Mode 3: Horn and LampsLamps (If you use the
transmitter to arm the system, your parking lamps will
flash and your horn will chirp twice
to verify that the
system is armed.
If you use either the power door lock
switch or passive arming, only your lamps will flash
for verification).
Mode 4: Lamps (When your vehicle arms, only your
parking lamps will flash for verification).
Driver’s Door Alarm Delay and Shock
Sensor Enable
Your vehicle comes with this feature set in Mode 4.
This means that if you open the driver’s door using
your key, the alarm will not
soand for eight seconds.
Also the sho’ck sensor, able
to detect sharp blows to
your vehicle is active. To change the factory setting, do
the following:
1.
2.
3.
Turn the parking lamps on and off.
Count the number of chimes you hear. The number of
chimes tells you which mode your vehicle is set for.
Turn the parking Imps on and off until you’hear the
number
of chimes that correspond to the mode
selection
you want.
Mode 1: Zero Del,ay and Shock Sensor Disabled (The
alarm will sound immediately if the driver’s door is
opened with your key and the shock sensor will not be
available
to measure sharp blows to your vehicle).
Mode 2: Eight Second Delay and Shock Sensor
Disabled (The alarm will sound eight seconds after the
driver’s door is opened with your key and the shock
sensor will not be available to measure sharp blows to
,
your vehicle).
Mode 3: Zero Delay and Shock Sensor Enabled (The
alarm will sound immediately after the driver’s door is
opened
with your key and the shock sensor will be
available to measure sharp blows to your vehicle).
Mode 4: Eight Second Delay and Shock Sensor Enabled
(The alarm will sound eight seconds’ after the driver’s
door is opened with your key and the shock sensor will
be available to measure sharp blows to your vehicle). :
Leaving Programming Mode
When programming is done, turn the ignition switch to
the
OW position and replace the RADIO fuse.
. ,,.
2-20
ProCarManuals.com
Daytime Running Lamps (Option)
Daytime Running Lamps (DRL) can make it easier for
others
tu see the front of your vehicle during the day.
DRL can be helpful in many different driving
conditions, but they can be especially helpful in.the
short periods after dawn and before sunset.
A light sensor on top of the instrument panel makes the
DRL work, so be sure it isn’t covered.
The
DRL system will make your front turn signal lamps
come on when:
The ignition is on,
The headlamp switch is OFF, and
The parking brake is released.
When
the DRL are on, only your front turn signal
lamps will be on. The taillamps, sidemarker and other
lamps won’t be on. Your instrument panel won’t be lit
up either.
When it’s dark enough outside, your front turn signal
lamps will
go out and your headlamps will come on.
The other lamps that come on with your headlamps will
also come on.
When it’s bright enough outside, the regular lamps will
go off, and your front turn signal lamps will come on.
As with any vehicle, you should turn on the regular
headlamp system when you need it.
Fog Lamps (Option)
Use your fog lamps for better vision in foggy or misty
conditions. Your parking lamps must be on or your fog
lamps won’t work.
SO To turn the fog lamps on, push the top of the fog
lamp switch,
Push the bottom of the switch to turn the
fog lamps off. A light on the switch will come on when
the fog
lamps are on.
Fog lamps will go off whenever your high beams come
on. When the high beams
go off, the fog lamps will
come
on again.
If your vehicle is equipped with Vehicle and Content
Theft-Deterrent System and your
fog lamp switch is
on,
the fog lamps may flash to indicate operation of
the Vehicle
and Content Theft-Deterrent System.
See “Vehicle and Content Theft-Deterrent System” in
the
Index.
2-52
ProCarManuals.com
Steering Wheel Controls (Option)
If your vehicle has this feature, you can control certain
radio functions using the buttons on
your steering wheel.
VOLUME: Press the up arrow to increase the volume
and the down arrow to decrease volume.
PLAY: Press this button to play a cassette tape or
compact disc when the radio is playing.
MUTE: Press this button to silence the system. Press it
again, or any other
radio button, to turn on the sound.
SEEK: Press the up mow to tune to the next radio
station and
the down arrow to tune to the previous radio
station. If a cassette tape or compact disc is playing, the
player will advance with the up arrow and rewind with
the down mow.
PRESET: Press this button to hear the radio stations
that
are set on your pushbuttons.
AM-F": Press this button to select AM, FM1 or €342.
