1996 AUDI A4 ATQ Engine Check DTC Memory And Erase DTC Memory Workshop Manual

01-28

DTC
DTC text
Corrective action
SAE
VAG


P0441 16825 Tank ventilation
system
Throughput faulty
1) - Check Evaporative Emission (EVAP) Canister Purge Regulator Valve, perform
output Diagnostic Test Mode (DTM) Page 01
-56

P0442 16826 Tank ventilation
system
Small leak
detected
1) - Checking fuel supply and ventilation systems for leaks
P0455 16839 Tank ventilation
system
Large leak
detected 1) Repair Manual, Engine Mechanical, Repair Group 20; Evaporative Emissions
(EVAP) System Diagnosis using KLI9210 EVAP Tester, test EVAP system.
P0456 16840 Tank ventilation
system
Pinhole leak
detected
1) Repair Manual, Engine Mechanical, Repair Group 20; EVAP canister system
components, servicing; tank leak diagnostic, performing.
1) For these malfunctions, ECM does not switch on the Malfunction Indicator Lamp (MIL) unless malfunction is recognized
again after another engine start. Meaning of Malfunction Indicator Lamp (MIL) Page 01
-3 .
Pa
ge 17 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2

01-29

DTC
DTC text
Corrective action
SAE
VAG


P0501 16885 Vehicle speed signal
Implausible signal
1) - Check vehicle speed signal Page 24
-168
P0506 16890 Idle control
Engine speed below
specified value
1) - Checking throttle valve control module Page 24
-141
P0507 16891 Idle control
Engine speed above
specified value
1) - Check hose setup (intake manifold change-over valve and Secondary Air
Injection -AIR- solenoid valve); check intake system for leaks Page 24
-64

P0560 16944 Voltage supply
Implausible signal - Check voltage supply for control module Page 28
-30
P0562 16946 Voltage supply
Voltage too low

P0563 16947 Voltage supply
Voltage too high
1) For these malfunctions, ECM does not switch on the Malfunction Indicator Lamp (MIL) unless malfunction is recognized
again after another engine start. Meaning of Malfunction Indicator Lamp (MIL) Page 01
-3 .
Pa
ge 18 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2

01-30

DTC
DTC text
Corrective action
SAE
VAG


P0571 16955 Brake light switch -F-
Implausible signal - Check brake light switch and brake pedal switch Page 24
-178
P0601 16985
Control module faulty
1)
- replacing Engine Control Module (ECM) Page 24
-21
P0604 16988
Control module faulty
1)

P0605 16989
Control module faulty1)

P1102 17510 Bank 1, sensor 1, heating circuit
Short circuit to B+
1) - Check oxygen sensor heating Page 24
-116
P1105 17513 Bank 2, sensor 1, heating circuit
Short circuit to B+
1)
P1107 17515 Bank 2, sensor 1, heating circuit
Short circuit to B+1)

P1110 17518 Bank 2, sensor 2, heating circuit
Short circuit to B+1)

1) For these malfunctions, ECM does not switch on the Malfunction Indicator Lamp (MIL) unless malfunction is recognized
again after another engine start. Meaning of Malfunction Indicator Lamp (MIL) Page 01
-3 .
Pa
ge 19 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2

01-31

DTC
DTC text
Corrective action
SAE
VAG


P1111 17519 Oxygen sensor
control, bank 1
System too lean - Check oxygen sensor control before catalytic converter Page 24
-76
P1112 17520 Oxygen sensor
control, bank 1
System too rich
P1113 17521 Bank 1, sensor 1
Internal resistance too
large
1) - Next check signal wires for contact resistance => page Page 24
-90
; if there
are no contact resistances: Replace oxygen sensor
P1114 17522 Bank 2, sensor 1
Internal resistance too
large
1) - Next check signal wires for contact resistance => page Page 24
-112
; if there
are no contact resistances: Replace oxygen sensor
1) For these malfunctions, ECM does not switch on the Malfunction Indicator Lamp (MIL) unless malfunction is recognized
again after another engine start. Meaning of Malfunction Indicator Lamp (MIL) Page 01
-3 .
Pa
ge 20 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2

01-32

DTC
DTC text
Corrective action
SAE
VAG


P1115 17523 Bank 1, sensor 1, heating circuit
Short circuit to Ground (GND)
1) - Check oxygen sensor heating Page 24
-116
P1116 17524 Bank 1, sensor 1, heating circuit
Open circuit
1)

P1117 17525 Bank 2, sensor 1, heating circuit
Short circuit to Ground (GND)
1)
P1118 17526 Bank 2, sensor 1, heating circuit
Open circuit
1)

P1119 17527 Bank 2, sensor 1, heating circuit
Short circuit to Ground (GND)
1)

P1120 17528 Bank 2, sensor 1, heating circuit
Open circuit
1)

P1121 17529 Bank 2, sensor 2, heating circuit
Short circuit to Ground (GND)
1)
P1122 17530 Bank 2, sensor 2, heating circuit
Pa
ge 21 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2

Open circuit
1)

1) For these malfunctions, ECM does not switch on the Malfunction Indicator Lamp (MIL) unless malfunction is recognized
again after another engine start. Meaning of Malfunction Indicator Lamp (MIL) Page 01
-3 .
Pa
ge 22 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2

01-33

DTC
DTC text
Corrective action
SAE
VAG


P1127 17535 Bank 1, mixture
adaptation (mult.)
System too rich
1) - Road test vehicle (fuel in oil).
- Check fuel system pressure Page 24
-30
P1128 17536 Bank 1, mixture
adaptation (mult.)
System too lean
1) - Check Mass Air Flow (MAF) sensor Page 24
-56
- Check intake system for proper seal Page 24
-64
P1129 17537 Bank 2, mixture
adaptation (mult.)
System too rich
1) - Check oxygen sensor before catalytic converter Page 24
-76
P1130 17538 Bank 2, mixture
adaptation (mult.)
System too lean
1) - Check oxygen sensor behind catalytic converter Page 24
-97
- Check fuel injectors Page 24
-36

P1131 17539 Bank 2, sensor 1
Internal resistance too
large
1) - Next check signal wires for contact resistance => page Page 24
-91
; if there
are no contact resistances: Replace oxygen sensor
1) For these malfunctions, ECM does not switch on the Malfunction Indicator Lamp (MIL) unless malfunction is recognized
again after another engine start. Meaning of Malfunction Indicator Lamp (MIL) Page 01
-3 .
Note:
Pa
ge 23 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2

mult. = multiplicative, means that malfunction is valid across entire range of engine speed and engine load.
Pa
ge 24 of 52 Check DTC Memor
y (function 02
) and Erase DTC Memor
y (function 05
)
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.01.2