Page 176 of 370

Downloaded from www.Manualslib.com manuals search engine r
f
r
f
r
r
r
A EJECT Press the upward triangle button to
remove a tape. The radio will play. Eject may be
activated with the radio
off. Cassette tapes may be
loaded with the radio
off but they will not start playing
until the PWR button is pressed.
Press PWR or turn the
ignition key off to stop the cassette tape player. The tape
will stay in the player and resume play
at the point
where it stopped.
If you leave a cassette tape in the
player while listening to the radio, it may become warm.
CLN: If this message appears on the display, the
cassette tape player needs to be cleaned. It will still play
tapes, but you should clean
it as soon as possible to
prevent damage to the tapes and player. See “Care of
Your Cassette Tape Player” in the Index. After you clean
the player, press and hold EJECT for five seconds
to
reset the CLN indicator. The radio will display --- to
show the indicator was reset.
Dolby“ Noise Reduction is manufactured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation. For information
on the compact disc player, see “Trunk
Mounted
CD Changer” later in this section.
PWRNOL: Press this knob lightly to release it from its
stored position. The system will turn on. Press the knob
again
to turn the system off. To increase volunle, turn the
knob clockwise.
Turn it counterclockwise to decrease
volume. The
volume level will appear on the display.
Page 180 of 370

Downloaded from www.Manualslib.com manuals search engine c
k
c
SOURCE: Press this button to switch from radio to
cassette tape play.
If no cassette tape is in the tape
player,
CASS appears on the display and then the radio
station appears briefly. The display then reverts back to
showing the time of day. Press this button again or
BAND to switch back to the radio.
A EJECT Press the upward triangle button to remove
a tape. The radio will play. Eject may be activated with the
radio
off if the ignition is on. Cassette tapes may be loaded
with
the radio off but they will not start playing until the
PWR button is pressed. Press
PWR or turn the ignition
key
off to stop the cassette tape player. The tape will stay
in the player and resume play at the point where it
stopped.
If you leave a cassette tape in the player while
listening to the radio,
it may become warm.
CLN: If this message appears on the display, the
cassette tape player needs to be cleaned.
It will still play
tapes, but
you should clean it as soon as possible to
prevent damage to the tapes and player. See “Care of
Your Cassette Tape Player’’ in the Index. After you clean
the player, press and hold
EJECT for five seconds to
reset the
CLN indicator. The radio will display --- to
show the indicator was reset.
Dolby@ Noise Reduction
is manufxtured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and
the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation. With the compact disc changer,
you can play up to
12 discs continuously. Normal size discs may be played
using the trays supplied in the magazine. The small discs
(8 cm) can be played only with specially designed trays.
NOTICE:
Objects in the trunk which mag shift or slide
during driving could damage your
CD changer.
Protect your
CD changer by using the
convenience net whenever possible. Place large
objects in the trunk appropriately
so that they
will not come into contact with the
CD changer.
,
Page 184 of 370

Downloaded from www.Manualslib.com manuals search engine c
c1
c
P
With this feature, your vehicle will recall the latest radio
settings as adjusted the last time your vehicle was
operated. This feature allows two different drivers
to
store and recall their own radio settings. The settings
recalled by the radio are determined by which
RKE
transmitter (“1” or “2’’) was used to enter the vehicle.
The number on the back
of the RKE transmitter
corresponds
to driver 1 or to driver 2. After the unlock
button is pressed
on the RKE transmitter or the ignition
key
is placed in the ignition, the radio settings will
automatically adjust to where they were last
set. The
settings can also be changed
by briefly pressing the
memory seat buttons 1 or
2 located on the driver’s door.
Your Cadillac has
a “built-in“ theft-deterrent feature on
each radio that is automatic -- there is no programming
required. The radio in your Cadillac cannot be used in
any other vehicle besides another Cadillac if it were to
be removed.
VOLUME: Press the up
arrow lever to increase
volume and the down arrow
lever to decrease volume.
SELECT: When listening to the radio, press the up or
down arrow lever
to tune to the next or previous preset
radio station (factory presets which have not been
reprogrammed with your stations will be ignored).
When listening to a cassette tape, the up
or clown arrow
lever
can be used to SEEK forward and rearward
through the tape. Pressing the up or down arrow lever
when listening to a
CD will cause the player to go to the
next or previous selection.
3-2
Page 194 of 370

