Page 25 of 27
34-65
- Make sure dowel sleeves for transmission cover -A- are installed in
transmission housing -B- (arrows).
- Install transmission cover onto transmission housing.
- Make sure dowel sleeves for cover -A- are installed in transmission
cover -B- (arrows).
- Install compression spring -C-.
- Install Torsen differential cover -A- onto transmission cover -B-.
Pa
ge 25 of 27 Transmission, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.5
Page 26 of 27
34-66
- Install rear circlip (arrow) for ball bearing onto input shaft.
- Slide ball bearing onto input shaft.
Closed side of ball cage faces toward transmission housing.
- Press in ball bearing.
- Slide thrust piece -A- of press device onto input shaft.
- Position press device behind splines for clutch plate.
- Screw in bolts -B- and tighten slightly.
The bolts bear against the indentations in thrust piece -A-.
- Press in ball bearing onto seat by alternately tightening bolts -B- (1/2-
turn at a time) until stop is reached.
Pa
ge 26 of 27 Transmission, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.5
Page 27 of 27
34-67
Notes: - Install front circlip -D- for input shaft ball bearing.
- Install dished washer -C-.
Position: convex side faces guide sleeve -B-.
Before installing guide sleeve, cover splines on input shaft with a
shrink-fit hose to protect the seal. Installing seal in guide sleeve Page 30
-20
.
- Install guide sleeve -B- for clutch release bearing.
- Install clutch release lever -A- and clutch release bearing.
Pa
ge 27 of 27 Transmission, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.5
