1995 VOLKSWAGEN GOLF Owners Manual

Tips for Operating of Cassette Player
This unit features an automatic tape type se lector and is suitable for use
with (ferric oxide), (ferro-chrome) tapes. To ensure troublefree cassette play, use only cassettes made by well-known manufacturers.
a pre-recorded cassette shown signs of defect, it is advisable to copy it onto a cassette made by a well-known manufacturer.
To prevent defects caused by the tapes themselves, it's recommended that the recording time of tapes used not exceed minutes. minute cassettes suited for use.
Never leave cassettes in the vehicle for long periods when they are exposed to very low or very high temperatures. Remember that temperatures insid e the vehicle can be considerable highe r than outside temperatures. A
l
so prevent direct exposure to sunlight. The best place to store cassettes is in
the
hinged boxes they come in o r a
Genuine Volkswagen Box with
spool
detent, which is avai lable for most
vehicles.
hours depending on the type
of tape used), the sound is distorted, it
may be because the sound head is soiled
with tape particles. These can be cleaned
away with a wet cleaning cassette. Use
only cleaning cassettes made by a
well-known manufacturer, and the
manufacturer's instruction for use.
9

Operating CD Player
ask your a use the Mode bu tton to begin in the magazine o f CO-Changer, track one. yo u CO before, the CO begin
appears in the the button which corres­ponds to the desired disc. (Butt on to Button 6 for D isc 6). The nu mbe r of th e disc appears in the buttons® to se­
press (minutes and seco nds). appears in the you
press the knob once, the indication in
the cha nge to track num ­
ber.
0 I REW EJECT
REP
1 2
4 5
appear s in the , th.e appear in the and so on.
CD scan
seconds of each track on the disc.
seconds of each track of next disc. again to
in dicator be
3
6 ®
CD to at random each track on the disc. at random each track on the next disc. a ppears in the During buttons to next track at random.

Anti - Theft
When you switch off the radio and remove the key, a red diode in the faceplate will start blinking. This means that the radio is anti-theft coded. T h e Anti-theft Coding will electronically prevent unauthorized persons from opera ting the unit it has been removed fro m the vehicle.
Whenever:
will appear in the frequency display when the radio is switch ed on. The unit will only work again if t h e correct code has been ente re d .
This code number and the radio seria l
number are on the "Radio
the electronic Jock-up
appear in the frequency display w hen the ra dio is switched on.
To cancel the el ec tronic lock-u p, you must enter the correct code number.
that the
Turn on the radio the word appears in the display.
Press the and
t o be the inp ut code number.
Use station b uttons to 4 to input the code number on your Radio
to 9 .
the code is shown on the display, press the and
appea rs in the frequency display.
Release buttons! afterward a frequency be displayed. ' The radio can now be used again.
you inadvertently input the
be shown in the display.
you input another incorrect number your radio be locked up approximately o ne ho ur. The radio will not play. Leave the radio switched on. After an hour. t he display with the number of a ttem pts goes out and you can cancel the electronic lock-up as described above.
This two attempts, one hour lock-u p applies.
Note:

WARRANTY,
to new a warranty is made during the warranty period, the unit
provided that the damage was not caused by improper treatment or attempts to repair it by non-qualified persons, and that the unit has not
a warranty
with the code and
12
Precautions
This equipment has been tested and found to with the B
installation.
This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause interference to radio communications. However, there is no guarantee that interference not occur in a installation. interference to radio or reception, which can be determined by turning the equipment oH and on, the user is encouraged to try to consuit the for
Changes or modifications not approved by the manufacturer for void the user's authority to operate the equipment.
Care of Antenna
A dirty antenna is
is washed, dry off the antenna and
This to
be
Never push in or
o r roof.
advantages of

Frequency Ranges
AM,FM
Waveband
Touch buttons
Station Selection
station tuned in before radio switched off (last station memory).
Quartz Tuning), automatic station scanning.
Cassette Player
Wear-resistant, high-performance sound head, automatic tape type recognition,
fast forward and rewind, electrical motor for cassette ejection, autorev erse, repea t function, Dolby B noise reduction system.
Display
Waveband, stereo preset station button, frequency, scan function, Dolby B repeat function, cassette player and CO-changer
Anti-glare illumination of controls from inside (night design), brightness
Anti-Theft Coding
Radio is
be reused when the correct code number is input.
Interference Suppression

Power .....................
Power Output: ........ ............. 4 x
Tape
Hz with 4 load) Tape
Speed: .... .... ........ ..........
H z to
Speaker ............ -allowable) Fast
Forward Time: ...............
Less than
Rewind Time: ........ .......... ...... Less than
Frequency Response: ...........
Stereo Separation: ........ ........ More than dB
AM radio dB
Frequency Range: ............ ....
KHz
Maximum Sensitivity: ........... (at 0.5W) 11 dB V)
dB
FM Radio Frequency
Response: ............ 17 Hz to 18 KHz 3 dB
Frequency Range: .... ........ .... 87 .5 MHz
dB ) dB V)
14

ERROR CHANGER
When a CD Changer is connected to radio, some indications can appear in Radio's see the following for meaning and in its case. an error code is and it indicates to contact to your VW see WARRANTY section in page 12.
Er1
E r2
Er 3
Er5 Memory error for
ejected by changer.
This error code appears when the
eject operation or disc select operation in the speci fie d time
because there is abnormal mechanism
Er6
H HH D isc error f or
C hange r.
adaptor is inserted with out the singl e disc.
Display shows this error code for 5 seconds and the next disc is selected
automatically.
This error code appears when
the temperature sensor ol
be in pause condit ion. To reestablish normal cond ition turn oH radio
and wait until temperature decreases.
This erro r appears when the
can not rese t focus error with sc ratched disc No Disc for error CD This error code appears when the empty
or electr ical interference . no Changer. magazine or no magaz ine is in serted in be in pause condition. To changer .
rees tablish normal operation select next Display shows this error code for 5 seconds
disc in manua l for m. and previous mode be rees tab lish automatically.
This error code appears
when the data
disc (ex. is inserted.
Display shows this error code for 5 seconds and the next disc is selected automa tically . Tape
eject
error Er8
To normal operatio n , insert
magazine at least one disc inside of it.
This error code appears in
material.
The eject operation is retried 3 times
w
ithout success. To normal operation contact to
your VW retailer.
15

When use a new disc, sometimes excess remains on edge and/or center refer to the right). When use thi s kind of disc, it can
happen that the disc is not set at correct position and the unit cannot operate. that case, use the disc after taking away excess on disc edge and/or center by slick (such as
excess on t he edge
point pen, etc .
excess on cent er