1996 Mercury Sable service

82warm up cycles without a misfire condition
occurring. A warm up cycle consists of engine
start from a cold condition (engine at ambient
temperature) and running until the engine
reaches normal operating temperature.
[LG07925(ALL)03/95]
On the fourth engine start up, the Service
Engine Soon Warning Light will turn off as soon
as the engine begins to crank. It is not necessary
to have the engine serviced.
[LG07951(ALL)11/94]
Under certain conditions, the Service Engine
Soon light may come on if the fuel cap is not
properly installed. If the Service Engine Soon
light comes on and you suspect that the fuel cap
is not properly installed, pull off the road as
soon as it is safely possible and turn off the
engine. Remove and replace the fuel cap, making
sure it is properly seated.
[LG08001(ALL)02/95]
After completing the three consecutive warm up
cycles and on the fourth engine start up, the
Service Engine Soon warning light should turn
off. If the light does not go off after the fourth
engine restart, have your vehicle serviced by
your dealer or a qualified technician.
%*
[LG08051(ALL)04/95]
Turn Signal Indicator Lights
[LG08102(ALL)04/95]
The turn signal arrow will flash to indicate the
direction in which you are going to be turning.
[LG08150(ALL)04/95]
one inch art:0010525-AFile:fclgs.ex
Update:Tue Aug 8 11:08:13 1995

83 [LG08251(ALL)11/94]
Speed Control Indicator Light
(If equipped)
[LG08301(ALL)02/95]
This light comes on when the speed control ON
switch is pressed. It turns off when the speed
control OFF switch is pressed or when the
ignition is turned to the OFF position.
[LG08351(ALL)02/95]
one inch art:0001376-A
Speed control indicator light
%*
[LG08391(ALL)02/95]
Anti-lock Brake System Warning Light
(If equipped)
*
[LG08392(ALL)01/95]
This light comes on for a few seconds when you
turn the ignition key to the START position. It
should go off shortly after the engine starts. If it
stays on longer than five (5) seconds, it indicates
that your anti-lock brake system may not be
working properly. Normal braking is not
affected unless the BRAKE system warning light
also remains on for longer than six (6) seconds.
You should have your vehicle serviced
immediately by your dealer or qualified service
technician to restore the benefits of the anti-lock
feature. SeeAnti-lock brakesin the Index for more
information.
[LG08394(ALL)03/95]
one inch art:0000674-D
Anti-lock brake system warning light
File:fclgs.ex
Update:Tue Aug 8 11:08:13 1995

85 [LG09005(ALL)02/95]
one third page art:0001095-B
Engine coolant temperature gauge
*
[LG09100(ALL)02/95]
If, under any circumstances, the pointer moves
above the Normal band, the engine coolant is
overheating and continued operation may cause
engine damage.
*
[LG09150(ALL)01/95]
If your engine coolant overheats:
*
[LG09200(ALL)03/95]
1. Pull off the road as soon as safely possible.
*
[LG09300(ALL)01/95]
2. Turn off the engine.
*
[LG09400(ALL)11/94]
3. Let the engine cool.
*
[LG09410(ALL)04/95]
4. Check the coolant level following the
instructions on checking and adding coolant
to your engine, seeEngine Coolantin the
Index. If you do not follow these
instructions, you or others could be injured.
[LG09415(ALL)11/94]
If the coolant continues to overheat, have the
cooling system serviced.
%*
[LG09800(ALL)01/95]
Speedometer
*
[LG09900(ALL)01/95]
The speedometer tells you how many miles
(kilometers) per hour your vehicle is moving.
%*
[LG10000(ALL)01/95]
Odometer
*
[LG10100(ALL)01/95]
The odometer tells you the total number of miles
(kilometers) your vehicle has been driven.
File:fclgs.ex
Update:Tue Aug 8 11:08:13 1995

