1996 FORD E SERIES Page 3

118
*
[FV17000(BEF )02/95]
When you use the remote entry UNLOCK or
PANIC buttons, the illuminated entry system
turns on the vehicle's interior lights for 25
seconds. You can turn these lights off with the
remote entry LOCK button or by turning the
ignition to the ON or ACCESSORY position.
*
[FV17100(BEF )04/94]
quarter page art:0060566-B
%*
[FV17200( E )04/95]
Arming and Disarming the Alarm System
with Remote Entry
*
[FV17300( E )04/95]
Your Remote Entry System will automatically
arm the factory installed Anti-Theft System when
the doors are locked, and automatically disarm it
when the doors are unlocked. The remote will
also reset the anti-theft alarm (when the driver's
door is unlocked) if it was triggered.
*
[FV17400( E )04/95]
The remote entry system may not arm and
disarm non-factory installed anti-theft systems.
%*
[FV17501(BEF )02/95]
Replacing the batteries
*
[FV17601(BEF )02/95]
The remote entry transmitter is powered by two
coin type three-volt lithium 2016
batteries (included) that should last for several
years of normal use. If you notice a significant
decrease in operating range, the batteries should
be replaced. Replacement batteries can be
purchased at most pharmacies, watch stores or
at your Ford or Lincoln-Mercury dealer.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

119
*
[FV17701(BEF )02/95]
NOTE: The operating range of the remote
entry system can also be affected by
weather conditions (such as very cold
temperatures) or structures around the
vehicle (buildings, other vehicles, radio
and TV towers, etc.). Typical operating
range will allow you to be up to 33
feet (10 meters) away from your
vehicle.
*
[FV17801(BEF )03/93]
quarter page art:0020789-A
Opening the remote transmitter
*
[FV17901(BEF )02/95]
The transmitter can be snapped apart to replace
the batteries by twisting a thin coin between the
two halves of the transmitter. DO NOT TAKE
THE FRONT PART OF THE TRANSMITTER
APART. When installing the new batteries, be
sure to place the positive (+) side down as
marked. Snap the two halves back together.
*
[FV18001(BEF )02/95]
quarter page art:0020790-A
Replacing the batteries
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

123
*
[FV19250(BEF )02/95]
Windows
[FV19800( E )02/91]
Side, cargo door and rear door window
controls (If equipped)
[FV19900( E )04/89]
To open, press down on the window latches.
Then depress the levers on each side of the latch
and pull the latch upward. Move the latch out
and depress into the open position. To close,
depress the levers on each side of the latch. Lift
the latch and pull inward, then press down on
the latch to lock the levers.
[FV20000( E )04/89]
quarter page art:0020216-A
Window latch
[FV20100( E )05/95]
RWARNING
Rear doors, rear door flipper windows,
and van conversion windows, should be
closed while driving. This will prevent
exhaust fumes from being drawn into
your vehicle.
[FV20200( E )03/95]
If you can't avoid leaving one or all of the
above windows open, you should pay careful
attention to the following precautions:
[FV20300( E )03/95]
q
Adjust your climate control system to force
outside air into your vehicle.
[FV20400( E )03/95]
q
Completely open the outside air vents, if your
vehicle is so equipped.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

124
*
[FV22901(BEF )03/91]
Using the Power Windows (If equipped)
*
[FV23001(BEF )06/95]
Each door has a power control that opens and
closes the window on that door. The driver's
door has a master control switch that operates
both front door windows. You must place the
ignition switch in the ON or ACC position to
use your power window controls.
*
[FV23501(BEF )05/95]
RWARNING
Do not let children play with the power
windows. They may seriously hurt
themselves. Make sure occupants are clear
of the window(s) before closing.
*
[FV23800(BEF )05/95]
quarter page art:0020203-C
Master control switch
*
[FV24101(BEF )01/95]
Seats
%*
[FV24801(BEF )05/90]
Adjusting the Front Seat Manually
*
[FV24901(BEF )06/95]
To move the front seat forward or rearward:
*
[FV25001(BEF )06/95]
1. Find the adjustment lever at the lower left
corner of the front seat.
*
[FV25101(BEF )06/95]
2. Push the lever to the left to unlatch the seat.
*
[FV25201(BEF )06/95]
3. Move the seat to the desired position.
*
[FV25301(BEF )06/95]
4. Release the lever to latch the seat in its new
position. Make sure the seat locks securely in
place.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

126 [FV27901( E )12/91]
one third page art:0020224-CReclining bucket seat
%*
[FV31201( E )12/91]
Quick Release Rear Captain Chairs
[FV31301( E )12/91]
Second row
*
[FV31400( E )12/91]
To remove:
[FV31700( E )12/91]
1. Disengage the lap/shoulder safety belt from
the seat by inserting a key or similar device
into the slot in the detachable anchor and
lifting upward. Stow the tongue end of the
detachable anchor as shown.
[FV31901( E )02/92]
2. Pull the seat latch handle, located on the
right hand side of the seat base, and pull
seat toward the right hand side of vehicle to
disengage four pins from the floor mount.
[FV32001( E )12/91]
one third page art:0020915-A
Removing the quick release rear captains chair
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

127 [FV32101( E )12/91]
3. Remove the seat from the vehicle.
*
[FV32200( E )12/91]
To install the rear bucket seat:
[FV32400( E )12/91]
1. Lift the seat assembly into the vehicle and
position the seat to the floor mount.
[FV32600( E )02/92]
2. Engage the four seat pins into their
respective floor mount holes and push the
seat toward the left hand side of the vehicle
to fully engage.
[FV32700( E )02/92]
one third page art:0020916-B
Installing the quick release rear captains chair
[FV33001( E )12/91]
3. Push the seat latch handle downward to a
full stop. This locks the seat in position.
[FV33101( E )12/91]
4. Before you engage the safety belt, be sure it
is not twisted. Remove any twist, then insert
the tongue end of the detachable anchor into
the detachable anchor until you hear a
ªsnapº and feel the latch engage.
*
[FV33201( E )05/95]
RWARNING
Check to see that the seat is latched
securely in position. Keep floor area free
of objects that would prevent proper seat
engagement. Never attempt to adjust the
seat latch while the vehicle is in motion.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

128 [FV33400( E )12/91]
three fourths page art:0020783-B
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

129 [FV33501( E )05/95]
two third page art:0020856-C
Rear seat shoulder safety belt Ð stowage (with seat
removed)
% [FV36101( E )02/92]
Quick Release Rear Passenger Seat
Assembly
% [FV36201( E )02/95]
Three Passenger and Four Passenger Bench
and Bed Seats
[FV36300( E )01/89]
To remove the seat assembly:
*
[FV36400( E )06/92]
1. Disengage the lap/shoulder safety belt from
the seat by inserting a key or screwdriver
into the slot in the detachable anchor and
lifting upward. Stow the tongue end of the
detachable anchor as shown in the
illustration.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996