Downloaded from www.Manualslib.com manuals search engine c
c Death and injury associated with drinking and driving is
a national tragedy. It’s the number one contributor to
the highway death toll, claiming thousands of victims
every year.
c
Alcohol affects four things that anyone needs to drive
a vehicle:
c
0 Judgment
0 Muscular Coordination
Vision
0 Attentiveness.
Police records show that almost half
of all motor
vehicle-related deaths involve alcohol.
In most cases,
these deaths are the result of someone who was drinking
and driving.
In recent years, some 17,000 annual motor
vehicle-related deaths have been associated with the
use
of alcohol, with more than 3007000 people injured.
Many addts
-- by some estimates, nearly half the
adult population -- choose never to drink alcohol. so
they never drive after drinking. For persons under 21,
it’s against the law in every U.S. state to drink alcohol.
There are
good medical, psychological and
developmental reasons for these laws. The
obvious way to solve this highway safety problem
is for people never
to drink alcohol and then drive. But
what if people do?
How much is “too much” if the
driver plans to drive? It‘s a lot
less than many might
think. Although it depends on each person and situation,
here is some general information
on the problem.
The Blood Alcohol Concentration (BAC)
of someone
who is drinking depends upon four things:
a The amount of alcohol consumed
0 The drinker’s body weight
The amount of food that is consumed before and
during drinking
0 The length of time it has taken the drinker to
consume the alcohol.
According to the American Medical Association,
a
180-lb. (82 kg) person who drinks three 12-ounce
(355 ml) bottles of beer in an hour will end up with a
BAC of about 0.06 percent. The person would reach the
same BAC
by drinking three 4-ounce ( 120 ml) glasses
of wine or three mixed drinks if each had I - 1/2 ounces
(45 ml j of a liquor like whiskey, gin or vodka.
Page 234 of 370
Downloaded from www.Manualslib.com manuals search engine c
A
This light on the instrument
panel will flash, indicating
that the hazard warning
flashers are
on.
The hazard warning flashers will work once the button
is pressed in regardless
of the key position.
e
Pull out on the collar to turn the flashers off. When the
hazard warning flashers are on. the turn signals won't
work since
they are alreadv flashing.
Page 242 of 370

Downloaded from www.Manualslib.com manuals search engine c
c
A CAUTION:
A vehicle can fall from a car-carrier if it isn’t
adequately secured. This can cause
a collision,
serious personal injury and vehicle damage. The
vehicle should be tightly secured with chains or
steel cables before it
is transported.
Don’t
use substitutes (ropes, leather straps,
canvas webbing, etc.) that can be cut by sharp
edges underneath the towed vehicle. Always use
T-hooks inserted in the front T-hook
slots or
R-hooks inserted in the rear R-hook slots. Never
use J-hooks. They will damage drivetrain and
suspension components.
When your vehicle is being towed, have the ignition
key turned to the
OFF position. The steering wheel
should be clamped in a straight-ahead position, with a
clamping device designed for towing service.
Do not
use the vehicle’s steering column lock for this. The
transaxle should be in
NEUTRAL (N) and the parking
brake released.
Don’t have your vehicle towed
on the drive wheels
unless
you must. If the vehicle must be towed on the
drive wheels, be sure to follow the speed and distance
restrictions later in this section or your transaxle will be
damaged.
If these limitations must be exceeded, then the
drive wheels have to be supported
on a dolly.
Page 276 of 370
Downloaded from www.Manualslib.com manuals search engine . ..
Gasoline vapor is highly flammable. It burns
violently, and that can cause very bad injuries.
Don’t smoke
if you’re near gasoline or refueling
your vehicle. Keep sparks, flames and smoking
materials away from gasoline.
The cap is behind a hinged door on the driver’s side of
your vehicle.
located
on the optional full
console and on the Remote
Keyless Entry
(RISE)
transmitter. If your vehicle
is
not equipped with the
full console, then you must
use the RKE transmitter to
open the fuel door.
Page 307 of 370
Downloaded from www.Manualslib.com manuals search engine It’s a good idea to clean or replace the wiper blade
assembly on a regular basis or when
worn. For proper
windshield wiper blade length and type,
see “Normal
Maintenance Replacement Parts” later
in this section. To
replace the wiper blade assembly: .I. c +*.
1. Turn the ignition key to ACCESSORY and turn the
wipers on. Position the wipers
on the windshield in
the “mid” wipe position. Then with the door open,
tum the key to
OFF.
2. Insert a screwdriver into the slot as shown and press
down to release the wiper blade assembly.
3. Align the wiper arm pin with the hole on the wiper
blade assembly and snap
it into place to install.