Features
103
%*
[FV15425(ALL)05/95]
Remote Entry System (If equipped)
[FV15450(R )06/95]
If your vehicle has the remote entry system, you can lock or
unlock the vehicle doors without using a key. The remote also
has a personal alarm feature. The buttons for the system are
located on the hand held transmitter that came with your
vehicle.
[FV15650(R )06/95]
The system will work with up to four transmitters. Your vehicle
came with one transmitter. Additional transmitters can be
ordered from your dealer.
*
[FV15700(ALL)02/95]
The remote entry features only operate with the ignition in the
OFF position.
[FV15800(ALL)04/94]
7-1/2 pica art:0021159-A
The remote entry transmitter
%*
[FV15901(ALL)02/95]
Unlocking the doors with the remote entry system
*
[FV16001(ALL)02/95]
To unlock the driver's door, press the UNLOCK button.
[FV16230(R )08/94]
To unlock the other door, press the UNLOCK button a second
time, within five seconds after the first UNLOCK.
*
[FV16300(ALL)02/95]
Locking the doors with the remote entry system
[FV16425(R )03/95]
To lock both doors, press the LOCK button. This will also arm
the factory installed Anti-Theft system.
[FV16475(R )08/94]
If you would like a signal that the doors are being locked, press
the LOCK button again within five seconds. If all doors are
completely closed, the doors will lock again, the horn will chirp,
File:08unfvr.ex
Update:Wed May 1 13:48:36 1996
104and the parking lamps will flash. If a door is open or ajar, the
horn will give two short chirps warning you that a door is
open.
%*
[FV16800(ALL)02/95]
Remote entry personal alarm
*
[FV16900(ALL)02/95]
If you wish to activate the remote entry system personal alarm,
press the PANIC button. This will honk the horn and flash the
lights for approximately 2 minutes 45 seconds. You can turn it
off by pressing the PANIC button again from the transmitter or
by turning the ignition to the ON or ACCESSORY position.
*
[FV17000(ALL)02/95]
When you use the remote entry UNLOCK or PANIC buttons,
the illuminated entry system turns on the vehicle's interior
lights for 25 seconds. You can turn these lights off with the
remote entry LOCK button or by turning the ignition to the ON
or ACCESSORY position.
[FV17100(ALL)03/95]
7-1/2 pica art:0021160-A%*
[FV17200(ALL)04/95]
Arming and Disarming the Alarm System with Remote
Entry
*
[FV17350(ALL)04/95]
Your Remote Entry System will automatically arm the factory
installed Anti-Theft System when the doors are locked, and
automatically disarm it when the doors are unlocked. The
remote will also reset the anti-theft alarm (when the driver's
door is unlocked or the PANIC button is pressed on a
programmed remote entry transmitter) if it was triggered.
File:08unfvr.ex
Update:Wed May 1 13:48:36 1996
Electronic Sound Systems
129
%*
[AS29217(ALL)08/94]
Premium Stereo Cassette and Stereo
Cassette with CD DJ
*
[AS29220(ALL)08/95]
Using the Controls on Your New Radio
*
[AS29225(ALL)10/95]
How to turn the radio on and off
*
[AS29230(ALL)01/95]
Press the ªVOL/PUSHº knob to turn the radio on. Press again
to turn it off.
*
[AS29235(ALL)10/95]
How to adjust the volume
[AS29240(ALL)06/95]
Turn the ªVOL/PUSHº knob clockwise to increase the volume
and counterclockwise to decrease the volume. Bars illuminate in
the display to show relative volume level.
*
[AS29245(ALL)10/95]
NOTE: If the volume level is set above a certain listening
level when the ignition switch is turned off, when the
ignition switch is turned back on, the volume will
come back to a ªnominalº listening level. However, if
the radio power is turned off, the volume will remain
in the position it was set at when radio power was
switched off.
