1995 RENAULT MEGANE SCENIC service

77 11 176 201APRIL 1995Edition Anglaise
General
"The repair methods given by the manufacturer in this document are based on the
technical specifications current when it was prepared.
The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories
from which his vehicles are constructed."All copyrights reserved by the Regie Nationale des Usines Renault.
Copying or translating, in part or in full, of this document or use of the service part
reference numbering system is forbidden without the prior written authority of the
Regie Nationale des Usines Renault.
Régie Nationale des Usines Renault S.A. 1995
SPECIFICATIONS
LIFTING
TOWING
LUBRICANTS CONSUMABLES
DRAINING, RE-FILLING
BA0A - BA0E - BA0F - BA0G - BA0L - BA0U
C
VALUES AND SETTINGS

Engine and peripherals
"The repair methods given by the manufacturer in this document are based on the
technical specifications current when it was prepared.
The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories
from which his vehicles are constructed."All copyrights reserved by the Regie Nationale des Usines Renault.
Copying or translating, in part or in full, of this document or use of the service part
reference numbering system is forbidden without the prior written authority of the
Regie Nationale des Usines Renault.
CRégie Nationale des Usines Renault S.A.1995
ENGINE AND PERIPHERALS
TOP AND FRONT OF ENGINE
FUEL MIXTURE
FUEL SUPPLY - PUMPS
ANTIPOLLUTION
STARTING CHARGING
IGNITION - INJECTION
COOLING - EXHAUST - FUEL TANK
77 11 176 211SEPTEMBER 1995Edition Anglaise
BA0A - BA0E - BA0F - BA0G - BA0L - BA0U
cont INJECTION (Fault finding)

FUEL MIXTURE
Specifications
12
DESCRIPTION MAKE/TYPE SPECIAL NOTES
ComputerSIEMENS FENIX 555 tracks
Injection Semi-sequential regulated multipoint injection
Ignition Static with two dual output coils
Power module integral in computer
One pinking sensor
Plugs
EYQUEM FC 52 LS
CHAMPION C10YCGap: 0.9 mm
Tightening torque: 2.5 to 3 daN.m
Air filter Replace every other oil change
Fuel filter Mounted in front of the fuel tank under the vehicle
Replace at major service
Fuel pump
WALBROSubmerged in fuel tank
Flow: 80 litres/hour minimum for regulated
pressure of 3 bars and voltage of 12 V
Pressure regulator Regulated pressure
Zero vacuum: 3 ± 0.2 bars
Vacuum of 500 mbar : 2.5 ± 0.2 bars
Solenoid injector
SIEMENSVoltage: 12 V
Resistance : 14.5 ± 1 Ω
Throttle body
PIERBURG
714 186Diameter 44 mm
Idle speed regulation stepping
motor
EGR (K7M 703) solenoid valve
PIERBURG
72213000Voltage: 12 V
Resistance : 30 ± 3 Ω
Fuel vapour recirculation
canister
Solenoid valve
CAN 10
DELCO REMY
Voltage: 12 V
Resistance : 35 ± 5 Ω
Heated oxygen sensor NGK Voltage at 850°C
Rich mixture: > 625 mvolt
Lean mixture: 0 to 80 mvolt
Tightening torque: 4.5 daN.m
Fault finding
FICHE n° 27
CODE D13
SELECTOR ON S8
Throttle potentiometer
Idle speed regulation: 5 ≤ #17 ≤ 47
Full load: 164 ≤ #17 ≤ 253
R.C.O. idle speed: 4 % ≤ #12 ≤ 14 % (K7M 720)
6 % ≤ #12 ≤ 15 % (K7M 702/703 in P and N)
10 % ≤ #12 ≤ 20 % (K7M 703 in D)
Adaptive R.C.O
idle speed: - 2.4 % ≤ #21 ≤ + 6.2%
Adaptive richness
operation: 0 ≤ #30 ≤ 208
Adaptive richness
idle speed: 100 ≤ #31 ≤ 255 (K7M 720)
104 ≤ #31 ≤ 255 (K7M 702/703)
12-4