If a cassette tape or compact disc is playing, the tape or
disc will stop playing and the radio will play.
UBderstanding Radio R: 3eption
FM Stereo
FM stereo will give you the best sound. But FM signals
will reach only about
10 to 40 miles ( 16 to 65 km). Tall
buildings or
hills can interfere with FM signals, causing
the sound to come and go.
AM
The range for most AM stations is greater than for FM,
especially at night. The longer range, however, can
cause stations
to interfere with each other. AM can pick
up noise horn things like storms and power lines. Try
reducing the treble to reduce this noise if you ever get it.
ProCarManuals.com
!
'The body takes about an hour to rid itself of the alcohol
,in one drink.
No amount of coffee or number of cold
'showers wlll speed that up. "I'll b'e careful'' isn't the
~~r~.-~~ ?right answer. What if there's an emergency, a need to
take sudden action, as when a child darts into the street?
A person with even a moderate BAC might not be able
to react quickly enough to avoid the collision.
There's something else about drinking and driving that
many people don't know. Medical research shows that
alcohol in
a person's system can make crash injuries
worse, especially injuries
to the brain, spinal cord or
heart. This means that when anyone who has been
drinking
-- driver or passenger -- is in a crash, that
person's chance
of being killed or permanently disabled
is higher than
if the person had not been drinking.
A CAUTION:
Drinking and then driving is very dangerous.
Your reflexes, perceptions, attentiveness and
judgment
can be affected by even a small amount
of alcohoL You can have a serious -- or even
fatal I- collision if you drive after drinking.
Please don't drink and drive
or ride with a driver
who has been drinking. Ride
home in a cab; or if
you're with a group, designate a driver who will
n'ot drink.
c
ProCarManuals.com
Remember: Anti-lock doesn’t change the time you need
to get your foot up to the brake pedal or always decrease
stopping distance.
If you get too close to the vehicle in
front
of you, you won’t have time to apply your brakes
if that vehicle sudd’enly slows or stops. Alwayssleave
enough room up ahead to stop, even
though you have
anti-lock brakes.
Using Anti-Lock
Don’t pump the brakes. Just hold the brake pedal
down and let anti-lock work for you.
You may feel
the system working,
or you may notice some noise,
but this is normal.
LOW
TRAC
When your anti-lock system
is adjusting brake pressure
to help avoid a braking skid,
this light will come
on.
See ‘‘L’ow Traction Light”
in the
Index
naction Control, System
(Option: LTl VS Engine) I
Your vehicle may have a traction control system that
limits wheel spin. This is especially usefulin slippery
road conditions.
The system operates only if it senses that
one or both of
the rear wheels are spinning or beginning
to lose traction. When
this happens, the system works the
rear brakes and reduces engine, power (by closing the
throttle and managing engine spark) to limit wheel spin.
LOW
TRAC
This light will come on
when YQLU traction control
system is limiting wheel
spin. See “Low Traction
Light”
in the Index. You
may feel or hear the system
working, but this is normal.
The traction control system may operate on dry roads
under some conditions, and you may notice a reduction in
acceleration when this happen,€, This is normal and doesn’t
mean there’s
a problem with your vehicle. Examples of
fhese conditions include a hard acceleration in a turn, or an
ProCarManuals.com
abrupt upshift or downshft. Also, when the compact spare
tire is on the rear axle,
the traction control system will
cycle and limit acceleration for about
the first 15 seconds
of driving after each engine start.
If your vehicle is in cruise control when the traction
control system begins to limit wheel spin, the cruise
control will automatically disengage. When road
conditions allow you to safely use it again, you may
re-engage the cruise control. (See “Cruise Control”
in the Index.)
TCS
OFF
When the system is on,
this warning light will
come on to let you know
if
there’s a problem with your
traction control system.
See “Traction Control
System Warning Light”
in the Index.
When this warning light is
on, the system will not limit
wheel spin. Adjust your driving accordingly.
The traction control system automatically comes on
whenever you start your vehicle.
To limit wheel spin, especially in slippery road
conditions,
you should
always leave the system on. But you
can turn the
traction control system
off if you ever need to.
(You should turn the system off if your vehicle ever
gets stuck in sand, mud, ice
or snow. See “Rocking
Your Vehicle” in the Index.)