*
[AS29250(ALL)10/95]
Selecting the AM or FM frequency band
*
[AS29255(ALL)02/95]
Push the ªAM/FMº button to select the desired frequency band
or to stop/store cassette tape (when in cassette mode). Pushing
the button more than once will alternate between AM, FM1 and
FM2. These functions are used with the station memory buttons
described underHow to tune radio stations.
File:09unasr.ex
Update:Wed May 1 13:49:43 1996
130
%*
[AS29260(ALL)10/95]
How to tune radio stations
[AS29265(ALL)10/94]
There are four ways for you to tune in a particular station. You
can use the ªTUNEº, ªSEEKº, ªSCANº or the memory buttons.
*
[AS29270(ALL)09/95]
n
Using the ªTUNEº function
[AS29275(ALL)03/95]
You can change the frequency up or down one increment at
a time by pressing and releasing either the left (
b) or right
(
a) side of the ªTUNEº button. To change frequencies
quickly, press and hold down either the right or left side of
the button.
*
[AS29280(ALL)10/95]
Manual tuning adjusts your radio to any allowable broadcast
frequency, whether or not a station is present on that
frequency. (SeeAll About Radio Frequenciesin this section.)
*
[AS29285(ALL)10/95]
n
Using the ªSEEKº function
[AS29290(ALL)09/94]
This feature on your radio allows you to automatically select
listenable stations up or down the frequency band. Press the
right (
a) side of the ªSEEKº button to select the next
listenable station up the frequency band. Press the left (
b)
side of the button to select the next listenable station down
the frequency band. By pressing and holding the button,
listenable stations can be passed over to reach the desired
station.
*
[AS29295(ALL)01/95]
n
Using the ªSCANº function
*
[AS29305(ALL)04/95]
Pressing the ªSCANº button will begin the scan mode up
the frequency band, stopping on each listenable station for
approximately five seconds.
*
[AS29310(ALL)02/95]
To stop the scan mode on the presently sampled station,
press the ªSCANº button again.
File:09unasr.ex
Update:Wed May 1 13:49:43 1996
Electronic Sound Systems
131
*
[AS29315(ALL)01/95]
n
Setting the station MEMORY PRESET buttons
*
[AS29320(ALL)01/95]
Your radio is equipped with 6 station memory buttons.
These buttons can be used to select up to 6 preset AM
stations and 12 FM stations (6 in FM1 and 6 in FM2)
*
[AS29325(ALL)10/95]
Follow the easy steps below to set these buttons to the desired
frequencies:
*
[AS29330(ALL)10/95]1.
Select a band, then select a frequency.
*
[AS29340(ALL)10/95]2.
Press one of the memory preset buttons and hold the button
until the sound returns. That station is now held in memory
on that button.
*
[AS29345(ALL)10/95]3.
Follow the two steps above for each station memory preset
button you want to set.
*
[AS29350(ALL)01/95]
n
Using the AUTOSET feature
*
[AS29355(ALL)01/95]
With AUTOSET, you can continually set strong stations into
your memory buttons without losing your originally set
stations.
*
[AS29360(ALL)01/95]
Press the ªAUTOSETº button once. Your radio will set the
first six strong stations of the band you are in (AM, FM1, or
FM2) into the memory buttons. The display will show
ªAUTOº, then run through the frequencies setting the
memory buttons.
*
[AS29365(ALL)10/95]
NOTE: If there are fewer than five strong stations in the
frequency band, the remaining unfilled buttons will
store the last strong station detected on the band.
*
[AS29370(ALL)01/95]
When all stations are filled, the radio will begin playing the
station stored in memory button 1.
*
[AS29375(ALL)01/95]
To deactivate the Auto Memory Store mode and return to
manually-set memory button stations, press the ªAUTOSETº
button. Display will show ªAUTOº then ªOFFº.
File:09unasr.ex
Update:Wed May 1 13:49:43 1996
Electronic Sound Systems
137
[AS29735(ALL)09/94]
Ford 6-CD Changer (If equipped)
[AS29745(R )03/95]
The Ford Ranger (Regular Cab) 6-CD Changer is mounted
behind the driver's seat. The Ford Ranger (SuperCab) 6-CD
Changer is mounted on the floor near the center of the rear cab
wall. Both changers are controlled with buttons on the Audio
System.
