1996 FORD TAURUS light

113 %
*
[IP31200(ALL)04/95]
Cleaning the Interior Lamps
*
[IP31300(ALL)04/95]
Your interior dome lamps and map lamps are
plastic and should be cleaned with a mild
detergent diluted in water. Rinse them with clear
water.
%*
[IP31400(ALL)01/95]
Battery Saver
[IP31500(ALL)11/94]
When the ignition is turned off, the vehicle will
turn off battery voltage to the interior lights
after 40 minutes.
*
[IP31600(ALL)09/95]
This will prevent draining of the battery if those
lights have been left on inadvertently or if a
door is not completely closed. Battery voltage to
these lamps will be restored when the outside
front door handles are lifted, the keyless entry
keypad is used, the remote entry transmitter is
used, any door is opened, the trunk is opened,
or the ignition key is turned to the ON position.
%
*
[IP32600(ALL)03/95]
Clock
[IP33200(ALL)03/95]
quarter page art:0000247-G
The digital clock
*
[IP33750(ALL)05/95]
1. To set the hour, press and hold the hour
button. When the desired hour appears,
release the button.
*
[IP33850(ALL)05/95]
2. To set the minutes, press and hold the
minute button. When the desired minute
appears, release the button.
File:06fcipt.ex
Update:Tue Jan 23 08:13:16 1996
ProCarManuals.com

115
Steering Column Controls
*
[SC00400(ALL)01/95]
The controls on the steering column and wheel
are designed to give you easy access to the
controls while you are driving.
%
*
[SC00500(ALL)01/95]
The Turn Signal Lever
*
[SC00600(ALL)01/95]
You can use the turn signal lever on the left side
of the steering column to:
*
[SC00700(ALL)07/94]
q
operate the turn signals
*
[SC00800(ALL)01/95]
q
turn the high beams on/off
*
[SC00900(ALL)05/95]
q
flash the lamps
*
[SC01000(ALL)01/95]
q
turn the windshield wipers and washer
on/off
%*
[SC01100(ALL)01/95]
Turn Signals
*
[SC02201(ALL)03/95]
Move the lever up to signal a right turn. Move
it down to signal a left turn. The corresponding
indicator light in the instrument cluster will
flash.
*
[SC02401(ALL)03/95]
If the turn signal stays on after you turn, move
the lever back to the center (off) position.
*
[SC02451(ALL)08/95]
For lane changes, move the lever far enough to
signal but not to latch. The lever will return to
the off position when you release it.
%*
[SC02800(ALL)08/95]
High Beams
*
[SC03100(ALL)05/95]
To turn on the high beams, turn the headlamp
control knob to the headlamp ON position and
push the turn signal lever away from you until
it latches. When the high beams are ON, the
high beam indicator light on the instrument
panel comes on.
File:07fcsct.ex
Update:Mon Jan 22 15:52:32 1996
ProCarManuals.com

116
*
[SC03200(ALL)05/95]
To turn off the high beams, pull the lever
toward you until it latches. The high beam
indicator light turns off.
%*
[SC03300(ALL)08/95]
Flashing the Lights
*
[SC03400(ALL)06/95]
To flash the headlamps, pull the lever toward
you for a moment and then release it. The
headlamps will flash whether the headlamp
knob is in the on or off position.
[SC03450(ALL)04/95]
one third page art:0001411-B
The turn signal lever
%*
[SC03500(ALL)08/95]
Windshield Wipers and Washer
*
[SC03600(ALL)03/95]
To turn on the windshield wipers, the ignition
key must be turned to the ON or ACC position.
[SC03900(ALL)05/94]
Turn the knob on the end of the turn signal
lever away from you to activate the wipers. The
first seven detents are interval wipe positions,
the eighth detent is the LO position, and the
ninth detent is the HI position.
*
[SC04000(ALL)01/95]
To turn the wipers off, turn the knob toward
you to the OFF position.
File:07fcsct.ex
Update:Mon Jan 22 15:52:32 1996
ProCarManuals.com

121 [SC08000(ALL)11/94]
one third page art:0001399-B
The cruise control buttons on the steering wheel
*
[SC08200(ALL)08/95]
To set the cruise control:
[SC08400(ALL)11/94]
1. Press and release the ON switch. The
CRUISE indicator light in the instrument
cluster will illuminate to indicate that speed
control is in a standby mode.
*
[SC08500(ALL)08/95]
2. Accelerate to the desired speed above
30 mph (50 km/h) using the accelerator
pedal.
*
[SC08800(ALL)08/95]
3. Press the SET ACCEL switch and release it
immediately to set your speed. If you keep
this switch pressed, your speed will continue
to increase.
*
[SC08900(ALL)08/95]
4. Take your foot off the accelerator pedal.
Your vehicle will maintain the speed you set.
*
[SC09000(ALL)08/95]
If you drive up or down a steep hill, your
vehicle may momentarily slow down or speed
up, even though the speed control is on. This is
normal.
File:07fcsct.ex
Update:Mon Jan 22 15:52:32 1996
ProCarManuals.com

