39-48
Checking measurement
Checking dimension "r"
- Install pinion shaft together with measured
shims S3 and S4 and turn 5 rotations in both
directions.
Note:
After removing universal mandrel, and with VW385/30 master gauge or
VW385/15 extension pin in place, check dial indicator again to see if it
indicates 0 with 2 mm preload. If not, correct adjustments. - Install universal mandrel Page 39
-43
, Determining dimension "e";
and perform check measurement.
- Read dial indicator counterclockwise (red scale).
If shims have been determined correctly, deviation "r" (as marked
on outer circumference of ring gear) should be indicated on dial
within a tolerance of 0.04 mm.
Pa
ge 25 of 43 Pinion shaft and rin
g gear, ad
justin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.39.5