90 %
*
[LG16700(ALL)04/95]
Anti-Theft Alarm Light (If equipped)
[LG16800(ALL)11/94]
This light is used when you set the anti-theft
alarm system. SeeAnti-theft systemin the Index.
[LG16825(ALL)02/95]
one inch art:0001389-A
Anti-theft alarm light
%*
[LG16950(ALL)10/94]
Overdrive Off Indicator (If equipped)
[LG16975(ALL)02/95]
This light tells you that the Overdrive Off (O/D
OFF) switch on the gearshift lever has been
pushed. When the light is on, the transaxle will
not shift into overdrive. Depressing the O/D
OFF switch located below the gearshift release
button on the floor gearshift or located on the
end of the column gearshift will return the
vehicle to ªoverdrive onº mode. The transaxle
will be in the ªoverdrive onº mode when the
vehicle is started even if the ªO/D OFFº mode
was selected when the vehicle was last shut off.
[LG17025(ALL)02/95]
If the light does not come on when the O/D
OFF switch is depressed or if the light flashes
when you are driving, have your vehicle
serviced at the first opportunity. If this condition
persists, damage could occur to the transaxle.
[LG17050(ALL)02/95]
one inch art:0001009-B
Overdrive off indicator
File:fclgs.ex
Update:Tue Aug 8 11:08:13 1995

103 [IP08625(ALL)04/95]
OUTSIDE TEMP button
[IP08725(ALL)03/95]
When this button is pressed, the temperature of
the air outside of the vehicle will show in the
display window. If the EATC is off, the display
will go blank after 4 seconds. If the EATC is on,
the outside temperature will be shown until the
OUTSIDE Temp button is pressed a second time
or another override button is pressed.
*
[IP08825(ALL)01/95]
NOTE: The outside temperature reading is
most accurate when the vehicle is
moving. Higher readings may be
obtained when the vehicle is not
moving. The readings that you get may
not agree with temperatures given on
the radio due to differences in vehicle
and station locations.
*
[IP08850(ALL)04/95]
Service
*
[IP08875(ALL)04/95]
If your EATC is not operating as described here,
take it to your dealer to have it checked. System
diagnostics are built in which will allow your
dealer to readily identify problems that might
occur.
[IP08925(ALL)04/95]
Operating tips
[IP09025(ALL)04/95]
The following tips will help you to get the most
satisfaction from your climate control system.
[IP09125(ALL)04/95]
q
In humid weather, selectVF-DEF (front
defrost) before driving. This will help to
prevent windshield fogging. After a few
minutes of operation, switch to any desired
selection.
File:fcips.ex
Update:Wed Dec 20 09:32:19 1995

140 [FV10802(ALL)04/95]Coded Key Anti-Theft System
[FV10804(ALL)08/95]
If your vehicle is equipped with the coded key
anti-theft system, you can only use an
electronically coded key to start the vehicle.
During each vehicle start, the coded key is
ªreadº by the anti-theft system. If the key's ID
code matches that in the anti-theft system, the
vehicle is enabled to start. If the key's ID code
does not match the anti-theft system, or if no
coded key is detected, then the vehicle is not
able to start. Your vehicle will need to be taken
to the dealership for re-initializaiton if either of
the following situations occur:
[FV10805(ALL)07/95]
q
Both supplied keys are lost or stolen.
[FV10807(ALL)07/95]
q
Only one key has been lost, but you want to
ensure the ªlostº key will not start the
vehicle. In this case, bring the remaining
key(s) to the dealer for re-programming.
[FV10808(ALL)04/95]
THEFT indicator
[FV10810(ALL)04/95]
The anti-theft indicator (THEFT) in the
instrument cluster will light for 2 seconds and
then go out when the ignition is turned to the
ON or START position. If it does not light or if
it flashes, have the system serviced by your
dealer or a qualified technician.
[FV10812(ALL)04/95]
Programming additional keys
[FV10814(ALL)04/95]
Two electronically coded keys were supplied
with your vehicle. Additional keys can be
purchased as spares, up to a total of 16 keys. To
program a new key, use a coded key and the
following procedure:
[FV10816(ALL)04/95]
1. With the coded key in the ignition, turn the
ignition from the ON to the OFF position.
[FV10820(ALL)04/95]
2. Within 15 seconds, insert the new electronic
key in the ignition and turn it to ON or
START. The key must have the correct
mechanical cut.
File:fcfvs.ex
Update:Wed Dec 20 09:39:11 1995