123 [SC09350(ALL)03/95]
NOTE: When driving uphill, especially with a
heavy load, you may notice your speed
decreasing even if you have the cruise
control set. If the speed drops more
than 8 to 14 mph (13-23 km/h) it is
normal for the automatic cruise control
feature to be cancelled. You may need
to use the accelerator pedal to help
your vehicle maintain the selected
speed when driving up steep grades.
%*
[SC09400(ALL)08/95]
Resetting the Cruise Control
*
[SC09410(ALL)08/95]
To reset the cruise control to alower speed, use
one of the following procedures:
*
[SC09415(ALL)08/95]
q
COASTÐ Press and hold the COAST switch.
Release the switch when the vehicle slows
down to the desired speed.
*
[SC09420(ALL)08/95]
q
Lightly tap the brake pedal. When the vehicle
attains the desired speed, press the SET
ACCEL switch and release it immediately.
% [SC09425(ALL)11/94]
q
TAP-DOWNÐ Press and then quickly
release the COAST switch. Each time you
ªtapº the switch, the set speed will decrease
by 1 mph (1.6 km/h). Multiple taps will
cause the set speed to decrease in increments
of 1 mph (1.6 km/h). For example, if the
current set speed is 60 mph (96 km/h) 5 taps
of the COAST switch will decrease the
vehicle speed and SET it at 55 mph
(88 km/h).
*
[SC09430(ALL)08/95]
If vehicle speed is reduced below 30 mph
(50 km/h) by any of the above methods, then
you must manually accelerate to a speed over
30 mph (50 km/h) and reset the system.
File:07fcsct.ex
Update:Mon Jan 22 15:52:32 1996
ProCarManuals.com

128 %
*
[FV04251(ALL)09/95]
Using the Keyless Entry System
(If equipped)
*
[FV04301(ALL)02/95]
If your vehicle has the keyless entry system, you
can lock or unlock the vehicle doors without
using a key. The buttons for the system are near
the outside door handle on the driver's side. See
alsoRemote Entry Systemwhich follows this
description.
[FV04351(ALL)02/95]
one third page art:0000482-C
Keyless entry buttons
*
[FV04401(ALL)02/95]
When you bought your vehicle, you were given
a computer code that operates the system for
your vehicle. For your convenience, we have
duplicated this code in two places.
*
[FV04451(ALL)09/95]
The code is:
*
[FV04501(ALL)09/95]
q
on your owner's wallet card found in the
glove compartment
*
[FV04551(ALL)02/95]
q
taped to the computer module
*
[FV04601(ALL)05/95]
When you use this entry system, the illuminated
entry system turns on the interior lights for 25
seconds and the buttons on the keypad light up
for 5 seconds. Do not push the buttons with a
key, ballpoint pen, pencil or any other hard
object. These objects could damage the buttons.
File:08fcfvt.ex
Update:Mon Jan 22 15:57:12 1996
ProCarManuals.com

130
*
[FV05301(ALL)09/95]
Do not set a code that presents the numbers in
sequential order, such as 1/2, 3/4, 5/6, 7/8, 9/0.
Studies show that people who idly press the
buttons usually press a sequential pattern. Also,
do not select a code that uses the same button
five times. Thieves can easily figure out these
types of codes.
%*
[FV05350(ALL)09/95]
Unlocking the doors with the keyless entry
system
*
[FV05401(ALL)02/95]
You must unlock the driver's door before you
unlock any of the other doors. If you let more
than five seconds pass between pressing
numbers, the system shuts down, and you have
to enter the code again. The system has shut
down if the keypad light is out. If the keyless
entry system does not work properly, use the
key or transmitter(s) to lock and unlock the
doors.
*
[FV05450(ALL)09/95]
1. To unlock the driver's door, enter the factory
code or your personal code. All codes have
five numbers. After you press the fifth
number, the driver's door unlocks.
[FV05500(ALL)04/95]
2. To unlock the passenger's door(s) and
liftgate (wagon), press the 3/4 button within
five seconds of unlocking the driver's door
or re-enter the code to open the driver's
door, then press 3/4.
[FV05525(ALL)03/95]
3. To open the trunk (sedan) or unlock the
liftgate (wagon), enter the five-digit factory
code, then press the 5/6 button within 5
seconds.
File:08fcfvt.ex
Update:Mon Jan 22 15:57:12 1996
ProCarManuals.com

135 [FV07920(ALL)04/95]
To unlock the liftgate (wagon), press the TRUNK
button. To open the liftgate, you must press the
liftgate release located above the license plate.
*
[FV07951(ALL)02/95]
Locking the doors with the remote entry
system
[FV08001(ALL)12/95]
To lock all the doors and liftgate (wagon), press
the LOCK button. This will also arm the factory
installed Anti-Theft system.
[FV08051(ALL)04/95]
If you would like a signal that the doors are
being locked, press the LOCK button again
within five seconds. If all doors and the liftgate
are completely closed, the doors and liftgate will
lock again, the horn will chirp and the external
lamps will flash. If a door or the liftgate is open
or ajar, the horn will give two short chirps
warning you that a door or the liftgate is open.
%*
[FV08100(ALL)02/95]
Remote entry personal alarm
*
[FV08151(ALL)02/95]
If you wish to activate the remote entry system
personal alarm, press the PANIC button. This
will honk the horn and flash the lights for
approximately 2 minutes 45 seconds. You can
turn it off by pressing the PANIC button again
from the transmitter or by turning the ignition
to the ON or ACCESSORY position.
*
[FV08200(ALL)02/95]
When you use the remote entry UNLOCK or
PANIC buttons, the illuminated entry system
turns on the vehicle's interior lights for 25
seconds. You can turn these lights off with the
remote entry LOCK button or by turning the
ignition to the ON or ACCESSORY position.
File:08fcfvt.ex
Update:Mon Jan 22 15:57:12 1996
ProCarManuals.com