
vehicle's ignition.
A yes or no response is required.
For
a list of the other personalization features available,
see "Memory and Personalization Features" later
in
this section.
Each remote keyless entry transmitter is coded to
prevent another transmitter from unlocking your vehicle.
If a transmitter is lost or stolen. a replacement can be
purchased through your dealer. Once your dealer has
coded the new transmitter, the lost transmitter will not
unlock
your vehicle. Each vehicle can have only two
transmitters matched to
it.
Under normal use, the battery in your remote keyless
entry transmitter should last about
four years.
You can tell the battery is weak if the transmitter won't
work at the normal range in any location. If you have to
get close
to your vehicle before the transmitter works.
it's probably time to change the battery.
I NOTICE: I
When replacing the battery, use care not to touch
any
of the circuitry. Static from your body
transferred
to these surfaces may damage
the transmitter.
I. Use the round end of the door key or a coin to pry
open the transmitter.

Downloaded from www.Manualslib.com manuals search engine I NOTICE:
~
Holding your key in START for longer than
15 seconds at a time will cause your battery to
be drained much sooner. And the excessive heat
can damage your starter motor.
2. If it doesn’t start right away, hold your key in
START for about three seconds at a time until your
engine starts. Wait about
15 seconds between each
try to help avoid draining your battery.
3. If your engine still won’t start (or starts but then
stops), it could be flooded with too much gasoline.
Try pushing your accelerator pedal all the way
to the
floor and holding
it there as you hold the key in
START for about three seconds.
If the vehicle starts
briefly but then
stops again, do the same thing.
I NOTICE:
Your engine is designed to work with the
electronics in your vehicle.
If you add electrical
parts
or accessories, you could change the way
the engine operates. Before adding electrical
equipment, check with your dealer.
If you don’t,
your engine might
not perform properly.
If you ever have to have your vehicle towed, see
the part
of this manual that tells how to do it
without damaging your vehicle. See “Towing
Your Vehicle”
in the Index.

Downloaded from www.Manualslib.com manuals search engine This mirror automatically changes to reduce glare from
headlamps behind you.
A photocell on the back of the
mirror senses when it is becoming dark outside. Another
photocell built into the mirror surface senses when
headlamps
are behind you.
At night, when the glare is too high, the mirror will
gradually darken to reduce glare (this change may
take a
few
seconds). The mirror will return to its clear daytime
state when the glare is reduced. Press
the button at the base
of the mirror to turn on the
automatic feature. The button has an indicator light to
show it
is on. Press the button to turn the automatic
feature
off.

Downloaded from www.Manualslib.com manuals search engine Note to Canadian Owners: During programming, the
hand-held transmitter may stop transmitting after one
or two seconds.
If you are programming from one of
these transmitters, you should press and re-press the
button
on the hand-held transmitter every two seconds
without ever releasing the button
on the universal
transmitter. Release both buttons when the red light
on
the universal transmitter begins to flash rapidly.
Press and hold the appropriate button on the universal
transmitter. The red light comes
on while the signal is
being transmitted.
Note that the universal transmitter is disabled when the
VALET button inside the glove box is activated. For
more information, see “Security Override” earlier
in
this section.
Also note that if the hand-held transmitter appears to
program the universal transmitter but does
not open
your garage door, and
if the garage door opener was
manufactured after
1995, the garage door opener may
have a “rolling code” system.
A rolling code system
changes
the code of the garage door opener every time
you open or close the garage door.
To determine if you have this system, press the
button on the universal transmitter that you have
programmed already. If the red light on the universal
transmitter flashes rapidly
for one or two seconds
and then stops flashing, the garage door opener has
a rolling code system.

Downloaded from www.Manualslib.com manuals search engine DISPLAY ON/OFF: Pressing this button will turn off
the DIC, Electronic Climate Control (ECC). fuel data
center, the fuel gage. trip odometer- and odometer.
While
the displays are off, pressing the INFORMATION
button will only turn on the DIC. If the TRIP SET
button is pressed or the fuel level falls below fout-
e aallons (15.2 L), all of the displays will come back on.
ENG/MER You can change the display from English
(miles) to metric (kilometers) by pressing
this button.
The same button
also changes other readings (like
temperature, fuel and odometer).
TRIP SET By using this button. you can tcll how Far
you've gone since you last sct t11c TRIP SET back to
zero. To reset, press and hold thc button until XI-OS
appear. If your vehicle is domestic. the trip odonwrcr
will return to zero after 999.9 mi Ics ( I 009 km). I I' !XNII-
vehicle is Canadian, the trip odcmctcr will return lo zero
after 1 999.9 km (1,242 miles ).
INFORMATION: Pressing this button repcatccll), ivill
display the MPG AVG, MPG INST. GAL FUEL LJSED,
AVG MPH, ENGINE RPM. BATTERY VOLTS.
COOLANT TEMP and OIL LIFE LEFT.
TIMER: This feature is like a stopwatch, in that you
can clock the time it takes to get from one point to
another.
To operate, press the TIMER button
until TIMER OFF
0O:OO:OO is displayed on the DIC. Each of the fields for
the hours, minutes and seconds are two numeric digits.