1996 CHEVROLET TRACKER key

Warning Lights, Gages and Indicators
This part describes the warning lights and gages that
may be on your vehicle. The pictures will help you
locate them.
Warning lights and gages can signal that something is
wrong before it becomes serious enough to cause an
expensive repair or replacement. Paying attention to
your warning lights and gages could also save you or
others from injury.
Warning lights come on when there may be or is a
problem with one of your vehicle’s functions. As you
will see in the details on the next few pages, some
warning lights come on briefly when
you start the
engine just
to let you know they’re working. If you are
familiar with this section, you should not be alarmed
when this happens.
Gages can indicate when there may be or is a problem
with
one of your vehicle’s functions. Often gages and
warning lights work together to let you know when
there’s
a problem with your vehicle. When
one of the warning lights comes
on and stays on
when you
are driving, or when one of the gages shows
there may be a problem, check the section that tells YOU
what to do about it. Please follow this manual’s advice.
Waiting to
do repairs can be costly -- and even
dangerous.
So please get to know your warning lights
and gages. They’re a big help.
Safety Belt Reminder Light
When the key is turned to
ON or STAFtT, a light will
come on for about eight
seconds to remind people to
fasten their safety belts.
Unless the driver’s safety
belt is already buckled, a
chime will also sound.
2-60
ProCarManuals.com

Brake System Warning Light
Your Geo’s hydraulic brake system is divided into two
parts.
Xf one part isn’t working, the other part can still
work and stop you. For good braking, though, you need
both parts workmg well.
If the warning light comes on, there could be a brake
problem. Have your brake system inspected right away.
If the light comes on while you are driving, pull off the
road and stop carefully.
You may notice that the pedal is
harder to push. Or, the pedal may go closer to the flow.
It may take longer to stop. If the light is still on, or if the
anti-lock brake system warning light is flashing, have
the vehicle towed for service. (See “Anti-Lock Brake
System Warning Light” and
“Towing Your Vehicle”
in the
Index.)
BRAKE
United States Canada
This light should come on when you turn the ignition
key to
STAFtT. If it doesn’t corne on then, have it fixed
so it will be ready to warn you if there’s a problem.
I
/i CAUTION:
---
Your brake system may not working properly
if the brake system warning light is on. Driving
with the brake system warning light on can lead
to an accident. If the light is still on or if the
anti-lock
brake system warning light is flashing
after you’ve pulled
off the road and stopped
carefully, have the vehicle towed
for service.
When the ignition is on, the brake system warning light
will also come on when you set your parking brake. The
light will stay on if your parking brake doesn’t release
fully. If it stays on after your parking brake is fully
released, it means you have
a brake problem.
2-62
ProCarManuals.com

Anti-Lock Brake System Warning
Light (Option)
ABS
With the anti-lock brake
system, this light will come
on when you start your
engine and it will stay
on for three seconds.
That’s normal.
If the light flashes when you’re driving, you don’t have
anti-lock brakes and there could be a problem with your
regular brakes. Pull off the road and stop carefully.
You
may notice that the pedal is harder to push. Or, the pedal
may go closer to the floor. It may take longer to stop.
Have the vehicle towed for service. (See
“Towing Your
Vehicle” in the Index.)
Your regular brake system may not be working
properly if the anti-lock brake system warning light
is flashing. Driving with the anti-lock brake system
warning light flashing
can lead to an accident. After
you’ve pulled
off the road and stopped caremy,
have the vehicle towed for service.
If the anti-lock brake system warning light stays on
longer than normal after you’ve started your engine, turn
the ignition
off. Or, if the light comes on and stays on
when you’re driving, stop as soon as possible and
turn
the ignition off. Then start the engine again to reset the
system.
If the light still stays on, or comes on again
while you’re driving, your Geo needs service. If the
light
is on but not flashing and the regular brake system
warning light isn’t on,
you still have brakes, but you
don’t have anti-lock brakes.
The anti-lock brake system warning light should come
on briefly when you turn the ignitiorrkey to ON- If the
light doesn’t come on then, have it fixed so it will-be
ready to warn you
if there is a problem.
2-63
ProCarManuals.com

Anti-Lock Brake’ System Active
Light (Option)
ABS
ACTIVE
When your anti-lock system
is adjusting brake pressure
to help avoid
a braking skid,
the
anti-lock brake system
active light will
come on.
Engine Coolant Temperature Gage
This gage shows the engine
coolant temperature. If the
gage pointer
moves to the
H (red) side, your engine is
I/
Slippery road conditions may exist if this light comes
on, so adjust your driving accordingly. The light will
stay on for a few seconds after the system stops
adjusting brake pressure. It
means that your engine coolant
has overheated and
you should stop your vehicle and turn off the engine as
soon as possible.
In “Problems on the Road,” this manual shows what to
do. See
“Engine Overheating” in the Index.
The anti-lock brake system active light also comes on
briefly when you turn the ignition key to ON. If the light
doesn’t come on then, have it fixed so it will be there to
tell you when the system is active.
2-64
ProCarManuals.com