180
*
[AS18260(ALL)01/95]
Tape error messages
*
[AS18280(ALL)01/95]
Your cassette tape player is equipped to
diagnose certain problems you may experience.
Error codes are as follows:
[AS18325(ALL)04/95]
TD E1 Ð Possible problem tape cartridge. The
cassette player will automatically eject the tape.
Insert the tape again. If the same error code
appears in the display, try a different tape. If the
problem persists, refer the problem to qualified
personnel for service.
[AS18330(ALL)04/95]
TD E2 Ð Radio cannot eject tape. If tape is not
ejected when the ªEJº button is pressed, refer
the problem to qualified personnel for service.
[AS18350(ALL)12/95]
TD E3 Ð Radio cannot insert tape properly. The
cassette player will automatically eject the tape.
Insert tape again. If the same error code appears
in the display, try a different tape. If the
problem persists, refer the problem to qualified
personnel for service.
*
[AS18500(ALL)02/95]
Tips on Caring for the Cassette Player and
Tapes
*
[AS18600(ALL)02/95]
In order to keep your cassette tape player
performing the way it was meant to, read and
follow these simple precautions:
*
[AS18700(ALL)02/95]
q
Using a Ford Cassette Cleaning Cartridge to
clean the tape player head after 10-12 hours
of play will help maintain the best playback
sound and proper tape operation.
*
[AS18800(ALL)02/95]
q
Only cassettes that are 90 minutes long or
less should be used. Tapes longer than 90
minutes are thinner and subject to breakage
or may jam the tape player mechanism.
*
[AS18900(ALL)02/95]
q
Protect cassettes from exposure to direct
sunlight, high humidity and extreme heat or
cold. If they are exposed to extreme
conditions, allow them to reach a moderate
temperature before playing.
File:fcass.ex
Update:Wed Dec 20 09:30:38 1995

189
*
[AS32344(ALL)03/95]
If play does not begin after the CD button is
pushed:
*
[AS32345(ALL)03/95]
q
The radio is not on.
[AS32346(ALL)02/95]
q
The disc magazine is not fully seated in
changer.
*
[AS32348(ALL)03/95]
q
Moisture may have condensed on the lenses
within the unit. If this occurs, remove the CD
magazine and wait approximately an hour
until the moisture evaporates.
*
[AS32350(ALL)03/95]
If the sound skips:
*
[AS32352(ALL)03/95]
q
Badly scratched discs or extremely rough
roads will cause the sound to skip. Skipping
will not damage the disc player or scratch the
discs.
*
[AS32400(ALL)02/95]
CD Error Messages
[AS32500(ALL)02/95]
Your system is equipped to diagnose certain
problems you may experience. The displayed
error codes are:
[AS32600(ALL)02/95]
NO then CDÐ Empty slot or magazine,
mechanical error, disc(s) unreadable, or
mechanism focus error. Check all discs in the
magazine for scratches and proper insertion. If
problem persists, refer problem to qualified
personnel for service.
[AS32700(ALL)02/95]
NO then DJÐ CD Changer not connected or
not communicating to audio system. Refer
problem to qualified personnel for service.
[AS32800(ALL)04/95]
TOO then HOTÐ The changer's internal
temperature is above140ÊF (60ÊC).Allow the
player to cool before operating.
File:fcass.ex
Update:Wed Dec 20 09:30:38 1995