Downloaded from www.Manualslib.com manuals search engine PR07Z−01
R15507Matchmarks
R04434
TMC
90Bracket Center
Line
Shaft Axial
Direction
R04435
DANA
90Bracket Center
Line
Shaft Axial
Direction
− PROPELLER SHAFTPROPELLER SHAFT ASSEMBLY (2WD)
PR−9
1996 TOYOTA T100 (RM449U)
INSTALLATION
1. INSTALL PROPELLER SHAFT
(a) Remove SST from the transmission.
SST 09325−40010
(b) Insert the yoke into the transmission.
(c) Temporarily install the center support bearing with 2
mounting bolts.
HINT:
Make sure the bearing is installed with facing the drain hole
downwards.
(d) Align the matchmarks on the flanges and connect the
flanges with the 4 bolts, washers and nuts.
(e) Torque the 4 bolts.
Torque: 74 N·m (750 kgf·cm, 54 ft·lbf)
2. ADJUST CENTER SUPPORT BEARING
HINT:
With the vehicle unladen, adjust the center support bear-
ing to keep the intervals, as shown.
At the same condition, check the center line in the axial
direction. Adjust the bearing if necessary.
Check that the center line of the center bearing is set to
the center line of the bracket when the vehicle is unladen.
Adjust the bracket if necessary.
Torque the 2 bolts.
Torque: 36 N·m (370 kgf·cm, 27 ft·lbf)
