1996 FORD E SERIES length

23
*
[SR07600(BEF )05/95]
Adjust the belt so that it fits snugly and as low
as possible around the hips:
*
[SR07700(BEF )06/95]
q
If you need to lengthen the belt, unfasten it
and repeat the procedure above.
*
[SR07800(BEF )06/95]
q
If you need to shorten the belt, pull on the
loose end of the webbing.
[SR08200( E )05/95]
Safety Belt Bed/Seat Pocket
[SR08450( E )05/95]
one third page art:0020862-B
Location of the safety belt bed/seat pockets
[SR08500(BEF )05/95]
To unfasten the belt:
[SR08525(BEF )05/95]
1. Push the release button on the buckle. This
allows the tongue to unlatch from the
buckle.
[SR08550( EF )05/95]
7-1/2 pica art:0020639-D
Unfastening the outboard lap/shoulder belts
File:03ltsre.ex
Update:Wed Apr 17 08:51:22 1996

27 [SR09530(BEF )05/95]
4. When completed, the safety belt should look
like Figure 3.
[SR09535(BEF )05/95]
half page art:0060600-D%*
[SR09600(BEF )06/95]
Safety Belt Extension Assembly
*
[SR09700(BEF )06/95]
For some people, the safety belt may be too
short even when it is fully extended. You can
add about eight inches (20 cm) to the belt length
with a safety belt extension assembly (part
number 611C22). Safety belt extensions are
available at no cost from your dealer.
*
[SR09750(BEF )06/95]
Use only extensions manufactured by the same
supplier as the safety belt. Manufacturer
identification is located at the end of the
webbing on the label. Also, use the safety belt
extension only if the safety belt is too short for
you when fully extended. Do not use extension
to change the fit of the shoulder belt across the
torso.
File:03ltsre.ex
Update:Wed Apr 17 08:51:22 1996

52 [SR16440(BEF )04/95]Installing a Child Safety Seat at the Rear
Center Seating Position with Locking
Adjustable Lap Belt
[SR16450(BEF )04/95]
1. Lengthen the lap belt. To lengthen the belt,
hold the tongue so that its bottom is
perpendicular to the direction of webbing
while sliding the tongue up the webbing.
[SR16455(BEF )04/95]
2. Place the child safety seat in the center
seating position.
[SR16460(BEF )04/95]
3. Route the tongue and webbing through the
child seat according to the child seat
manufacturer's instructions.
[SR16465(BEF )04/95]
4. Insert the belt tongue into the proper buckle
for the center seating position until you hear
a snap and feel it latch. Make sure the
tongue is securely fastened to the buckle by
pulling on tongue.
[SR16470(BEF )04/95]
5. Push down on the child seat while pulling
on the loose end of the lap belt webbing to
tighten the belt.
[SR16475(BEF )04/95]
6. Before placing the child into child seat,
forcibly tilt the child seat from side-to-side
and in forward directions to ensure that the
seat is held securely in place. If the child
seat moves excessively, repeat steps 5
through 6, or properly install the child seat
in a different seating position.
File:03ltsre.ex
Update:Wed Apr 17 08:51:22 1996

190
*
[AS34700( EF )07/90]
How to set the clock
*
[AS34710( EF )06/95]
1. Turn the radio on.
*
[AS34720( EF )05/95]
2. Press and hold in the
ON/VOL-PUSH-CLOCK control.
*
[AS34730( EF )05/95]
3. While holding the
ªON/VOL-PUSH-CLOCKº button in, press
the ªTUNEº button left (S) to advance the
hours and right (+) to advance the minutes.
*
[AS34740( EF )07/90]
NOTE: The clock displays 12-hour time with
no AM/PM indications.
*
[AS35200(BEF )06/95]
Common Radio Reception Conditions
*
[AS35300(BEF )02/95]
Several conditions prevent FM reception from
being completely clear and noise-free, such as
the following:
*
[AS35400(BEF )04/95]
1. Distance/Strength
*
[AS35500(BEF )02/95]
The strength of the FM signal is directly related
to the distance the signal must travel. The
listenable range of an average FM signal is
approximately 25 miles (40 kilometers). Beyond
this distance, the radio is operating in a fringe
area and the signal becomes weaker.
*
[AS35575( EF )07/90]
NOTE: Always make sure your antenna
(Whether you have a power antenna or
a manually adjustable antenna) is fully
extended to its maximum length for
proper reception. If your antenna is not
fully extended, you may experience
signal loss while traveling in fringe
reception areas.
*
[AS35600(BEF )04/95]
2. Terrain
*
[AS35700(BEF )02/95]
The terrain (hilly, mountainous, tall buildings) of
the area over which the signal travels may
prevent the FM signal from being noise-free.
File:09ltase.ex
Update:Wed Apr 17 08:44:51 1996

269 %
*
[HS08100( ALL)03/95]
Mediation/Arbitration Program
(Canada Only)
*
[HS08200( ALL)03/95]
In those cases where you continue to feel that
the efforts by Ford and the dealer to resolve a
factory-related vehicle service concern have been
unsatisfactory, Ford of Canada participates in an
impartial third party mediation/arbitration
program administered by the Canadian Motor
Vehicle Arbitration Plan (CAMVAP).
*
[HS08300( ALL)05/95]
The CAMVAP program is a straight-forward and
relatively speedy alternative to resolve a
disagreement when all other efforts to produce a
settlement have failed. This procedure is without
cost to you and is designed to eliminate the
need for lengthy and expensive legal
proceedings.
*
[HS08400( ALL)05/95]
In the CAMVAP program, impartial third-party
Arbitrators conduct hearings at mutually
convenient times and places in an informal
environment. These impartial Arbitrators review
the positions of the parties, make decisions and,
where appropriate, render awards to resolve
disputes. CAMVAP decisions are fast, fair and
final as the arbitrator's award is binding on both
you and Ford of Canada.
*
[HS08450( ALL)05/95]
CAMVAP services are available in all territories
and provinces, except Quebec. For more
information, without charge or obligation, call
your CAMVAP Provincial Administrator directly
at 1-800-207-0685.
File:12lthse.ex
Update:Wed Apr 17 08:41:20 1996