13-18
Drive plate
- Hold crankshaft in position using crankshaft
holder 3242 page 13
-11
CAUTION!
Part numbers are listed for reference only. Always check with your
Parts department for the latest information.
Note:
Short blocks are supplied without a bushing in the crankshaft. For
vehicles with automatic transmission, tap the bushing into place before
installing the drive plate. - Mark bolt hole pattern of drive plate and washers -1- and -2- relative to
crankshaft. Mark position of shim in front and shim behind drive plate.
- Install drive plate with 3.0 mm shim -1- (Part no. 054 105 301) or 4.0
mm shim -1- (Part no. 054 105 202), and spacer -2- (Part no. 035 105
303A).
Pa
ge 18 of 32 C
ylinder block, crankshaft and fl
ywheel, com
ponent la
yout
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.13.4
13-19
Note:
Before installing the engine, make sure that the engine-to-transmission
dowel sleeves are installed in the cylinder block flange. - Check clearance -a- between drive plate and cylinder block in three
places and calculate average value.
Dimension -a-:
Transmission 01V: 18.1-19.7 mm (0.713-0.776 in.)
- If necessary, install other shims to achieve correct clearance
dimension.
Tightening torque: 60 Nm (44 ft lb) plus 1/4-turn (90 )
Pa
ge 19 of 32 C
ylinder block, crankshaft and fl
ywheel, com
ponent la
yout
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE01.13.4
