1996 Mercury Sable buttons

173 [AS11400(ALL)02/95]
q
Using the ªTUNEº function
[AS11525(ALL)02/95]
You can change the frequency up or down
one increment at a time by pressing and
releasing either the right (
a) or left (
b) side
of the ªTUNEº or ªTUNE/DISCº button. To
change frequencies quickly, press and hold
down either the right or left side of the
button.
*
[AS11700(ALL)02/95]
q
Using the ªSEEKº function
[AS11825(ALL)02/95]
Press the right (
a) side of the ªSEEKº
button to select the next listenable station up
the frequency band. Press the left (
b) side of
the button to select the next listenable station
down the frequency band. By pressing and
holding the button, listenable stations can be
passed over to reach the desired station.
*
[AS12200(ALL)01/95]
q
Using the ªSCANº function
*
[AS12325(ALL)04/95]
Pressing the ªSCANº button will begin the
scan mode up the frequency band, stopping
on each listenable station for approximately
five seconds. The band indicator (AM, FM1,
FM2) flashes during scan operation.
*
[AS12340(ALL)02/95]
To stop the scan mode on the presently
sampled station, press the ªSCANº button
again.
*
[AS12700(ALL)02/95]
q
Setting the Station Memory Preset buttons
*
[AS12850(ALL)02/95]
Your radio is equipped with 6 station
memory buttons. These buttons can be used
to select up to 6 preset AM stations and 12
FM stations (6 in FM1 and 6 in FM2).
File:fcass.ex
Update:Wed Dec 20 09:30:38 1995

174 [AS12900(ALL)02/95]Follow the steps below to set these buttons to
the desired frequencies:
*
[AS13025(ALL)03/95]
1. Select a band, then select a frequency.
*
[AS13200(ALL)02/95]
2. Press one of the memory buttons and hold
the button until the sound returns. That
station is now held in memory on that
button.
*
[AS13300(ALL)02/95]
3. Follow the two steps above for each station
memory preset button you want to set.
[AS13510(ALL)04/95]
q
Using the Radio Set feature
[AS13515(ALL)04/95]
With Radio set, you can automatically set
strong stations into your memory buttons.
AM, FM1 and FM2 will be set sequentially.
[AS13545(ALL)04/95]
Turn the radio off with the ªVOL PUSH ONº
knob. Press and hold the ªSCANº button and
turn the radio on by pressing the ªVOL
PUSH ONº knob. Continue holding the
ªSCANº button until ªRADº is shown in the
display.
[AS13550(ALL)04/95]
NOTE: If there are less than six strong stations
in the frequency band, the remaining
unfilled buttons will store the last
strong station detected on the band.
*
[AS13560(ALL)04/95]
After all stations have been filled, the radio will
begin playing the station stored on memory
button 1.
*
[AS13600(ALL)02/95]
Adjusting the tone balance and speaker
output of your radio
*
[AS13800(ALL)02/95]
q
Increasing or decreasing bass response
[AS13925(ALL)02/95]
Press the right (
a) side of the ªBASSº button
to increase bass (more ªlowsº); press the left
(
b) side of the ªBASSº button to decrease
bass (less ªlowsº).
File:fcass.ex
Update:Wed Dec 20 09:30:38 1995

181
*
[AS19000(ALL)02/95]
q
If a tape is loose inside the cassette, tighten it
before playing by putting your finger or a
pencil into one of the holes and turning the
hub until the tape is tight.
*
[AS19100(ALL)01/95]
q
Loose labels on cassette tapes can become
lodged in the mechanism. Remove any loose
label material before inserting cassette.
*
[AS19200(ALL)01/95]
q
Do not leave a tape in the cassette tape
player. High heat in the vehicle can cause the
cassette to warp.
%
*
[AS29351(ALL)02/95]
Ford 6-CD Changer
[AS29401(ALL)02/95]
The Ford 6-CD Changer is in the left of the
trunk or the right of the cargo area. It is
controlled by the audio system buttons.
*
[AS29450(ALL)02/95]
Loading Instructions
[AS29500(ALL)04/95]
1. Open the cover door. Open Compact Disc
Changer trunk unit by sliding door to the
front (sedan) or rear (wagon) (Figure 1).
[AS29550(ALL)04/95]
one third page art:0001464-A
Figure 1
[AS29601(ALL)02/95]
2. Press the orange Eject button to eject the disc
ªmagazineº (holds 6 discs) (Figure 2).
File:fcass.ex
Update:Wed Dec 20 09:30:38 1995