Page 223 of 386
The jack has a bolt at the end. Attach the wheel wrench
to the jack bolt.
If your wheel has a bolt-on center cap, loosen the plastic
caps using the wheel wrench.
Turn the wheel wrench to the right to raise the lift head a
little.
ProCarManuals.com
Page 224 of 386
Then pry off the center cap with the wheel wrench. If your vehicle has optional alloy wheels, each wheel
may have one locknut in place
of the standard wheel
nut.
A special wheel lock key (removal tool) and
instructions are located in the center console. Attach the
wheel lock key to the socket
of the wheel wrench.
Remove the locking wheel nut by turning
counterclockwise.
ProCarManuals.com
Page 225 of 386
Using the wheel wrench, loosen all the wheel nuts.
Don’t remove them yet.
, .i.. ,.
fl
Position the jack under the vehicle. There is a notch in
the vehicle’s rocker flange on the coupe model. Raise
the jack head until
it fits fiiy into the notch nearest the
flat tire.
ProCarManuals.com
Page 227 of 386
Raise the vehicle by rotating the wheel wrench
clockwise. Raise the vehicle far enough
off the ground
so there is enough room for the spare tire to fit.
Remove all the wheel nuts and take off the flat tire.
Remove any rust or dirt from the wheel bolts, mounting
surfaces and spare wheel. Place the spare on the wheel
mounting surface.
ProCarManuals.com
Page 228 of 386
Replace the wheel nuts with the rounded end of the nuts
toward the wheel. Tighten each nut by hand until the
wheel
is held against the hub.
Lower the vehicle by rotating the wheel wrench
counterclockwise. Lower
the jack completely..
5-39
ProCarManuals.com
Page 229 of 386
Tighten the wheel nuts
firmly in a criss-cross
sequence as shown. Don’t try to put a center cap on your compact spare tire.
It won’t fit. Store the center cap in the rear area until
you have the flat tire repaired or replaced.
NOTICE:
Center caps won’t fit on your compact spare.
If you try to put a center cap on your compact
spare, you could damage the cover or the spare.
5-40
ProCarManuals.com
Page 230 of 386
Replace the jack, wheel wrench and flat tire using the storage instructions. When you replace the
trim panel,
be sure to tuck it under the weatherstrip.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Trim Panel
Bolt
Cover
Jack
Wing Nut
Adapter
Compact Spare Tire
Full-Size Tire
Carpet Flap
Tire Storage Bolt
Trunk Access Pane
Knob
:1 (Convertible Only)
6
5-41
ProCarManuals.com
Page 231 of 386

Compact Spare Tire
Although the compact spare was fully inflated when
your vehicle was new, it can lose air after a time. Check
the inflation pressure regularly. It should be 60 psi
(420 kPa). After installing the compact spare on your
vehicle, you should stop as soon
as possible and make
sure your spare tire is correctly inflated.
The compact
spare is made to perform well at posted speed limits for
distances up to
3,000 miles (5 000 km), so you can
finish
your trip and have your full-size tire repaired or
replaced where you want. Of course, it’s best to replace
your spare with a full-size tire as soon as you can. Your
spare
will last longer and be in good shape in case you
need it again.
I
I NOTICE:
Don’t take your compact spare through an
automatic car wash with guide rails. The
compact spare can get caught on the rails. That
can damage the tire and wheel, and maybe other
parts
of your vehicle.
NOTICE:
If the compact spare is used as a rear tire, do not
1 drive faster than 50 mph (80 km/h). Damage to
the rear axle may occur if the compact spare
is
driven faster than 50 mph. This speed limitation
does not apply when the compact spare is used as
a front tire.
Don’t use your compact spare on some other vehicle.
And don’t mix your compact spare or wheel with other
wheels or tires. They
won’t fit. Keep your spare and its
wheel together.
5-42
ProCarManuals.com