1995 Oldsmobile Achieva radio

Vehicle Symbols
These are some of the symbols you may find on your vehicle.
For example,
these symbols
are used on an
original battery:
POSSIBLE A
CAUTION
INJURY
PROTECT EYES BY
SHIELDING
CAUSTIC
ACID COULD BATTERY
CAUSE
BURNS
AVOID
SPARKS
OR
FLAMES
SPARK
OR ,\I/,
COULD FLAME
EXPLODE BATTERY
These symbols
are important
for you and
your passengers
whenever your
vehicle
is
driven:
DOOR LOCK
UNLOCK
FASTEN SEAT
BELTS
POWER
WINDOW
These symbols
have to do with
your lights:
SIGNALS e e
TURN
FOG LAMPS
$0
These symbols
are on some of
your controls:
WINDSHIELD
WIPER
WINDSHIELD DEFROSTER
WINDOW
DEFOGGER
VENTILATING FAN
These symbols are used on
warning and
indicator lights:
COOLANT F-
TEMP --
ENGINE
CHARGING
I-1
BATTERY SYSTEM
BRAKE
(a)
FUEL
ENGINE OIL
PRESSURE
Wd
TEMP OIL 9b
ANTI-LOCK (@)
BRAKE
Here are some
other symbols
you may see:
FUSE -%-
RELEASE
RADIO
VOLUME
CONDITIONING
A'R 43
RELEASE TRUNK e
LIGHTER n
HORN )tr
SPEAKER
b
V

The rear doors of your vehicle cannot be opened from
inside when this feature
is in use. If you want to open a
rear door when the security lock is on:
1. Unlock the door from the inside.
2. Then open the door from the outside.
If you don’t cancel the security lock feature, adults or
older children who ride in the rear won’t be able to open
the rear door from the inside. You should let adults and
older children know how these security locks work, and
how to cancel the locks.
To Cancel the Rear Door Lock:
1. Unlock the door from the inside and open the door
from the outside.
2. Use a key to move the lock all the way down.
3. Do the same for the other rear door.
The rear door locks will now work normally.
Remote Lock Control (Option)
If your Oldsmobile has this option, you can lock and
unlock your doors or unlock your trunk from
up to
30 feet (9 m) away using the key chain transmitter
supplied with your vehicle.
Your Remote Lock Control operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules.
2-6

Ignition Switch
A E
With the key in the ignition switch, you can turn the
switch to five positions:
ACCESSORY (A): This is an “on” position in which
you can operate some
of your electrical power
accessories. Press in the ignition switch as you
turn the
top
of it toward you.
LOCK (B): This is the only position in which you can
remove the key. This locks your steering wheel, ignition
and transaxle (on automatic models).
OFF (C): This position unlocks the steering wheel,
ignition, and transaxle (on automatic models), but does
not send electrical power to any accessories. Use this
position
if your vehicle must be pushed or towed, but
never try to push-start your vehicle.
A warning chime
will sound if
you open the driver’s door when the
ignition is
off and the key is in the ignition.
RUN (D): This is an “on” position to which the switch
returns after you start your engine and release the
switch. The switch stays
in the RUN position when the
engine is running. But even when the engine
is not
running, you can use
RUN to operate your electrical
power accessories, and to display some instrument panel
warning lights.
START (E): Use this for starting the engine. When the
engine starts, release the key.
The ignition switch will
return to
RUN for normal driving.
Note that even
if the engine is not running, the positions
ACCESSORY and RUN are “on” positions that allow you
to operate your electrical accessories, such as the radio.
2-13

Air Bag Readiness Light
There is an air bag readiness light on the instrument
panel, which shows AIR BAG. The system checks the
air bag’s electrical system for malfunctions. The light
tells
you if there is an electrical problem. The system
check includes the air bag sensors and module, the
wiring and the diagnostic module. For more information
on the air bag system, see “Air Bag” in the Index.
AIR
BAG
You will see this light
flash for a few
seconds when you
turn your ignition to
RUN or START.
Then the light should
go out. This means
the system is ready.
If the air bag readiness light doesn’t come on when you
start your vehicle, or stays on, or comes on when you
are driving, your air bag system may not work properly.
Have your vehicle serviced right away.
Charging System Light
WASH
I FLUID
The CHARGE light
will come on when
you turn on the
ignition, but the
engine is not running,
as a check to show
you it is working.
Then it should go out. If it stays on, or
co !s on while
you are driving, you may have a problem with the
electrical charging system. It could indicate that you
have a loose generator drive belt or another electrical
problem. Have it checked right away. Driving while this
light
is on could drain your battery.
If you must drive
a short distance with the light on, be
certain to turn off all your accessories, such
as the radio
and air conditioner.
2-60

