1996 FORD AEROSTAR lock

234 [RE06000(ALL)08/95]To stow underbody temporary spare tire:
[RE06100(ALL)11/89]
1. Insert lug nut wrench into the actuator hole
and turn counterclockwise until the
cable/retainer is extended for insertion into
the wheel.
*
[RE06200(ALL)10/94]
2. Install the retainer through wheel center
with valve stem facing up.
[RE06300(ALL)11/89]
3. Rotate wrench clockwise until tire is secured.
(Raising mechanism will slip.)
*
[RE06400(ALL)03/91]
4. Check for proper seating against underbody
supports and retighten if necessary.
[RE06500(ALL)11/89]
half page art:0020266-B
Spare tire Ð underbody carrier
File:12cprea.ex
Update:Tue Aug 29 17:46:27 1995

237
*
[RE15100(ALL)05/95]
RWARNING
Make sure the spare tire and jacking
equipment are stowed and secured in the
proper storage location.
%*
[RE15200(ALL)03/95]
Preparing to Change the Tire
*
[RE15250(ALL)12/91]
NOTE: To lift your vehicle by other than the
front or rear jacking points, be sure to
use only hoist adapters with a wide
contact surface.
*
[RE15325(ALL)03/95]
1. Make sure that your vehicle will not move
or roll. Put the gearshift in P (Park). Set the
parking brake and block the wheel that is
diagonally opposite the tire that you are
changing.
*
[RE15335(ALL)12/91]
NOTE: Make sure the ignition is in the OFF
position.
*
[RE15420(ALL)06/95]
When one of the back wheels is off the ground,
the transmission alone will not prevent the
vehicle from moving or slipping off the jack,
even if the vehicle is in P (Park). To prevent the
vehicle from moving when you change a tire, be
sure the parking brake is set, then block the
wheel (both directions) that is diagonally
opposite (other side and end of the vehicle) to
the tire being changed.
*
[RE15430(ALL)05/95]
RWARNING
If the vehicle slips off the jack, you or
someone else could be seriously injured.
File:12cprea.ex
Update:Tue Aug 29 17:46:27 1995

239
*
[RE16800(ALL)12/91]
3. Use the tapered end of the lug nut wrench
to unscrew wheel ornaments attached by
retaining screws. Remove any wheel trim.
Insert the tapered end of the lug nut wrench
behind wheel covers or hubcaps and twist
off.
*
[RE16900(ALL)10/89]
4. Loosen the wheel nuts by pulling up on the
handle of the lug nut wrench about one-half
turn (counterclockwise). Do not remove the
wheel lug nuts until you raise the tire off the
ground.
[RE17000(ALL)02/95]
5. Unfold the jack handle and lock into the
jack. Use the jack handle to slide the jack
under the vehicle.
%*
[RE17100(ALL)05/95]
Removing and Replacing the Tire
%*
[RE17300(ALL)06/95]
1. Positioning the jack
[RE17400(ALL)02/89]
a. To raise a front wheel, place the jack
under a horizontal portion of the
underbody member behind the wheel, as
shown.
[RE17500(ALL)01/89]
one third page art:0020293-A
Front jacking point
File:12cprea.ex
Update:Tue Aug 29 17:46:27 1995

240 [RE17600(ALL)01/89]
b. To raise a rear wheel, place the jack
under a horizontal portion of the
underbody member ahead of the wheel
as shown.
[RE17700(ALL)01/89]
one third page art:0020294-A
Rear jacking point
[RE17800(ALL)01/89]
c. Turn the jack handle clockwise until the
wheel is completely off the ground.
[RE17900(ALL)05/91]
RWARNING
Never place the jack under the rocker
panels.
*
[RE21151(ALL)10/92]
one third page art:0020939-B
File:12cprea.ex
Update:Tue Aug 29 17:46:27 1995

241
*
[RE21400(ALL)06/95]
2. Remove the lug nuts with the lug nut
wrench.
*
[RE21500(ALL)06/95]
3. Replace the flat tire with the spare tire.
*
[RE21700(ALL)06/95]
4. Thread the lug nuts on the wheel studs with
the beveled face toward the wheel. Use the
lug nut wrench to screw the lug nut snug
against the wheel but do not tighten.
*
[RE22200(ALL)01/95]
5. Lower the vehicle by turning the jack handle
counterclockwise.
*
[RE22300(ALL)06/95]
6. Remove the jack and fully tighten the lug
nuts in the order shown in the following
illustration.
%*
[RE22400(ALL)12/89]
quarter page art:0020312-B
Lug nut tightening sequence
*
[RE23400(ALL)05/95]
RWARNING
Use of wheels or lug nuts other than
original equipment could cause damage to
the wheel or mounting system and allow
the wheels to come off while the vehicle
is in motion.
*
[RE23500(ALL)07/95]
7. Replace any wheel covers, ornaments, or hub
caps that your vehicle has. Make sure that
they are screwed or snapped into place.
File:12cprea.ex
Update:Tue Aug 29 17:46:27 1995

