1996 PONTIAC FIREBIRD lock

6-Speed
1 3 5 R
2 4 6
This is your shift pattern.
Here’s how to operate
your transmission:
FIRST (1): Press the clutch pedal and shift into
FIRST
(1). Then, slowly let up on the clutch pedal as
you press the accelerator pedal.
You can shift into FIRST
(1) when you’re going less
than
20 mph (32 M). If you’ve come to a complete
stop and it’s hard to shift into FIRST
(1) put, the shift
THIRD(3),FOURTH(4),FIFTH(5),and SIXTH
(6): Shift into THIRD (3), FOURTH (4), FIFTH (5) and
SIXTH (6) the same way you do for SECOND (2).
Slowly let up on the clutch pedal as you press the
accelerator pedal.
To Stop: Let up on the accelerator pedal and press the
$rake pedal. Just before the vehicle stops, press the
clutch pedal and the brake pedal, and shift to neutral.
‘NEUTRAL (N): Use this position when you start or
REVERSE (R): To back up, press down the clutch
pedal and shift into REVERSE (R). Let
up on the clutch
pedal slowly while pressing the accelerator pedal.
If you
shift from SIXTH (6) into REVERSE (R) the shift lever
must be first placed in the
ITl3UTRAL (N) position
centered between
SECOND (2) and THIRD (3) prior to
shifting into REVERSE (R).
Your six-speed manual transmission has a feature that
’ ’ idle your engine.
lever in NEUTRAL
(N) and let up on the clutch. Press allows
you to safely shift into REVERSE (R) while the
the clutch pedal back down. Then shift into FIRST (1). vehicle is rolling (at less than 5 mph). You will: be
locked-out if you try to shift into REVERSE (R) while
SECOND (2): Press the clutch pedal as you let up on your vehicle is moving faster than 5 mph (8 km/h).
the accelerator pedal and shift into SECOND (2). Then,
slowly
let up on the clutch pedal as you press the If you have turned your ignition to the OFF position
accelerator pedal.
and wish to park your vehicle in, REVERSE (a), you will have to move the shift lever quickly to the right,
“crashing”through the high load spring and then into gear.
2-33
ProCarManuals.com

1. Hold the brake pedal down with your right foot and
set the parking brake.
I
2. Move the shift lever into' PARK (P) position by
holding in
the button on the lever, and push the lever
all the way toward the front
af your vehicle.
3. Move the ignition key to LOCK,
4. Remove the key and take it with you. If you can
leave your vehicle with the ignition key in your
hand, your vehicle is in PARK (PI.
Leaving Your Vehicle With the Engine
Running (Automatic Transmission
Models Only)
It can be dangerous to leave your vehicle with the
engine
running. Your vehicle could move
suddenly
if the shift lever is not fully in PARK (P)
with the parking brake firmly set. And, if you
leave the vehicle
with the engine running, it could
overheat and ev'en catch fire. You or others could
be injured. Don't
leave your vehicle with the
engine running unless you have to.
If you have to leave your vehicle with the engine
running,
be sure your vehicle is in PARK (P) and your
parking
brake is firmly set before you leave it. After
you've moved
the shift lever into the PARK (P)
position, hold, the regular brake pedal down. Then, see if
you can move the shift lever away from PARK (P)
without first pushing the button. If you can, it means
that the shift lever wasn't fully locked
into PARK (P).
2-38
ProCarManuals.com

Torque Lock (Automatic Transmission) Shifting Out of PARK (P)
If you are parlung on a hill and you don’t shift your
transmission into PARK
(P) properly, the weight of the
vehicle may put too much force on the parking pawl in
the transmission. You may find it difficult
to pull the
shift lever out of PARK (P),. This is called “torque lock.”
To prevent torque lock, set the parking brake and then
shift into
PARK (P) properly before you leave the
driver’s seat.
To find out how, see “Shifting Into
PARK (P)”
in the Index.
When you
are ready to drive, move the shift lever out of
PARK (P) before you release the parking brake.
(Automatic Transmission)
Your Pontiac has a brake-transmission shift interlock.
You have to fully apply your regular brake before
you can shift from PARK (P) when the ignition
is in
the
RUN position. See “Automatic Transmission” in
the Index.
If you cannot shift out of PARK (P), ease pressure
on
the shift lever -- push the shift lever all the way into
PARK
(P) and release the shift lever button as you
maintain brake application. Then press the shift lever
button and ‘move the shift lever into the gear you wish.
If torque lock does occur, you may need
to have another
vehicle push yours a little uphill
to take some of the
pressure from the transmission,
so you can pull the shift
lever out
of PARK (P). 1. Turn the key to the OFF position.
If
you
ever hold the brake pedal down but still can’t
shift out of PARK (P), try this:
Parking Your Vehicle 2. Apply and hold the brake.
(Manual Transmission) 3. Shift to NEUTRAL (N).
Before you get out of your vehicle, put your manual
transmission in REVERSE
(R) and firmly apply the
parking brake.
5. .Have the vehicle fixed as soon as you can.
If your vehicle is equipped to tow a trailer, see “Towing
a Trailer” in the Index.
4. Start the engine and then shift to the drive gear
you want.
2-39
ProCarManuals.com