If the Light Is Flashing
The following may prevent more serious damage to
your vehicIe:
Reduce vehicle speed.
Avoid hard accelerations.
@ Avoid steep uphill grades.
If towing a trailer, reduce the amount of cargo being
hauled as soon as it is possible.
If the light stops flashing and remains on steady, see “If
the Light Is On Steady” following.
If the light continues to flash, when it is safe to do so,
stop the vehicle. Put your vehicle in PARK (P). Turn the
key
off, wait at least 10 seconds and restart the engine.
If the light remains on steady, see “If the Light Is On
Steady” following.
If the light is still flashing follow the
previous steps, and drive the vehicle to
your dealer or
qualified service center for service.
If the Light Is On Steady
You may be able to correct the emission system
malfunction
by considering the following:
Did you
just put fuel into your vehicle?
If so, reinstall the fuel cap, making sure to fully install
the cap.
The diagnostic system can determine if the fuel
cap has been left off or improperly installed. This will
allow fuel to evaporate into
the atmosphere. A few
driving trips should
turn the light off.
Did you just drive through a deep puddle of water?
If so, your electrical system may be wet. The condition
will usually be corrected when the electrical system
dries out.
A few driving trips should turn the light off.
Are you low on fuel?
As your engine starts to run out of fuel, your engine may
not run as efficiently as designed since small amounts
of
air are sucked into the fuel line causing a misfire. The
system can detect this. Adding fuel should correct
this
condition. Make sure to install the fuel cap properly. It
will take a few driving trips to turn the light off.
2-66 ProCarManuals.com

Drunken Driving
Death and injury associated with drinlung and driving is
a nationaI tragedy. It’s the number one contributor to
the highway death toll, claiming thousands
of victims
every year.
Alcohol affects four things that anyone needs to drive
a vehicle:
Judgment
0 Muscular Coordination
0 Vision
Attentiveness.
Police records
show that almost half of all motor ,
vehicle-related deaths involve alcohol. In most cases,
these deaths
are the result of someone who was drinking
and driving. In recent years, some
18,000 annual motor
vehicle-related deaths have been associated with the use
of alcohol, with more than 300,000’people
injured.
Many adults -- by some estimates, nearly half the
adult population -- choose never ta drink alcohol, so
.they never drive after drinking. For persons under 21,
it’s against the law in every U.S. state to drink alcohol.
There are good medical, psychological and
developmental
reasons for these laws.
The obvious way to solve this highway safety problem
is for people never to drink alcohol
and then drive. But
what if people
do? How much is “too much” if the
driver plans to drive? It’s a lot less than many might
think. Although it depends on each person and situation,
here
is some general information on the problem.
The Blood Alcohol Concentration
(BAC) of someone
who
is drinking depends upon four things:
The amount of alcohol consumed
The drinker’s body weight
The amount of food that is consumed before and
during
drinking
The length of time it has taken the drinker to
consume the alcohol.
According to the American Medical Association,
a
180-lb. (82 kg) person who drinks three 12-ounce
(355 m1) bottles of beer in an hour will end up with a
BAC
of about 0.06 percent. The person would reach the
same
BAC by drinking three 4-ounce (120 ml) glasses
of wine or three mixed drinks if each had 1 - 1/2 ounces
(45 ml) of a liquor like whiskey, gin or vodka.
4-2
ProCarManuals.com

Controlling your vehicle is the key to successful
off-road driving. One
of the best ways to control your
vehicle is to control your speed. Here are some things to
keep in mind.
At higher speeds:
you approach things faster and you have less time to
scan the terrain for obstacles.
0 you have less time to react.
you have more vehicle bounce when you drive
you’ll need more distance for braking, especially
over
obstacles.
since you’re on an unpaved surface.
~~
~
When you’re driving off-road, bouncing and
quick changes in direction can easily throw you
out of position. This could cause
you to lose
control and crash.
So, whether you’re driving on
or off the road,
you and your passengers should
wear safety belts.
Scanning the Terrain
Off-road driving can take you over many different
kinds
of terrain. You need to be familiar with the
terrain and its many different features. Here are some
things to consider.
Surface Conditions. Off-roading can take you over
hard-packed dirt, gravel, rocks, grass, sand, mud, snow
or ice. Each of these surfaces affects the steering,
acceleration and braking
of your vehicle in different
ways. Depending upon the kind of surface you
are
on, you may experience slipping, sliding, wheel
spinning, delayed acceleration, poor traction and
Surface Obstacles. Unseen or hidden obstacles can
be hazardous. A rock, log, hole, rut or bump can
startle you if you’re not prepared for them. Often
these obstacles are hidden
by grass, bushes, snow or
even the rise and fall of the terrain itself. Here are some
things to consider:
I longer braking distances.
0 Is the path ahead clear?
0 Will the surface texture change abruptly up ahead?
I Does the travel take you uphill or downhill? (There’s
more discussion of
these subjects later.)
4-17
1. ProCarManuals.com

2.
3.
4.
5,
Set the parking brake.
If your Geo is a four-wheel-drive vehicle, set your
manual free-wheeling hubs
to FliEE or unlock your
automatic freewheeling hubs.
See “Four-wheel
Drive” in the Index.
Turn the ignition key to ACC to unlock the
steering wheel.
Clamp the steering wheel in a straight-ahead
position, with
a clamping device designed
for towing.
Release the parking brake.
NOTICE:
Make sure that the towing speed does not
exceed 55 mph (90 km/h), or your Geo could be
badly damaged.
Towing Your Ve- ‘cle from the Front
NOTICE:
If your vehicle has automatic freewheeling hubs
or two-wheel drive, do not tow it on all four
wheels. If you do, your transmission could be
damaged.
4-44
ProCarManuals.com