1996 Mercury Sable service indicator

75
*
[LG02400(ALL)01/95]
Indicator Lights and Chimes
%*
[LG02500(ALL)04/95]
Safety Belt Warning Light and Chime
*
[LG02510(ALL)01/95]
This warning light and chime remind you to
fasten your safety belt. The following conditions
will take place:
[LG02550(ALL)02/95]
q
If the driver's safety belt is not buckled when
the key is turned to the ON position, the
light will activate for 1 minute and the chime
will sound for 4 to 8 seconds.
*
[LG02600(ALL)03/95]
q
If the driver's safety belt is buckled while the
light is on or the chime is sounding, both the
light and the chime will turn off.
[LG02650(ALL)02/95]
q
If the driver's safety belt is buckled before the
key is turned to the ON position, the light
will turn on for a short period, but the chime
will not activate.
[LG02700(ALL)02/95]
one inch art:0000107-B
Safety belt warning light
%*
[LG02900(ALL)03/95]
Brake System Warning Light
*
[LG03000(ALL)03/95]
The warning light for the brakes can show two
things Ð that the parking brake is not fully
released, or that the brake fluid level is low in
the master cylinder reservoir. If the fluid level is
low, the brake system should be checked by
your dealer or a qualified service technician.
File:fclgs.ex
Update:Tue Aug 8 11:08:13 1995

82warm up cycles without a misfire condition
occurring. A warm up cycle consists of engine
start from a cold condition (engine at ambient
temperature) and running until the engine
reaches normal operating temperature.
[LG07925(ALL)03/95]
On the fourth engine start up, the Service
Engine Soon Warning Light will turn off as soon
as the engine begins to crank. It is not necessary
to have the engine serviced.
[LG07951(ALL)11/94]
Under certain conditions, the Service Engine
Soon light may come on if the fuel cap is not
properly installed. If the Service Engine Soon
light comes on and you suspect that the fuel cap
is not properly installed, pull off the road as
soon as it is safely possible and turn off the
engine. Remove and replace the fuel cap, making
sure it is properly seated.
[LG08001(ALL)02/95]
After completing the three consecutive warm up
cycles and on the fourth engine start up, the
Service Engine Soon warning light should turn
off. If the light does not go off after the fourth
engine restart, have your vehicle serviced by
your dealer or a qualified technician.
%*
[LG08051(ALL)04/95]
Turn Signal Indicator Lights
[LG08102(ALL)04/95]
The turn signal arrow will flash to indicate the
direction in which you are going to be turning.
[LG08150(ALL)04/95]
one inch art:0010525-AFile:fclgs.ex
Update:Tue Aug 8 11:08:13 1995

83 [LG08251(ALL)11/94]
Speed Control Indicator Light
(If equipped)
[LG08301(ALL)02/95]
This light comes on when the speed control ON
switch is pressed. It turns off when the speed
control OFF switch is pressed or when the
ignition is turned to the OFF position.
[LG08351(ALL)02/95]
one inch art:0001376-A
Speed control indicator light
%*
[LG08391(ALL)02/95]
Anti-lock Brake System Warning Light
(If equipped)
*
[LG08392(ALL)01/95]
This light comes on for a few seconds when you
turn the ignition key to the START position. It
should go off shortly after the engine starts. If it
stays on longer than five (5) seconds, it indicates
that your anti-lock brake system may not be
working properly. Normal braking is not
affected unless the BRAKE system warning light
also remains on for longer than six (6) seconds.
You should have your vehicle serviced
immediately by your dealer or qualified service
technician to restore the benefits of the anti-lock
feature. SeeAnti-lock brakesin the Index for more
information.
[LG08394(ALL)03/95]
one inch art:0000674-D
Anti-lock brake system warning light
File:fclgs.ex
Update:Tue Aug 8 11:08:13 1995

90 %
*
[LG16700(ALL)04/95]
Anti-Theft Alarm Light (If equipped)
[LG16800(ALL)11/94]
This light is used when you set the anti-theft
alarm system. SeeAnti-theft systemin the Index.
[LG16825(ALL)02/95]
one inch art:0001389-A
Anti-theft alarm light
%*
[LG16950(ALL)10/94]
Overdrive Off Indicator (If equipped)
[LG16975(ALL)02/95]
This light tells you that the Overdrive Off (O/D
OFF) switch on the gearshift lever has been
pushed. When the light is on, the transaxle will
not shift into overdrive. Depressing the O/D
OFF switch located below the gearshift release
button on the floor gearshift or located on the
end of the column gearshift will return the
vehicle to ªoverdrive onº mode. The transaxle
will be in the ªoverdrive onº mode when the
vehicle is started even if the ªO/D OFFº mode
was selected when the vehicle was last shut off.
[LG17025(ALL)02/95]
If the light does not come on when the O/D
OFF switch is depressed or if the light flashes
when you are driving, have your vehicle
serviced at the first opportunity. If this condition
persists, damage could occur to the transaxle.
[LG17050(ALL)02/95]
one inch art:0001009-B
Overdrive off indicator
File:fclgs.ex
Update:Tue Aug 8 11:08:13 1995