242 [RE23625(ALL)06/95]8. Put the tire, jack, and wrench away. Make
sure jack is securely fastened so it doesn't
rattle when you drive. The carrier is
designed to hold the temporary spare which
comes with your vehicle. The stowage of a
full size tire in the spare tire carrier may
damage the tire or the vehicle. The flat full
size tire should be stowed securely in the
vehicle until it can be repaired.
*
[RE23700(ALL)06/95]
9. Unblock the wheels.
*
[RE23800(ALL)06/93]
Retighten the wheel lug nuts to the specified
torque at 500 miles (800 km) of new vehicle
operation and at intervals specified in the
Maintenance Schedule and Recordbooklet.
*
[RE24200(ALL)10/89]
Also retighten to the specified torque at 500
miles (800 km) of operation after any wheel
change or any time the lug nuts are loosened.
*
[RE24301(ALL)05/95]
RWARNING
Failure to retighten wheel lug nuts at
mileages specified could allow wheels to
come off while the vehicle is in motion.
[RE24315(ALL)02/89]
eight pica chart:0020313-AFile:12cprea.ex
Update:Tue Aug 29 17:46:27 1995

245
Customer Assistance
%*
[HS00205(ALL)06/94]
Roadside Assistance
*
[HS00210(ALL)08/95]
Ford Motor Company has set up a 24-hour,
seven-day-a-week hotline with trained operators
who put you in touch with the help you need if
you experience a problem with your vehicle.
This complimentary service is provided to you
throughout your warranty period of 3 years or
36,000 miles (60,000 km), whichever comes first.
To purchase Roadside Assistance coverages
beyond this period (available through Ford Auto
Club in the United States or Ford and
Lincoln-Mercury dealers in Canada), contact
your Ford or Lincoln-Mercury dealer.
*
[HS00215(ALL)06/94]
Roadside Assistance will cover the following:
*
[HS00220(ALL)06/94]
q
Mount your spare if you have a flat tire.
*
[HS00225(ALL)06/94]
q
Jump-start your battery if it is dead.
*
[HS00230(ALL)06/94]
q
Unlock your vehicle if you are locked out.
*
[HS00235(ALL)06/94]
q
Bring you fuel if you run out.
*
[HS00240(ALL)06/94]
q
Tow your vehicle if you are stranded. Even
non-warranty related tows, like accidents or
getting stuck in mud or snow, are covered
(some exclusions apply, such as impound
towing and repossession).
File:13cphsa.ex
Update:Tue Aug 29 17:46:53 1995

267
*
[SV02100(ALL)08/95]
q
Never get under a vehicle while it is
supported only by a jack. If you must work
under a vehicle, use safety stands.
*
[SV02200(ALL)06/95]
q
Keep all lit cigarettes and other smoking
materials away from the battery and all
fuel-related parts.
*
[SV02500(ALL)03/95]
If you disconnect the battery, the engine must
ªrelearnº its idle conditions before your vehicle
will drive properly. To find out how the engine
does this, seeBatteryin this chapter.
*
[SV02600(ALL)03/95]
Working with the engine off:
*
[SV02650(ALL)03/95]
1. Set the parking brake fully and make sure
that the gearshift is securely latched in P
(Park).
*
[SV02700(ALL)06/95]
2. Remove the key from the ignition after you
turn the engine off.
*
[SV02725(ALL)06/95]
3. Block the wheels. This will prevent your
vehicle from moving unexpectedly.
*
[SV02750(ALL)03/95]
Working with the engine on:
*
[SV02785(ALL)03/95]
1. Set the parking brake fully and make sure
that the gearshift is securely latched in P
(Park).
*
[SV02800(ALL)03/95]
2. Block the wheels. This will prevent your
vehicle from moving unexpectedly.
*
[SV02900(ALL)02/95]
RWARNING
Do not start your engine with the air
cleaner removed and do not remove it
while the engine is running.
File:15cpsva.ex
Update:Tue Aug 29 17:51:51 1995