DRIVESHAFTS
Bearing gaiter
29
REFITTING
To be in the correct position on the shaft, the bea-
ring must be fitted so as to obtain a dimension L
between the front part of the bearing and the
end of the shaft.
L = 118 ± 0.2 mm (JB1 gearbox)
L = 123.2 ± 0.2 mm (JB3 gearbox)
This dimension is obtained using tool T.Av. 944
when its end is level with the shaft.
86197S
GI 69 seal
85884-1R1
To avoid damaging the bearing which contains a
lip seal, therefore to avoid the risk of leaks, do
not fit the bearing using a hammer but instead
use a press which provides progressive pressure.
29-25
