You may also customize your vehicle to activate the
Delayed Locking function as described above, or you
may choose to completely disable the function at
all
times. If disabled, the power door locks will activate
immediately when a power door lock switch
is pressed.
The enableddisabled state of the Delayed Locking
function will be toggled when you perform the
following sequence with the doors closed and the
ignition key in the
RUN position:
Press and hold the power door unlock switch. While
holding the door unlock switch, cycle the transmission
out of and back into
PARK (P). After an initial
transmission cycle, each additional cycle will toggle the
enable/disable state of the Delayed Locking function.
During this procedure, the chime will sound, providing
you with feedback.
A single chime will be heard if the
Delayed Locking function is disabled and two chimes
will be heard
if the function is enabled. When the door
unlock switch is released, the vehicle will remain in the
most recent operating mode.
The Delayed Locking function will be enabled when
your vehicle is shipped from the factory.
Disconnecting the vehicle battery for up to a year will
not change the programmed mode of the Delayed
Locking function.
Leaving Your Vehicle
If you are leaving the vehicle, take your keys, open your
door and set the locks from inside. Then get out and
close the door. (Also see “Delayed Locking” in this
section for more information.)
Remote Keyless Entry
You can lock and unlock your doors or unlock your
trunk from about
3 feet (1 m) up to 30 feet (9 m) away
using the remote keyless entry transmitter supplied with
your vehicle.
Your remote keyless entry system operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules and with Industry and
Science Canada.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
2-9
ProCarManuals.com
Back-up Lamp
The back-up lamps are located in the trunk lid
applique. (Refer to the trunk lid applique removal
procedure earlier in this section for graphic and
further instructions.)
1. Remove the trunk lid applique.
2. Twist and pull the back-up lamp socket from the
trunk lid applique.
3. Twist and pull the bulb from the back-up
To install the new bulb:
lamp
socket.
1. Twist and push the bulb into the back-up
2. Twist and push the back-up lamp socket into the
3. Reinstall the trunk lid applique.
lamp socket.
trunk lid applique.
Dome Lamp
1. Grasp the front center and rear center positions
of the dome lamp housing and squeeze together
until the housing releases from the base plate.
A
flat-bladed screwdriver may be necessary to pry the
assembly loose.
6-35
ProCarManuals.com