Windows
Manual Windows
Rotate the window crank handle to open and close each
door window.
Power Windows (Option)
T
With power windows, switches on the door control each
window when the ignition is on or when
RAP is present.
(See “Retained
Accessory Power” in the Index.)
You can also open the passenger window any amount by
pressing the switch and releasing it when the window
has lowered to the position
you want.
The switch-for the driver’s window has anexpress-down
feature. Quickly press and release
the switch for the
driver’s window and
the window will lower completely.
You can also open the driver’s window any amount by
pressing the switch again while the
window is in the
express-down mode when it has lowered to
the position
you want.
Horn ..
To sound the horn, press either horn symbol on your ‘ -. ”’ .
steering wheel.
If your horn sounds two or three chirps when unlocking ,
your vehicle with the Remote Lock Control transmitter
(if
you have that option), the alarm was triggered in
while
you were away. ‘Check the vehicle before entering.
.. .., c ’ .I .. I’ .. . ..
2-42
ProCarManuals.com

Tilt Steering Wheel Turn SignaVMultifunction Lever
A tilt steering wheel allows you to adjust the steering
wheel before
you drive.
You can also raise it to the highest level to give your
legs more room when you exit and enter the vehicle.
To tilt the wheel, hold the steering wheel and pull the
lever. Move the steering wheel
to a comfortable level,
then release the lever to lock the wheel in place. The
lever on the left side of the steering column
includes your:
Turn Signal and Lane Change Indicator
e Headlamp Highkow Beam and Passing Signal
e Windshield Wipers
Windshield Washer
Cruise Control (Option)
2-43
ProCarManuals.com

Windshield Washer
At the top of the turn signal lever there’s a paddle with
the word PUSH on it. To spray washer fluid on the
windshield, just push the paddle for less than
a second.
The washer will continue to spray until you release the
paddle. The wipers will clear the window and wipe a
few more times before stopping or returning to the
previous setting. See “Windshield Washer Fluid” in
the Index.
In freezing weather, don’t use your washer until
the windshield
is warmed. Otherwise the washer
fluid can form ice
on the windshield, blocking
your vision.
Cruise Control (Option)
With cruise control, you can maintain a speed of about
25 mph (40 km/h) or more without keeping your foot on
the’ accelerator. This can really help on long trips. Cruise
control does not
work at speeds below about 25 mph
(40 km/h).
2-46
ProCarManuals.com

Headlamp Doors The headlamp doors should be open when driving in icy or snowy conditions to prevent the doors from
freezing closed and when washing the vehicle to help
clean the headlamps.
You can open the headlamp doors manually:
1. Open the hood.
2. Remove the plastic cover from the retractor
motor knob.
3. Turn the retractor motor knob counterclockwise
until the headlamp door is fully open. The knob will
get harder to turn when the headlamp door is all
the
way up.
4. Replace the plastic cover on the retractor motor knob.
To manually close the headlamp doors, turn the lampssoff
The headlamp doors are designed to open when you turn and turn the knob clockwise. If the headlamp doors aren’t
the headlamps on.and close when you turn the working properly, see your Pontiac dealer for help.
headlamps off. The headlamp doors can be opened
without turning
on the headlamps by turning the
headlamps
on, then turning in the switch back to the
parking lamps position.
ProCarManuals.com

Interior Lamps
Instrument Panel Brightness Control
This switch controls the brightness of your
instrument panel lights. Turn the switch to brighten
or
dim the lights. If you turn the switch all the way up your
courtesy lamps will come on.
Courtesy Lamps
When any door is opened, several interior lamps go on.
These lamps are courtesy lamps. They make it easier for
you to enter and leave your vehicle.
Courtesy lamps include the dome lamp and other
lamps
throughout the interior of your vehicle.
To prevent battery rundown, your interior lamps will be
disabled about
10 minutes after the ignition is turned to
OFFm The 10 minute timer will be restarted if you do any
of the following:
1. Turn the ignition on.
2. Open either door.
3.
4.
5.
Press any button on your Remote Lock
Control transmitter.
Turn the interior lamp switch from off to on.
Open the hatch.
Delayed Illumination (Option)
With delayed illumination, when you open a door, your
courtesy lamps will come
on and stay on for 25 seconds
after the doors
are closed. The 25 seconds is shortened
if the ignition is turned to
the RUN position or if the
power locks
are activated. To turn this feature on or off,
see “Feature Customization” in the Index.
Exit Lighting (Option)
With exit lighting, the interior lamps will come on when
you remove the key from the ignition to help you see
while exiting the vehicle. To turn
this feature on or off,
see “Feature Customization” in the Index.
..
ProCarManuals.com