140 [FV10802(ALL)04/95]Coded Key Anti-Theft System
[FV10804(ALL)08/95]
If your vehicle is equipped with the coded key
anti-theft system, you can only use an
electronically coded key to start the vehicle.
During each vehicle start, the coded key is
ªreadº by the anti-theft system. If the key's ID
code matches that in the anti-theft system, the
vehicle is enabled to start. If the key's ID code
does not match the anti-theft system, or if no
coded key is detected, then the vehicle is not
able to start. Your vehicle will need to be taken
to the dealership for re-initializaiton if either of
the following situations occur:
[FV10805(ALL)07/95]
q
Both supplied keys are lost or stolen.
[FV10807(ALL)07/95]
q
Only one key has been lost, but you want to
ensure the ªlostº key will not start the
vehicle. In this case, bring the remaining
key(s) to the dealer for re-programming.
[FV10808(ALL)04/95]
THEFT indicator
[FV10810(ALL)04/95]
The anti-theft indicator (THEFT) in the
instrument cluster will light for 2 seconds and
then go out when the ignition is turned to the
ON or START position. If it does not light or if
it flashes, have the system serviced by your
dealer or a qualified technician.
[FV10812(ALL)04/95]
Programming additional keys
[FV10814(ALL)04/95]
Two electronically coded keys were supplied
with your vehicle. Additional keys can be
purchased as spares, up to a total of 16 keys. To
program a new key, use a coded key and the
following procedure:
[FV10816(ALL)04/95]
1. With the coded key in the ignition, turn the
ignition from the ON to the OFF position.
[FV10820(ALL)04/95]
2. Within 15 seconds, insert the new electronic
key in the ignition and turn it to ON or
START. The key must have the correct
mechanical cut.
File:fcfvs.ex
Update:Wed Dec 20 09:39:11 1995

319
*
[SV40201(ALL)02/95]
Horizontal aim adjustment
[SV40250(ALL)04/95]
1. Open the hood and locate the horizontal
indicator and adjusting screw.
*
[SV40375(ST)04/95]
2. Use a 4mm wrench to turn the horizontal
adjusting screw until the reference mark on
the reflector extension aligns with the ª0º
reference mark on the horizontal indicator
when viewed from directly above. If the
vehicle has been in an accident requiring the
front end of the vehicle to be repaired, the
horizontal indicator should be recalibrated
by a servicing facility using theTaurus/Sable
Service Manualinstructions.
*
[SV40501(ALL)02/95]
Vertical aim adjustment
*
[SV40601(ALL)02/95]
1. With the hood open, locate the bubble level
vertical aim indicator. It is visible when
viewed from above and to the rear of the
headlamp.
*
[SV40650(ALL)02/95]
2. With the vehicle on a level surface, use a
4mm wrench to turn the vertical aim
adjustment screw (outboard screw) located
on the back of the lamp assembly clockwise
or counterclockwise until the bubble in the
spirit level is centered when viewed from
directly above the bubble.
[SV40725(ALL)04/95]
3. Close the hood.
*
[SV40750(ALL)02/95]
If the vehicle is on a downward or upward
slope of not more than1.2Ê, theVHAD's bubble
level can be used to correct for the effects of the
surface slope, provided that the slope is
accurately known.
*
[SV40775(ALL)02/95]
Each graduation of the bubble level represents
0.19Ê ofdownward or upward slope. To correct
for the effects of a surface slope, turn the
vertical aim adjustment screw until the bubble is
centered at a position corresponding to the slope
of the surface.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

356 Index
Lamps (continued)
high beams.............. 115
illuminated mirrors.......... 155
interior lamps............. 110
map lamps.............. 111
trailer................ 216
Lap belts................. 20
Lights, warning and indicator
airbag................. 79
anti-lock brakes (ABS).......... 83
anti-theft................ 90
brake................. 75
charging system............. 76
door ajar................ 79
engine oil pressure........... 77
high beam............... 78
lamp out................ 89
low fuel................ 89
low washer fluid............ 88
oil pressure............... 77
overdrive off.............. 90
safety belt............... 75
service engine soon........... 80
speed control.............. 83
turn signal indicator........... 82
Load limits
GAWR................ 209
GVWR................ 209
trailer towing............. 212
Lubricant specifications......... 331
Luggage rack.............. 163
Lug nuts
anti-theft............... 230
standard............... 227
tightening sequence.......... 228
Lumbar support pad........... 149
File:fcixs.ex
Update:Tue Aug 8 10:58:02 1995