39-44
Note:
Make sure gauge contact surface is precisely installed and free of oil. - Place end gauge on face of pinion shaft.
Note:
For transmissions with drive flange without polygon bearing ( Page 00
-
3 ) use VW385/2 centering disc instead of VW385/3 centering disc
opposite dial indicator. - Remove master gauge and install measuring mandrel into transmission
housing.
Dial indicator extension -A- = 6.5 mm long must be installed VW385/3 centering disc faces cover for final drive
- Install differential cover and tighten 4 bolts to 22 Nm (16 ft lb).
- Using adjustable ring, pull 2nd VW385/3 centering disc out as far as
possible, so mandrel can only just be turned by hand.
Pa
ge 20 of 43 Pinion shaft and rin
g gear, ad
justin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.39.5