Audio Systems
The following pages describe the audio systems
available for your Oldsmobile and how to get the best
performance from them. Please read about the system in
your vehicle.
Setting the Clock
No matter which audio system you have in your vehicle,
setting
the clock is easy.
1. With the ignition on and radio either on or off, press
SET. The SET indicator will appear on the digital
display for five seconds.
2. You must begin to set the clock to the correct hour
and minute during those five seconds.
If your audio system does not have
a compact disc
player:
Press
SCAN to set the hour.
Press SEEK to set the minute. If
your system has
a compact disc player:
Press
SCAN to set the hour.
Press the left SEEK arrow to decrease minutes or the
right
SEEK arrow to increase minutes.
If your vehicle is left with the ignition turned off for
over
24 days, battery power to your clock, audio system
and Remote Lock Control
(if you have this option) will
be turned
off to reduce battery drain. When the ignition
is turned on again, battery power will be resupplied.
However, under these conditions, it will be necessary
to
reset the clock and audio system settings. The
Delco-LOC
II@ feature on vehicles equipped with the
optional
CD player will also be activated and will need
to be reset.

AM/FM Stereo Radio
L Q []I
I II VOLUME TREE r 1 I II TUNE
I II
-
I "
The digital display indicates information on time or
radio station frequency, the
AM or FM radio band,
whether the station is in stereo, and other radio
functions.
Playing the Radio
VOLUME: With the ignition on, turn the upper knob
clockwise to turn on the radio and increase volume.
Press it to change between the clock and the radio
station frequency display when the radio is on.
Finding a Station
AM/FM: Press the lower hob to change between the
AM and FM bands (the digital display will display AM
or FM, and if the station is in stereo, STEREO will be
displayed).
TUNE: Turn the lower knob clockwise or
counterclockwise to tune in radio stations (the radio
station frequency will be displayed on
the digital
display).
SCAN: Press this button to listen to stations for a few
seconds. Press it again to stop scanning.
SEEK: Each time you press SEEK, you will tune in the
next station on the
AM or FM radio band.
3-6

Presets: The four numbered pushbuttons can be used to
preset up to 14 radio stations (seven AM and seven
FM).
1. Tune in the desired station.
2. Press SET, The word SET will appear on the digital
display
for five seconds.
3. While SET is displayed, press one of the four
pushbuttons. Whenever
you press this button again,
the preset station will be tuned
in.
4. Repeat steps 1-3 for each of four AM and four FM
stations.
Up to three additional stations
on each band may be
preset by “pairing” pushbuttons:
1. Tune in the desired station.
2. Press SET, and within five seconds press any two
adjacent pushbuttons at the same time. Whenever
you press these two buttons again, the preset station
will be tuned in,
Setting the Tone
TREB:
Slide this lever up to increase treble or down to
decrease it. If a station is weak or noisy, reduce the
treble.
BASS: Slide this lever up to increase bass or down to
decrease
it.
Adjusting the Speakers
R/L BALANCE: The control ring behind the
VOLUME knob adjusts the lefthight speaker balance.
F/R FADE: The control ring behind the TUNE knob
adjusts the frondrear speaker balance.
3-7
. ~~ . -

AM/FM Stereo Radio with Cassette Tape
Player (Option)
VOLUME TUNE
R
TREB
BASS
SCAN SEEK 3 4 SET
imd AUTO
The digital display indicates information on time or
radio station frequency, the
AM or FM radio band,
whether the station is
in stereo, and other radio
functions.
Playing the Radio
VOLUME: With the ignition on, turn the upper knob
clockwise to
turn on your audio system and increase
volume. Press it to change between the clock and the
radio station frequency display when the radio is on, or
to change sides of a tape when a cassette is playing.
Finding a Station
AM/FM: Press the lower knob to change between the
AM and FM bands (the digital display will display AM
or FM, and if the station is in stereo, STEREO will be
displayed).
TUNE: Turn the lower knob clockwise or
counterclockwise to tune in radio stations (the radio
station frequency will be displayed on the digital
display).
SCAN: Press this button to listen to stations for a few
seconds. Press it again to stop scanning.
SEEK: Each time you press SEEK, you will tune in the
next station on the
AM or FM radio band.
3-8