1996 Oldsmobile Cutlass Supreme wipers

New Vehicle aBreak-In”
NOTICE:
Your modern Oldsmobile doesn’t need an
elaborate “break-in.” But
it will perform better
in the long run
if you follow these guidelines:
0
0
0
Don’t drive at any one speed -- fast or
slow
-- for the first 500 miles (804 km).
Don’t make full-throttle starts.
Avoid making hard stops for the fist
200 miles (322 km) or so. During this time
your new brake linings aren’t yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
,
Follow this breaking-in guideline every
time you get new brake linings.
Don’t tow
a trailer during break-in. See
“Towing a nailer” in the Index for
more information.
Ignition Positions
C
I
A E
With the ignition key in the ignition switch, you can turn
the switch to five positions.
ACC (A): This position lets you use things like the
radio and windshield wipers when the engine is
off. To
use ACC (Accessory), push in the key and turn it toward
you. Your steering wheel will stay locked.
I

;, :i
Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes
your:
0 Turn Signal and Lane Change Indicator
Headlamp High/Low Beam Changer
, Windshield Wipers
' Wmdshield Washer
0 Cruise Control
'.
Turn Signal and Lane Change Indicator
The turn signal has two upwardl(for right) and.twa
downward (for left) positions. These positions allow
you
to signal a turn 'or a lane change. '
To signal a turn, move the lever all the way up or down.
whep the turn is finished, the lever will return automatically.
1
A
1
cs
An arrow on the instrument
panel will flash in the
direction of the.turn or
lane change.
To signal a lane change, just raise or lower the lever
until
the arrow starts 2-0 flash. Hold it there until you
complete your lane change. The lever will return
by
itself when you release it.
2-26

.. I.
AS you signal a tm'or a lane change,;if the'arrows don't Windshield Wipers
I
To change. your headlamps
€$om
-low beam to high
beam, or-high to low, pull
the multifunction lever
all
the way toward you. Then
release
it. When the higli
beams are on,. a light on the
instrument panel also will
be 'on.
2-27

Windshield Washer
At the top of the multifunction lever, there's a paddle
with the word
PUSH on it. To spray washer fluid on the
windshield, push the paddle. The wipers will run for
several sweeps and then either stop or return to your
preset speed.
I
In freezing weather, don't use your washer until
the windshield is warmed. Otherwise the washer
fluid
can form ice on the windshield, blocking
your vision.
Cruise Control
With cruise control, you can maintain a speed of about
25 mph (40km/h) or more without keeping your foot on
the accelerator. This can really help
on long trips. Cruise
(40 km/h). %
- control does not work at speeds below about 25 mph
When you apply your brakes, the cruise control shuts
off.
2-28 ..

Electrical System Headlamp Wiring
Add-on Electrical Equipment
NOTICE:
~~
~
Don’t add anything electrical t6 ydur Oldsmobile
unless you check with your retailer first. Some
electrical equipment can damage your vehicle
and the damage wouldn’t be covered by your
warranty. Some add-on electrical equipment
can keep other components from working as
they should.
Your vehicle has an air bag system. Before attempting
to add anything electrical to your Oldsmobile, see
“Servicing Your Air Bag-Equipped Oldsmobile” in
the Index. The
headlamp wiring is protected by a circuit breaker
in
the underhood electrical center. An electrical overload
will cause the lamps to go on and off, or in some cases
to remain
off. If this happens, have your headlamp
system checked right away.
Windshield Wipers
The windshield wiper motor is protected by a circuit
breaker and a fuse. If the motor overheats due to heavy
snow, etc., the wiper will stop until the motor cools. If
the overload
is caused by some electrical problem, have
it fixed. I