Automatic Transmission Manual Transmission
To turn the system off, press the button located on
the center
of the console behind the shift lever
(Automatic Transmission) or in front
of the shift
boot (Manual Transmission).
The light on the button will go off, and the traction
control system warning light will come on and stay on.
4-9
ProCarManuals.com
Passing
The driver of a vehicle about to pass another on a
two-lane highway waits for just the right moment,
accelerates, moves around the vehicle ahead, then goes
back into the right lane again.
A simple maneuver?
Not necessarily! Passing another vehicle on
a two-lane
highway is a potentially dangerous move, since the
passing vehicle occupies the same lane
as oncoming
traffic for several seconds.
A miscalculation, ”an error in
judgment, or a brief surrender to frustration or anger can
suddenly put the passing driver face to face with the
worst of all traffic accidents
-- the head-on collision.
So here are some tips for passing:
0
0
Trive ahead.” Look down the road, to the sides and to
crossroads for situations that ‘might affect your passing
patterns. If you have any doubt whatsoever about.
making a successful pass, wait for a better time.
Watch for traffic signs, pavement markings
and lines.
If you can see a sign up ahead that might indicate a
turn or an intersection, delay your pass. A broken
center
line usually indicates it’s all right to pass
(providing the road ahead is clear). Never cross a solid
line on your side
of the lane or a double solid line,
even
if the road seems empty of approaching traffic.
0 Do not get too close to the vehicle you want to
pass while you’re awaiting an opportunity. For
one
thing, following too closely reduces your area of
vision, especially if you’re following a larger
vehicle. Also, you -won’t have adequate space if
the vehicle ahead suddenly slows or
stops. Keep
back a reasonable distance.
When it looks like a chance to pass is coming up,
start to accelerate but stay in the right lane and don’t
get too close. Time your move
so you will be
increasing speed as
the time comes to move into the
other lane. If the way is clear to pass, you will have
a
“running start” that more than makes up for the
distance you would lose by dropping back. And
if
something happens to cause you to cancel your pass,
you need only slow down and drop back again and
wait for another opportunity.
0 If other cars are lined up to pass a slow vehicle, wait
your turn. But take care that someone isn’t trying to
pass you as you pull out to pass the slow vehicle.
Remember to glance over your shoulder and.check
the blind spot.
. . .I . ,.
4-13
ProCarManuals.com
0
0
0
0
Check your mirrors, glance over your shoulder, and
start your left lane change signal before moving out
of the right lane to pass. When you are far enough
ahead of the passed vehicle to see its front in your
inside mirror, activate your right
lane change signal
and move back into the right lane. (Remember that
your right outside mirror
is convex. The vehicle you
just passed may seem to be farther away from you
than
L it really is,)
Try not to pass more than one vehicle at a time
on two-lane roads. Reconsider before passing the
next vehicle.
Don’t
overtake a slowly moving vehicle too rapidly.
Even though the brake lamps
are not flashing,,it may
be slowing down or starting to turn.
If you’re being passed, make it easy for the
following driver to get ahead
of you. Perhaps you
can ease a little to the right.
Loss of Control
Skidding
In a skid, a driver can lose control of the vehicle.
Defensive drivers avoid
most skids by taking reasonable
care suited to existing conditions, and by not “overdriving”\
those conditions. But skids
are always possible.
The three types of skids correspond
to your Pontiac’s
three control systems. In the braking
skid, your wheels
aren’t rolling. In the steering or cornering skid, too
much speed or steering in a curve causes tires to slip and
lose cornering force. And in the acceleration skid, too
much throttle causes the driving wheels
to spin.
A cornering skid is best handled by easing your foot off
the accelerator pedal.
If you have the traction control system, remember: It
helps avoid only the acceleration skid.
If
you do not have traction control, or if the system is
off, then an acceleration skid is also best handled by
easing your foot off the accelerator pedal.
Let’s
review what driving experts say about what E your vehicle starts to slide, ease your foot off the
happens when the
three control systems (brakes, steering accelerator
pedal and quickly steer the way you want the
and acceleration) don’t have enough friction where the vehicle to
go. If you start steering quickly enough, your
tires meet the road to do what the driver has asked. vehicle may straighten
out. Always be ready for a
constantly seek an escape route or area of less danger. second
skid if it occurs.
. .-
. -- . r- _.. In any emergency, don’t give up. Keep trying to steer and ..
ProCarManuals.com