FUEL MIXTURE
Specifications
12
DESCRIPTION MAKE/TYPE SPECIAL NOTES
ComputerSIEMENS FENIX 555 tracks
Injection Sequential regulated multipoint injection
Ignition Static with two dual output coils
Power module integral in computer
One pinking sensor
Plugs
EYQUEM C 52 LS
CHAMPION N7YCX
BOSCH W7DCOGap: 0.9 mm
Tightening torque: 2.5 to 3 daN.m
Air filter Replace every other oil change
Fuel filter Mounted in front of the fuel tank under the vehicle
Replace at major service
Fuel pump
WALBROSubmerged in fuel tank
Flow: 80 litres/hour minimum for regulated
pressure of 3 bars and voltage of 12 V
Pressure regulator WEBER
BOSCHRegulated pressure
Zero vacuum: 3 ± 0.2 bars
Vacuum of 500 mbar : 2.5 ± 0.2 bars
Solenoid injector
SIEMENSVoltage: 12 V
Resistance: 14.5 ± 1 Ω
Throttle body SOLEX
Diameter 60 mmReference: 127 F3R 751 without AC - F3R 750
Reference: 132 F3R 751 AC
Idle speed regulation solenoid
HITACHI
AESP 207-17Voltage: 12 V
Resistance: 9.5 ± 1 Ω
Fuel vapour recirculation
canister
Solenoid valve
CAN 10
DELCO REMY
Voltage: 12 V
Resistance: 35 ± 5 Ω
Heated oxygen sensor
BOSCH LSH 25Voltage at 850°C
Rich mixture: > 625 mvolt
Lean mixture: 0 to 80 mvolt
Tightening torque: 4.5 daN.m
Fault finding
FICHE n° 27
CODE D13
SELECTOR ON S8
Throttle potentiometer
Idle speed regulation: 8 ≤ #17 ≤ 38
Full load: 188 ≤ #17 ≤ 245
R.C.O. idle speed: 20 % ≤ #12 ≤ 40 % (F3R 750)
18 % ≤ #12 ≤ 38 % (F3R 751)
Adaptive R.C.O
idle speed: - 6.2 % or - 8.6 ≤ #21 ≤ + 6.2 %
Adaptive richness
operation: 82 ≤ #30 ≤ 224
Adaptive richness idle speed: 32 ≤ #31 ≤ 224
12-6

96420R3
FUEL SUPPLY
Fuel filter
13
SPECIAL TOOLING REQUIRED
Mot. 1265 Pliers for removing quick release
unions
LOCATION
The fuel filter is located under the vehicle in front
of the fuel tank.
99214R
REPLACEMENT
Replace the fuel filter at each major service.
REMOVAL
Before removing the filter, take precautions to
catch the fuel which will run out (do not clamp
the pipes as they will be damaged).
Remove the clips (1).
Disconnect the pipes with quick release unions (2)
using tool Mot. 1265.
Remove bolt (3) and remove the fuel filter.
REFITTING
Observe the direction of fuel flow (marked by an
arrow on the filter).
Reconnect the pipes by hand (it is not necessary to
use tool Mot. 1265).
Ensure the quick release unions are correctly
connected.
Refit the safety clips (1).
13-9

77 11 176 221SEPTEMBER 1995Edition Anglaise
"The repair methods given by the manufacturer in this document are based on the
technical specifications current when it was prepared.
The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories
from which his vehicles are constructed."All copyrights reserved by the Regie Nationale des Usines Renault.
Copying or translating, in part or in full, of this document or use of the service part
reference numbering system is forbidden without the prior written authority of the
Regie Nationale des Usines Renault.
CRégie Nationale des Usines Renault S.A. 1995
Transmission
CLUTCH
MANUAL GEARBOX
BA0A - BA0E - BA0F - BA0G - BA0L - BA0U
AUTOMATIC TRANSMISSION
DRIVESHAFTS

AUTOMATIC TRANSMISSION
Oil change frequencies
23
The mechanism is drained during the major service.
The oil level must be checked every 10000 miles (15 000 km) in case there is a slight oil leak.
The final drive is never drained ; it is filled for life.
The strainer is no longer replaced (NT 2261A).
Only the level may change due to a slight leak.
Oil capacity
NOTE :if the automatic transmission is replaced, only check the oil level since the transmission is supplied by
the Parts Department full of oil.
TOTAL volume
MECHANISM
5.7 l
FINAL DRIVE1 l
Fault warning light
MESSAGE FROM THE ELECTRONIC FAULT
WARNING LIGHT
Normal operation :
• The warning light is not illuminated during
normal operation whether the vehicle is being
started, engine running or when the vehicle is
stationary.
Presence of a fault :
• Vehicle stopped, engine running, or when
driving, warning light permanently illuminated
• Vehicle moving, warning light illuminates and
extinguishes without action at the ignition key.
• Vehicle moving, warning light illuminates
briefly.Oil temperature < - 20 °C or > + 140 °C
• Vehicle moving or stationary, warning light
flashes at a rate of approximately 1 flash per
second, in this case, reduce the performance
requirement by moderating acceleration.
23-6

77 11 192 972FF F F
EE E E
BB B B
RR R R
UU U U
AA A A
RR R R
YY Y Y

11 1 1
99 9 9
99 9 9
77 7 7Edition Anglaise
Panels
"The repair methods given by the manufacturer in this document are based on the
technical specifications current when it was prepared.
The methods may be modified as a result of changes by the manufacturer in the
production of the various component units and accessories from which his vehicles
are constructed".All copyrights reserved by Renault.
Copying or translating, in part or in full, of this document or use of the service part
reference numbering system is forbidden without the prior written authority of
Renault.
CRenault 1997
GENERAL
LOWER STRUCTURE
UPPER REAR STRUCTURE
UPPER SIDE STRUCTURE
OPENINGS OTHER THAN SIDE DOORS