Downloaded from www.Manualslib.com manuals search engine SA3213
A
FrontB
C D
FA0014R05239F01733
R04256
R04257
SA−8
− SUSPENSION AND AXLEFRONT WHEEL ALIGNMENT (2WD)
1447 Author: Date:
1996 TOYOTA T100 (RM449U)
4. INSPECT TOE−IN
To e−in (total)
STD cabA + B: 0° ± 12’ (0° ± 0.2°)
C − D: 0 ± 2 mm (0 ± 0.08 in.)
Extra cab
P215/75 R15A + B: 0°22’ ± 12’ (−0.36° ± 0.2°)
C − D: −4.7 ± 2 mm (0.18 ± 0.08 in.)
Extra cab
P235/75 R15A + B: 0°22’ ± 12’ (0.36° ± 0.2°)
C − D: −4.9 ± 2 mm (0.19 ± 0.08 in.)
If the toe−in is not within the specification, adjust the rack end.
5. ADJUST CAMBER AND CASTER
HINT:
Try to adjust the camber and caster to center value.
If camber or caster is not within the specification, adjust by ad-
ding or removing shims on the upper suspension arm.
Shim thickness
4.0 mm (0.157 in.)1.6 mm (0.063 in.)1.2 mm (0.047 in.)
HINT:
If the steering axis inclination is not as specified after camber
and caster have been correctly adjusted, recheck the steering
knuckle and front wheel for distortion or looseness.
NOTICE:
Adjust the shim thickness to 7 mm (+4, −3), and adjust the
difference between the front and rear of the upper suspen-
sion arm shaft to within 4 mm.
If this adjustment is not possible, adjust the strut bar bush
set nut.
6. ADJUST TOE−IN
(a) Remove the boot clamps.
(b) Loosen the tie rod end lock nuts.
(c) Turn the left and right rack ends an amount to adjust the
toe−in.
HINT:
Try to adjust the toe−in to the center value.
Make sure that the length of the left and right rack ends
are the same.
Rack end difference: 3.0 mm (0.118 in.) or less
(d) Tighten the tie rod end lock nut.
Torque: 56 N·m (570 kgf·cm, 41 ft·lbf)
(e) Place the boot on the seat and install the clip.
HINT:
Make sure that the boots are not twisted.