[AS29750(ALL)10/94]
Unit Loading Instructions
[AS29755(ALL)06/95]1.
Open Compact Disc Changer unit by sliding door rearward
(Figure 1).
[AS29760(ALL)09/94]
10-1/2 pica
art:0060686-A
Figure 1
File:09unasr.ex
Update:Wed May 1 13:49:43 1996
140
*
[AS29830(ALL)01/95]
If the CD Changer is empty, ªNOº and ªDISCº will flash in the
display and radio play will continue.
*
[AS29835(ALL)02/95]
How to change the disc being played
[AS29840(ALL)10/94]
When in the CD mode, you can change discs by pressing the
right side (
a) of the ªTUNE DISCº button (to select the next
discs) or the left side (
b) of the ªTUNE DISCSº button (to
select previous discs). Play will begin on the first track of the
selected disc.
[AS29845(ALL)10/94]
If either side of the button is pressed and held, the CD Changer
will continue fast-forwarding or reversing through the discs in
the disc magazine. During these functions, the display will
indicate the disc number.
*
[AS29850(ALL)10/95]
How to change the track being played
[AS29855(ALL)04/94]
There are two ways to change the track being played. You can
use the ªSEEKº or ªSCANº buttons.
[AS29860(ALL)04/94]
n
Using the ªSEEKº function with your CD-Changer
[AS29865(ALL)10/94]
Press the right (
a) side of the ªSEEKº button to seek
forward to the next track of the current disc. After the last
track has been completed, the CD player automatically
changes to the next disc.
[AS29870(ALL)04/94]
Press the left (
b) side of the ªSEEKº button to seek to the
previous track on the current disc.
[AS29875(ALL)04/94]
n
Using the SCAN function with your CD Changer
[AS29880(ALL)10/94]
Press the ªSCANº button to move forward to the next track.
Approximately an eight-second sampling of the track will be
played before moving to the next track. The display will
indicate the disc and track number (dd-tt). At the end of the
disc, the CD Changer automatically changes to the next disc.
[AS29885(ALL)04/94]
To end the scan mode, press the ªSCANº button a second
time.
File:09unasr.ex
Update:Wed May 1 13:49:43 1996
146
*
[AS29967(R )05/95]
Midline Stereo and Stereo Cassette Radio
*
[AS29970(ALL)08/95]
Using the Controls on Your New Radio
*
[AS29972(ALL)10/95]
How to turn the radio on and off
*
[AS29973(ALL)01/95]
Press the ªVOL/PUSH ONº knob to turn the radio on. Press
again to turn it off.
*
[AS29975(ALL)10/95]
How to adjust the volume
[AS29980(ALL)06/95]
Turn the ªVOL/PUSH ONº knob clockwise to increase the
volume and counterclockwise to decrease the volume. Bars
illuminate in the display to show relative volume level.
*
[AS29985(ALL)10/95]
NOTE: If the volume level is set above a certain listening
level when the ignition switch is turned off, when the
ignition switch is turned back on, the volume will
come back to a ªnominalº listening level. However, if
the radio power is turned off, the volume will remain
in the position it was set at when radio power was
switched off.
*
[AS29990(ALL)10/95]
Selecting the AM or FM frequency band
[AS29995(ALL)10/94]
Push the ªAMº/FMª button to select the desired frequency
band or to stop/store cassette tape (when in cassette mode).
These functions are used with the station memory buttons
described underHow to tune radio stations.
%*
[AS30000(ALL)10/95]
How to tune radio stations
[AS30005(ALL)04/95]
There are four ways for you to tune in a particular station. You
can manually locate the station using the ºTUNEª button,
ºSEEKª button, ºSCANª button, or select the station by using
the memory buttons, which you can set to any desired
frequency. These four methods are described below.
File:09unasr.ex
Update:Wed May 1 13:49:43 1996