1995 RENAULT MEGANE SCENIC dimensions

GENERAL INFORMATION
Sub-frame dimensions
40
40-17

UPPER SIDE STRUCTURE
Body side front section
43S
143UPPER SIDE STRUCTURE
Body side front section
INTRODUCTION
The replacement of this part is a basic operation
following a front side collision.
The method for replacing this part has not changed,
see basic Workshop Repair Manual.
For standardisation purposes, the front section of the
body side is delivered by the Parts Department without
the welded pins on the bottom section for mounting the
plastic fittings panels and without the drillings for
mounting the longitudinal flaps.
It will be necessary to fit the riveted pins (pin rivets)
and to make the drillings after the part has been
replaced.
The number of rivets required will depend on the
location of the cut on the sill panel.
The dimensions of the drillings to be carried out are
listed below.
43-1
F

UPPER SIDE STRUCTURE
Complete sill panel
43SComplete sill panel
INTRODUCTION
The replacement of this part is a basic operation
following a side collision.
For the method for replacing this part, see the basic
Workshop Repair Manual.
The sill panel is delivered by the Parts Department
with the welded pins for mounting the plastic fittings
panels.
The dimensions of the holes drilled are given for your
information in sections 43-F and 44-A.
COMPOSITION OF THE PART FROM THE PARTS
DEPARTMENT
Part assembled with:
– Front pillar hinge reinforcement,
– Centre pillar hinge reinforcement,
– Welded studs,
– welded pins.
PRF4302
43-4
H

UPPER REAR STRUCTURE
Rear wing panel
44S
144UPPER REAR STRUCTURE
Rear wing panel
INTRODUCTION
The replacement of this part is a basic operation for a
rear side impact.
For the method for replacing this part, see the basic
Workshop Repair Manual.
The rear wing panel is delivered by the Parts
Department with the welded pins for mounting the
plastic fittings panels.
The dimensions of the holes drilled and and the
welded pins are given below for your information.
COMPOSITION OF THE PART FROM THE PARTS
DEPARTMENT
Part assembled with:
– bumper side mounting reinforcement,
– striker plate stiffener, rear door,
– plate cage,
– plate,
– sound-deadening material,
– fuel pipe unit (right side).
– welded nuts,
– lower blanking cover,
– welded pins.
PRF4418
44-1
A